Code of practice for project management for construction and development

Part 1. Code of practice for dead and imposed loads doc

... units Loading for buildings Code of practice for wind loads Code of practice for imposed roof loads Other references [1] T Ji and B R Ellis Floor vibration induced by dance type loads Ð Theory ... Inside front cover Foreword ii Code of practice Scope References Definitions Dead loads Imposed floor and ceiling loads Reduction in total imposed floor loads Imposed roof loads Crane gantry ... NOTE Reductions for intermediate areas may be calculated by linear interpolation Imposed roof loads For imposed roof loads refer to Part of this standard Crane gantry girders For loads due to cranes,...

Tài liệu Information technology — Security techniques — Code of practice for information security management pdf

... edition 2005-06-15 Information technology — Security techniques — Code of practice for information security management Technologies de l 'information — Techniques de sécurité — Code de pratique ... eShop.bsi-global.com BS ISO/IEC 17799:2005 BS ISO/IEC 17799:2005 Information technology — Security techniques — Code of practice for information security management Licensed to: Alexis Dobrolski, 06/09/2006 ... of the implementation of the information security policy; d) provide clear direction and visible management support for security initiatives; e) provide the resources needed for information security; ...

130
1,048
0

Information technology — Security techniques — Code of practice for information security management pot

CODE OF PRACTICE FOR BUILDING ENERGY AUDIT ppt

... Energy Audit Energy Audit Requirements Energy Audit Report 9 Energy Audit Form 11 EAC_2012 -i- EMSD Code of Practice for Building Energy Audit Introduction 1.1 This Code of Practice titled Code ... Code of Practice for Building Energy Audit Objectives of Energy Audit 5.1 An energy audit involves the systematic review of the energy consuming equipment/systems in a building to identify energy ... EAC_2012 of 11 EMSD Code of Practice for Building Energy Audit – Collection of Building Information 7.2 Information on building operation characteristics and technical characteristics of various energy...

Environmental Code of Practice for Poultry Farms in Western Australia pptx

... 26 vi ENVIRONMENTAL CODE OF PRACTICE FOR POULTRY FARMS IN WESTERN AUSTRALIA PART INTRODUCTION ENVIRONMENTAL CODE OF PRACTICE FOR POULTRY FARMS IN WESTERN AUSTRALIA Modern poultry farms are intensive ... 39 ENVIRONMENTAL CODE OF PRACTICE FOR POULTRY FARMS IN WESTERN AUSTRALIA 40 ENVIRONMENTAL CODE OF PRACTICE FOR POULTRY FARMS IN WESTERN AUSTRALIA PART FREE TO RANGE POULTRY FARMSSUPPLEMENTARY ... ENVIRONMENTAL CODE OF PRACTICE FOR POULTRY FARMS IN WESTERN AUSTRALIA Environmental Code of Practice for Poultry Farms in Western Australia May 2004 Prepared by: Western Australian...

Code of Practice for Revenue Audit pdf

... controls CODE OF PRACTICE FOR REVENUE AUDIT Page INTRODUCTION1 OVERVIEW OF REVENUE AUDIT 1.1 OBJECTIVE OF THE REVENUE AUDIT 1.2 DEFINITION OF REVENUE AUDIT 1.3 RANDOM AUDIT PROGRAMME 1.4E-AUDITING ... Chapter Overview of Revenue Audit • Definition and objectives of a Revenue Audit • Overview of a Revenue Investigation • Notification of a Revenue Audit/ Investigation OVERVIEW OF REVENUE AUDIT 1.1 ... of Revenue that there is no loss of revenue Where this onus of proof is not met, the ‘no loss of revenue arrangements will not apply ‘No Loss of Revenue claims will not be accepted in any of...

Recommended code of practice for the care and handling of poultry from hatchery to processing plant ppt

... of Practice for Handling Chickens from Hatchery to Slaughterhouse (1983); Recommended Code of Practice for Care and Handling of Pigs (1984); Recommended Code of Practice for the Care and Handling ... Handling of Special Fed Veal Calves (1988); Recommended Code of Practice for the Care and Handling of Mink (1988); Recommended Code of Practice for the Care and Handling of Ranched Fox (1989) This code ... coordinating the process of drafting codes of practice for all livestock species with the drafting of a code of practice for handling chickens and the agreement of the federal Minister of Agriculture to...

