0

rf microwave circuit design for wireless application

RF / Microwave Circuit Design for Wireless Application potx

RF / Microwave Circuit Design for Wireless Application potx

Kỹ thuật lập trình

... THE RADIO CHANNEL AND MODULATION REQUIREMENTS 23 RF/ MICROWAVE CIRCUIT DESIGN FOR WIRELESS APPLICATIONS RF/ Microwave Circuit Design for Wireless Applications. Ulrich L. Rohde, David P. NewkirkCopyright ... advances.In this book, RF/ Microwave Circuit Design for Wireless Applications, Dr. Rohde helpsclarify RF theory and its reduction to practical applications in developing RF circuits. Thebook provides ... members. We have thereforedecided to give some guidelines for the designer applications of ICs, focusing mainly onhigh-performance applications. In the case of high-performance applications, low...
  • 972
  • 552
  • 1
Tài liệu Rf Mems Circuit Design For Wireless Communications pptx

Tài liệu Rf Mems Circuit Design For Wireless Communications pptx

Hóa học - Dầu khí

... 424 4133p(2.29)28 RF MEMS Circuit Design for Wireless Communications2Elements of RF Circuit Design 2.1 IntroductionThe design of RF MEMS circuits for wireless applications is predicated ... both RF MEMS and traditional RF and microwave circuit design. Chapter 1 of RF MEMS Circuit Design for Wireless Communicationsstarts by clearly stating the ubiquitous wireless communications problem, ... groundfixed/mobile platform, and (3) the space platform.4 RF MEMS Circuit Design for Wireless CommunicationsInformationVoiceBroadband dataMessagingNavigationDBSInternetVideoWireless...
  • 280
  • 545
  • 0
Fundamentals of RF Circuit Design With Low Noise Oscillators

Fundamentals of RF Circuit Design With Low Noise Oscillators

Điện - Điện tử

... equations for one port error correction.8 Fundamentals of RF Circuit Design Figure 1.6. Typical model for the SOT143 package. Obtained from the SPICE model for aBFG505. Data in Philips RF Wideband ... significantinformation but ignore other aspects. It is actually rather difficult to find singlefigures of merit which accurately quantify performance and therefore many areused in RF and microwave design ... impedance is therefore:12 Fundamentals of RF Circuit Design ()efeTferhfhC12+=πTmeTfg rf ππ221=≈(1.25)Many of the parameters of a modern device can therefore be deduced just...
  • 308
  • 698
  • 6
Báo cáo

Báo cáo "Design dual band microstrip antenna for RFID application" potx

Báo cáo khoa học

... line for RFID transponder antennas. [2] Leena Ukkonen, Lauri Sydänheimo, Markku Kivikoski, Effects of metallic plate size on the performmance of microstrip patch-type tag antennas for passive ... đa băng RFID sẽ được đưa ra thảo luận trong bài báo này. VNU Journal of Science, Natural Sciences and Technology 26 (2010) 276-280 276 Design dual band microstrip antenna for RFID application ... Park, NaeSoo Kim, Jaehoon Choi, Dual-band Dipole antenna for ISO 18000-9/ISO 18000-4 passive RFID tag application. [5] David M Pozar, Microwave Engineering, John Willey & Son, INC, Second...
  • 5
  • 302
  • 0
reverse osmosis design, processes, and applications for engineers

reverse osmosis design, processes, and applications for engineers

Hóa học - Dầu khí

... California in 1965. The membranes were developed and prepared at UCLA (see Chapter 1). The break for commercial viability came when as an appropriate swelling agent, formamide, was found for ... accurately models the performance of the perfect RO mem- brane. 4.1.3 Finely-Porous Model (porous model) The finely-porous model is based on a balance of applied and frictional forces in a 1-dimentional ... brane. In an effort to keep the membrane surface free of solids that may accumulate and foul or scale the membrane, tangential flow across the membrane surface aids in keeping the surface clean...
  • 416
  • 4,525
  • 0
bowick, c. (1997). rf circuit design

bowick, c. (1997). rf circuit design

Điện - Điện tử

... in the theory behind the rf circuitry being designed, you can use the more detailed information that is provided for in-depth study. An expert in the rf circuit design field will find this ... are an individual who has little rf circuit design experience, you can use this book as a catalog of circuits, using component values designed for your application. On the other hand, if ... frequency response vs. loaded Q for three-element low-pass filters. RF Circuit Design is written for those who desire a practical approach to the design of rf amplifiers, impedance matching...
  • 178
  • 481
  • 1
Visual Design for Web Sites  and Web Applications

