... presents some of the considerations and assumptions of ACI Committee 313 in developing the provisions of the Standard Practice forDesignandConstructionofConcrete Silos and Stacking Tubes for Storing ... finishingR3.7 Concrete protection and curingChapter 4 Design, p. 313R-4R4.1—NotationR4.2—GeneralCommentary on Standard PracticeforDesignandConstruction of Concrete Silos and Stacking Tubes for ... of admixture may be adjusted in the fieldto suit the ambient conditions and so maintain a constant rate of rise for the forms.313R-3COMMENTARY ON DESIGNANDCONSTRUCTIONOFCONCRETE SILOS AND...
... support and lining systems are critical for the tunnel design, considering both ground conditions and the proposed method of construction. Perform the design in Preliminary and Final design ... type of tunnel, the geometrical configuration of the cross section, and method of construction. For example, in cut and cover tunnels of rectangular cross section, cast in place concrete is often ... and Subtitle 5. Report Date December 2009 6. Performing Organization Code TECHNICAL MANUAL FOR DESIGN ANDCONSTRUCTIONOF ROAD TUNNELS – CIVIL ELEMENTS 7. Author(s) 8. Performing...
... use of steelwork in building — Part 5: Codeofpracticefordesignof cold formed thin gauge sections.BS 5950-6, Structural use of steelwork in building — Part 6: Codeofpracticefordesignof ... steel bars for the reinforcement of concrete. BS 4482, Specification for cold reduced steel wire for the reinforcement of concrete. BS 4483, Steel fabric for the reinforcement of concrete. BS ... 2573-1, Rules for the designof cranes — Part 1: Specification for classification, stress calculations and design criteria for structures. BS 2853, Specification for the designand testing of steel...
... practicefor protective coating of iron and steel structures against corrosion1).BS 5502-22, Buildings andstructures for agriculture Ð Codeofpracticefor design, construction and loading.BS ... materials and workmanship: coldformed sections and sheeting.BS 6399-1, Loading for buildings Ð Codeof practice for dead and imposed loads.BS 6399-2, Loading for buildings Ð Codeof practice for ... properties of fasteners ÐBolts, screws and studs.CP3 Codeof basic data for the designof buildings:Chapter V: Part 2: Wind loads.1.4 Terms and definitions For the purposes of this part of BS...
... values for construction operatives, impact and heaping of concrete during placing, hand tools, small items of equipment and materials for immediate use. The minimum values quoted are intended for ... 3.4 and 3.5 of BS 8110-1:1985 or Tables 5.1 and 5.2 of BS 8110-2:1985.Figure 4 — Typical profiles BRITISH STANDARDBS 5950-4:1994Structural use of steelwork in building —Part 4: Codeofpractice ... loads for its intended life. The design should facilitate construction, both of theslab itself andof the structure of which it forms part.The composite slab should be sufficiently robust andinsensitive...
... Rt,0.5 and Rmshould normally be taken as specified in the relevant product standard for the steel sheet or strip and used for the formed sections. For information, the resulting values of Ys and ... Properties of materials and section properties3.1 Range of thicknessesThe provisions of this Part of BS 5950 apply primarily to profiled steel sheet with a net thickness of steel basemetal of not ... stateDpOverall depth of the profileDwSloping distance between the intersection points of a web and flanges (see figure 4)d Diameter of a fastenerdpDiameter of a perforationdwDiameter of a washerE...
... recommendations for the use of their multiples andof certain other unitsBS 6399 : Loading for buildingsBS 6399 : Part 2 : 1995 Codeofpracticefor wind loadsBS 6399 : Part 3 : 1988 Codeofpracticefor ... Part 1 : 1996 Code of practice 1 Scope1.1 This Part of BS 6399 gives dead and minimumrecommended imposed loads for use in designingbuildings. It applies to:a) new buildings and new structures; b) ... loads for parapets, barriers and balustrades, etc.Type of occupancy for part of the building orstructureExamples of specific use Horizontaluniformlydistributed lineload(kN/m)A uniformlydistributed...