Part 5. Code of practice for design of cold formed thin gauge sections pdf

... 3.1 Code of practice for design of simple and continuous composite beams Part 4, Code of practice for design of composite slabs with profiled steel sheeting Part 5, Code of practice for design of ... design of cold formed thin gauge sections Part 6, Code of practice for design of light gauge profiled steel sheeting Part 7, Specification for materials and workmanship: cold formed sections and ... parts: Part 1, Code of practice for design in simple and continuous construction: hot rolled sections Part 2, Specification for materials, fabrication and erection: hot rolled sections Part 3, Design...

74
1,670
9

Part 1: Code of practice for design — Rolled and welded sections pptx

... workmanship and erection It comprises the following parts: Part 1: Code of practice for design Rolled and welded sections; Part 2: Specification for materials, fabrication and erection Rolled and welded ... slabs with profiled steel sheeting; Part 5: Code of practice for design of cold formed thin gauge sections; Part 6: Code of practice for design of light gauge profiled steel sheeting; Part 7: Specification ... buildings Part 1: Code of practice for dead and imposed loads BS 6399-2, Loading for buildings Part 2: Code of practice for wind loads BS 6399-3, Loading for buildings Part 3: Code of practice for...

222
2,959
0

Part 4: Code of practice for design of composite slabs with profiled steel sheeting ppt

... — Part 4: Code of practice for design of composite slabs with profiled steel sheeting; — Part 5: Code of practice for design of cold formed sections; — Part 61): Code of practice for design of ... Part of BS 5950 gives recommendations for the design of composite slabs with profiled steel sheeting It covers slabs spanning only in the direction of span of the profiled steel sheets This code ... light gauge profiled sheeting; — Part 7: Specification for materials and workmanship: cold formed sections; — Part 8: Code of practice for fire resistant design; — Part 9: Code of practice for stressed...

Part 6. Code of practice for design of light gauge profiled steel sheeting ppt

... practice for design of cold formed sections Code of practice for design of light gauge profiled steel sheeting Specification for materials and workmanship: cold formed sections Code of practice for ... sections Design in composite construction Code of practice for design of simple and continuous composite beams Code of practice for design of composite slabs with profiled steel sheeting Code of practice ... practice for fire resistant design Code of practice for stressed skin design This Part of BS 5950 gives recommendations for the design of light gauge profiled steel sheeting as roof decking, flooring,...

Part 8: Code of practice for fire resistant design pot

... 3.1: Code of practice for design of simple and continuous composite beams; — Section 3.21): Code of practice for design of composite columns and frames; — Part 4: Code of practice for design of ... Specification for materials and workmanship: cold formed sections; — Part 8: Code of practice for fire resistant design; — Part 91): Code of practice for stressed skin design This Part of BS 5950 ... 5950-4, Code of practice for design of floors with profiled steel sheeting BS 8110, Structural use of concrete BS 8110-2, Code of practice for special circumstances CP 290, Code of practice for suspended...

Part 9: Code of practice for stressed skin design pptx

... cold formed sections; — Part 8: Code of practice for fire resistant design; — Part 9: Code of practice for stressed skin design This Part of BS 5950 gives recommendations for the use of profiled ... steel sheeting; — Part 5: Code of practice for design of cold formed sections; — Part 61): Code of practice for design of light gauge profiled sheeting; — Part 7: Specification for materials and ... Part 3: Design in composite construction — Section 3.1 Code of practice for design of simple and continuous composite beams; — Part 4: Code of practice for design of composite slabs with profiled...

Part 2: Code of practice for wind loads pps

... Key for flat roofs Figure 17 — Key to eave details for flat roofs Figure 18 — Key for inset storey Figure 19 — Key for monopitch roofs Figure 20 — Key for duopitch roofs Figure 21 — Key for hipped ... hipped roofs Figure 22 — Key for mansard and multipitch roofs Figure 23 — Key for multi-bay roofs Figure 24 — Key for free-standing canopy roofs Figure 25 — Reduction factor for length of elements ... for flat roofs Figure 36 — Examples of zones of flat roof of arbitrary plan shape Figure 37 — Additional zones around inset storey Figure 38 — Key for monopitch roofs Figure 39 — Symmetries for...

Part 3: Code of practice for imposed roof loads potx

... Part to BS 6399 (formerly CP 3: Chapter V) Imposed roof loads were previously included in BS 6399-1 This new Part of BS 6399 now gives more information on imposed roof loads and in particular gives ... 6399-1 ,Code of practice for dead and imposed loads BS 6399-2, Wind loads CP 3, Code of basic data for the design of buildings1) CP 3: Chapter V, Loading ISO 3898, Bases for design of structures ... occurs For roofs with no access, the minimum imposed roof load value includes an allowance for repair and maintenance work For roofs with access, consideration needs to be given to how the roof may...

30
1,887
4

Xem thêm