Tài liệu Lab 9 1 2 Gateway of Last Resort ppt

Tài liệu Lab 9.1.2 Gateway of Last Resort ppt

... 1 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9. 1. 2 Copyright  20 03, Cisco Systems, Inc. Lab 9. 1. 2 Gateway of Last Resort Objective • Configure RIP ... the privileged exec mode. 3 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9. 1. 2 Copyright  20 03, Cisco Systems, Inc. c. What is the Gateway of last resort listed? ________________________________________ ... ________________________________________________ Upon completion of the previous steps, log off by typing exit and turn the router off. 4 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9. 1. 2 Copyright  20 03, Cisco Systems, Inc....

Tài liệu Lab 9.1.2 Gateway of Last Resort (Default Gateway) pdf

... Router 1 GAD 17 2 .16 .0 .1 DCE 17 2 .17 .0 .1 25 5 .25 5.0.0 class cisco Router 2 BHM 17 2 .18 .0 .1 DTE 17 2 .17 .0 .2 255 .25 5.0.0 class cisco Objective • Configure RIP routing and add default routes (gateways) ... Lab 9. 1. 2 Gateway of Last Resort (Default Gateway) Router Designation Router Name FastEthernet 0 Address ... ________________________________________________ Upon completion of the previous steps, log,off by typing exit and turn the router off. 3 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9. 1. 2 Copyright  20 03, Cisco Systems, Inc....

Tài liệu Lab 9.1.5b Trunking with 802.1q pptx

... 0 / 12 to the switch IP 19 2 .16 8 .1. 2. c. Was the ping successful? ___________________________________________________ 4 - 8 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 9. 1. 5b ... with an unconfigured switch. Instructions are provided for the 29 0 0, 29 5 0, and 19 0 0 Series switches. 29 0 0 and 29 5 0 Series Switches 1. Enter into the privileged EXEC mode by typing enable. If ... 1 - 8 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 9. 1. 5b Copyright  20 03, Cisco Systems, Inc. Lab 9. 1. 5b Trunking with 8 02. 1q Objective • Create...

Tài liệu Lab 9.1.5b Trunking with 802.1q ppt

... __________________________________________________________________ Ping from the host in Switch_A port 0 / 12 to the switch IP 19 2 .16 8 .1. 2. a. Was the ping successful? ___________________________________________________ ... __________________________________________________________________ Ping from the host in Switch_A port 0 / 12 to the switch IP 19 2 .16 8 .1. 2. a. Was the ping successful? ___________________________________________________ ... switch IP 19 2 .16 8 .1. 2. a. Was the ping successful? ___________________________________________________ b. Why? __________________________________________________________________ Step 19 Move...

6

344

0

Tài liệu Lab 3.1.2 Command Modes and Router Identification docx

... 1 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3 .1. 2 Copyright  20 03, Cisco Systems, Inc. Lab 3 .1. 2 Command Modes and Router Identification ... close out of the router. GAD(config)#exit Upon completion of the previous steps, logoff by typing exit. Turn the router off. 4 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3 .1. 2 Copyright ... 800, 16 00, 17 00, 25 00, 26 00 routers, or a combination. Refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. ...

5

411

0

Tài liệu Lab 3.1.2 Voltage Measurement pdf

... 1 - 3 CCNA 1: Networking Basics v 3.0 - Lab 3 .1. 2 Copyright  20 03, Cisco Systems, Inc. Lab 3 .1. 2 Voltage Measurement Objective • Demonstrate ... will be required: • Fluke 11 0, 12 B, or equivalent multimeter • An assortment of batteries: A cell, C cell, D cell, 9 Volts, 6 V lantern • Duplex wall outlet, typically 12 0v • Power supply for ... electrical appliance that is plugged in. Examples of appliances are a computer, 2 - 3 CCNA 1: Networking Basics v 3.0 - Lab 3 .1. 2 Copyright  20 03, Cisco Systems, Inc. toaster, or television....

3

396

0

Tài liệu Lab 3.1.2 Command Modes and Router Identification doc

... 1 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3 .1. 2 Copyright  20 03, Cisco Systems, Inc. Lab 3 .1. 2 Command Modes and Router Identification ... 800, 16 00, 17 00, 25 00 and 26 00 routers, or a combination. Refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. ... 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3 .1. 2 Copyright  20 03, Cisco Systems, Inc. a. Enter exit at the prompt to close out of the router. GAD(config)#exit Upon completion of the...

5

332

0

Tài liệu Lab 9.1.1 Using Show IP Route to Examine Routing Tables doc

... BHM(config)#interface Serial1 BHM(config-if)#ip address 17 2. 22. 0 .2 255 .25 5.0.0 BHM(config)#no shutdown d. On the BHM router remove the IGRP network statement network 17 2 .18 .0.0 so the router IGRP 25 should ... 1 - 6 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9. 1. 1 Copyright  20 03, Cisco Systems, Inc. Lab 9. 1. 1 Using Show IP Route to Examine Routing ... interface S1 on GAD to serial S1 on BHM. GAD is the DCE. b. Configure the GAD router with the additional statements. GAD(config)#interface Serial1 GAD(config-if)#ip address 17 2. 22. 0 .1 25 5 .25 5.0.0...

6

424

0

Tài liệu Lab 9.1.1 Using Show IP Route to Examine Routing Tables ppt

... password Enable/VTY/Console passwords Router 1 GAD 17 2 .16 .0 .1 DCE 17 2 .17 .0 .1 25 5 .25 5.0.0 class cisco Router 2 BHM 17 2 .18 .0 .1 DTE 17 2 .17 .0 .2 255 .25 5.0.0 class cisco Objective • Setup IP an ... BHM(config)#interface Serial1 BHM(config-if)#ip address 17 2. 22. 0 .1 25 5 .25 5.0.0 BHM(config)#no shutdown d. On the BHM router remove the IGRP network statement network 17 2 .18 .0.0 so the router IGRP 25 should ... interface S1 on GAD to serial S1 on BHM. GAD is the DCE. b. Configure the GAD router with the additional statements. GAD(config)#interface Serial1 GAD(config-if)#ip address 17 2. 22. 0 .1 25 5 .25 5.0.0...

6

362

0

Tài liệu Lab 9.1.5a Trunking with ISL ppt

... Ping from the host in Switch_A port 0 / 12 to the switch IP 19 2 .16 8 .1. 2. 4 - 8 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 9. 1. 5a Copyright  20 03, Cisco Systems, Inc. c. Was the ... with an unconfigured switch. Instructions are provided for the 29 0 0, 29 5 0, and 19 0 0 Series switches. 29 0 0 and 29 5 0 Series Switches 1. Enter into the privileged EXEC mode by typing enable. If ... switch IP 19 2 .16 8 .1. 3. e. Was the ping successful? ___________________________________________________ 6 - 8 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 9. 1. 5a Copyright  20 03,...

8

353

0