Visual Design for Web Sites and Web Applications

Thiết kế - Đồ họa - Flash

... Systemsdesignerskhoi vinhjerey zeldman jason santa mariacameron molldan cedarholmLucida is the default of the Facebook phenomenon.Use Lucida Grande for Mac, and Lucida Sans Unicode for ... illustratoromnigrale indesignacrobatelements of the designer’s craftresources - know your materialsinspirationtools techniquesdirty, dirty tricksAniversDesigned by: Jos Buivenga (2008)the ... typographyDesigned by: Mahew Carter (1996) PC: 98.34% Mac 95.45%Humanist sans-serif with large x-height for good legibility.what was old is new againSince the 1930s, graphic designers have...
  • 78
  • 323
  • 0
code design for dependable systems theory and practical applications

code design for dependable systems theory and practical applications

Đại cương

... addition.(V2) cv 2 V for all v 2 V and for all scalar c 2 F.(V3) cðu þ vÞ¼cu þ cv for all u, v 2 V and for all scalar c 2 F.(V4) ða þ bÞv ¼ av þ bv for all v 2 V and for all scalars a, b 2 ... design methodologies, and concrete checker design for logic circuits and for computer systems.Watchdog Timer and Watchdog Processor A watchdog timer is very useful for detecting faults in a system. The ... the valuable information part of a wordagainst errors. For example, control information or address information in communicationmessages or computer words, or similarly pointer information in...
  • 718
  • 442
  • 0
Báo cáo hóa học:

Báo cáo hóa học: "IDEA1: A validated SystemC-based system-level design and simulation environment for wireless sensor networks" pot

Hóa học - Dầu khí

... can be sent for the next trans-mission; thus, the latency is short.4.2 Performance evaluationIn this section, the same application of Section 4.1 isstudiedbyNS-2andIDEA1.TheperformancesofIDEA1 ... implemented. It has beenwidely utilized in WSN applications since it is designed for low data rate, short distance and low-power-con-sumption applications in conformity with the constraintsof WSN systems ... nodes.- The performances of IDEA1 have also been com-pared with NS-2.3 Design and architecture of IDEA1In this section, the design and architecture of IDEA1 arepresented, including the design framework,...
  • 20
  • 408
  • 0
báo cáo hóa học:

báo cáo hóa học: " Cross-layer design for radio resource allocation based on priority scheduling in OFDMA wireless access network" docx

Hóa học - Dầu khí

... andscenario 2, which generates much heavier traffic loadthan that of scenario 1, was performed to measure theperformance of resource utilization.During the simulations, the jakes model was adoptedto ... performance conclusions. Furthermore, it wasshown that the MAP messages occupy up to 20-60% ofdownlink resources [12]. Therefore, the mapping of traf-fic into bursts is a crucial issue for ... article as: Chen et al.: Cross-layer design for radio resourceallocation based on priority scheduling in OFDMA wireless accessnetwork. EURASIP Journal on Wireless Communications and Networking2011...
  • 10
  • 405
  • 0
Báo cáo hóa học:

Báo cáo hóa học: " Research Article Design and Analysis of an Energy-Saving Distributed MAC Mechanism for Wireless Body Sensor Networks" doc

Hóa học - Dầu khí

... especially designed for biosensors in BSNs. Itimproves energy efficiency by exploiting human heartbeatrhythm information to perform time synchronization for TDMA. By following the heartbeat rhythm, wireless ... in43.31% for a payload length packet of 50 bytes;(iii) BSN-MAC outperforms IEEE 802.15.4 MAC in7.20% for payload length packet of 80 bytes;(iv) DQ-MAC outperforms IEEE 802.15.4 MAC in36.65% for ... areshown for a traffic load of 80% (i.e., high-density area).It can be seen that(i) BSN-MAC outperforms IEEE 802.15.4 MAC in19.09% for payload length packet of 50 bytes;(ii) DQ-MAC outp erforms...
  • 13
  • 485
  • 0

Xem thêm