... minutes of fire exposure. This may require fireproofing of the control DESIGNANDCONSTRUCTIONOF LPG INSTALLATIONS 3 4 Design of LPG Vessels 4.1 APPLICABLE DESIGNCONSTRUCTION CODES ... methods, and details of design and construction of foundations and supports for LPG storage vessels and related piping shall meet the requirements stipu-lated in the following codes and specifications: ... supporting structuresand foundations. f. Static and dynamic loads during maintenance and operations. 6.2.8 Support Design 6.2.8.1 The design of supports for vessels shall include provisions for...
... communication port for management services with same type needs the information about the codeof VCC, the code of WSN platform and the codeof WSN gateway. The latter two codes are described and defined ... members Prof. Yuni Xia and Prof. Xukai Zou for their time and guidance. In addition, I would like to thank Prof. Arjan Durresi, Prof. Yuni Xia, Prof. Xukai Zou and Prof. Rajeev Raje for their ... socket port is automatically created based on the codeof VCC, the codeof platform and the code of WSN gateway, in another words, these code information should be defined at the beginning by...
... to be taken in places of assembly, for means of escape for disabled people, for ventilation and air conditioning ducts, for enclosed shopping complexes and the revision of CP 3:Chapter IV-1, ... 5588-1.2This code offers a method for keeping protected escape routes clear of smoke by pressurizing these routes and so creating a pattern of airflow away from them. The objects of this code are ... 5588-4:1978(Reprinted, incorporating Amendment No. 1)Fire precautions in the design and construction of buildings —Part 4: Codeofpracticefor smoke control in protected escape routes using pressurizationUDC...
... 5588-1.2, Codeofpracticefor flats and maisonettes4). BS 5588-2, Codeofpracticefor shops3). BS 5588-3, Codeofpracticefor office buildings3). BS 5588-5, Codeofpracticefor firefighting ... and lifts3). BS 5720, Codeofpracticefor mechanical ventilation and air conditioning in buildings. BS 5839, Fire detection and alarm systems in buildings. BS 5839-1, Codeofpracticefor ... 4422, Glossary of terms associated with fire. BS 5588, Fire precautions in the designandconstructionof buildings. BS 5588-1, Residential buildings. BS 5588-1.1, Codeofpracticefor single-family...
... differentials;— Part 6: Codeofpracticefor places of assembly;— Part 7: Codeofpracticefor the incorporation of atria in buildings;— Part 8: Codeofpracticefor means of escape for disabled people;— ... 9: Codeofpracticefor ventilation and air conditioning ductwork;— Part 10: Codeofpracticefor shopping complexes;— Part 11: Codeofpracticefor shops, offices, industrial, storage and ... Part 0: Guide to fire safety codes ofpracticefor particular premises/applications;— Part 1: Codeofpracticefor residential buildings;— Part 4: Codeofpracticefor smoke control using pressure...
... referencesAmerican Concrete Institute307-69 Specification for the DesignandConstruction of Reinforced Concrete Chimneys307-88 Standard Practicefor the Designand Construc-tion of Cast-in-Place Reinforced ... Reinforced Concrete Chimneys318 Building Code Requirements for Structural Concrete 505-54 Standard Specification for the Designand Con-struction of Reinforced Concrete Chimneys550R-93 Design ... Recommendations for Precast Concrete Structures American Society of Civil EngineersASCE 7-88 Minimum Design Loads for Buildings and Other Structures (formerly ANSI A58.1)ASCE 7-95 Minimum Design Loads for...
... Requirements for Re-inforced Concrete ASCE 7-95 Minimum Design Loads for Buildings and Other Structures ASTM A 615-95c Standard Specification for Deformed and Plain Billet Steel Bars forConcrete ... including the design strength of the concrete, the thickness of the concrete chimney shell, thesize and position of reinforcing steel, details and dimen-sions of the chimney lining, and information ... gives material, construction, anddesign requirements for cast-in-place and precast reinforced concrete chimneys. It sets forth mini-mum loadings fordesignand contains methods for determining...