... developments in operating system software werethe UNIX operating system (1969–70), the CM operating system for the8086Microprocessor (1980), and the MS-DOS operating system (1981). ... York,1988.Echte, K. Dependable Computing—EDCC-1. Proceedings of the First EuropeanDependable Computing Conference, Berlin, Germany,1994.Fault-Tolerant Computing Symposium,25th Anniversary ... appendices of this book interrelate.1.1WHAT IS FAULT-TOLERANT COMPUTING?Literally, fault-tolerant computing means computing correctly despite the exis-tence of errors in a system. Basically,...
... error detecting; single error correcting320Double error detecting; zero error correcting430Triple error detecting; zero error correcting421Double error detecting; single error correcting540Quadruple ... detecting; zero error correcting531Triple error detecting; single error correcting522Double error detecting; double error correcting650Quintuple error detecting; zero error correcting641Quadruple ... codes that wediscuss in this chapter are error-detecting and -correcting codes. The principlethat underlies error-detecting and -correcting codes is the addition of speciallycomputed redundant...
... will provide an error-detecting but not an error-correcting code; however, the availability of parity checks for more than onegroup of strips provides error-correcting ability. Consider the ... the expendi-tures.2. Parallel redundancy, where one or more extra components are operatingand waiting to take over in case of a failure of the primary system. Inthe case of two computers ... Eq. (3.33) by approximating e−lctand e−ltbythe first two terms in the expansion—cf. Eq. (3.17)—yielding (1− e−lt) ≈ lt,e−lct≈1− lct. Substituting these approximations...
... pairwise voting is slightly worse than it is for TMR.There are various other combinations of advanced voting techniques de-TABLE4.12Comparison of Reliabilities for Various Voting SystemsPairwise-out-of-Single ... Level VotingAssume that a digital system is composed of m series subsystems, each havinga constant-failure rate l, and that voting is to be applied at the subsystem level.The majority voting ... a5-level voter system.Higher-Level Voting. One could extend the above analysis to cover higher-level voting systems; for example,7-level and9-level voting. Even though itis easy to replicate...
... constructing the prototype, an initial control struc-ture (the main program coordinating all the parts) is written and tested along withthe interfaces to the various components (subroutines and ... errors[Shooman,1983, pp.332–335].dEd(t)dtaEr(t)(5.25a)Substituting for Er(t), from Eq. (5.20) and letting Ed(t)Ec(t) yieldsdEc(t)dta[ET− Ec(t)] (5.25b)Rearranging ... by5k100and9k100. Taking logarithms and solving the resulting equations yields2.09≤ k ≤2.86. Thus, starting with the top-level0, we will have about2or3successorlevels....
... reliabilities:0.94×0.96×0.94×0.94×0.930.71415. The resulting network is shown in Fig.6.11(a).Now, we repeat the design procedure by calculating a maximum-reliability326NETWORKED SYSTEMS RELIABILITY(f) ... node b inthe all-terminal computation. Of course, eliminating node b does not invalidatethe transmission between nodes a and c. If we continue to use Eq. (6.46) todefine all-terminal reliability, ... from a center (a costly connection). The Esau–Williams’s algorithm aids ineliminating this problem by implementing a trade-off between the connectionto a center and the interconnection between...
... very large system, we might consider continuing the optimization to level2by applying apportionment again to each of the subsystem goals. In fact,we can continue this process until we reach the ... this method isquite useful even if it is not the first one attempted. Adopting the terminologyof government contracting (which generally has parallels in the commercialworld), we might say ... andsuboptimum system designs. This provides guidance when choices must bemade rapidly and conflicting design constraints must be satisfied.REFERENCESAGREE Report. Reliability of Electronic Equipment....
... nhân sự của công ty.1.3 Đặc điểm về sản phẩm và thị trườngSV: Nguyễn Thị Hải Yến Lớp: QTCL4712Chuyên đề thực tập tốt nghiệpCHƯƠNG II: ĐÁNH GIÁ THỰC TRẠNG SỰ AN TOÀN VÀ ĐỘTIN CẬY CỦA PHƯƠNG ... nghiệpKết cấu của bài viết ngoài phần mở đầu, kết luận được chia thành 3 chương: Chương I: Giới thiệu tổng quan về công ty.Chương II: Đánh giá thực trạng sự an toàn và độtincậycủa phương thức ... theo quy định của công ty và của pháp luật.- Công tác hành chính:+ Thực hiện tốt công tác quản lý tài sản và vật tư tiêu hao.+ Thực hiện tốt việc liên hệ & truyền đạt thông tincủa BGĐ đến...
... TOÀN VÀ ĐỘ TIN CẬYCỦA PHƯƠNG THỨC THANH TOÁN TRỰC TUYẾN TRONG GIAO DỊCH THƯƠNG MẠI ĐIỆN TỬ CỦA CÔNG TY 78CỔ PHẦN GIẢI PHÁP PHẦN MỀM HÒA BÌNH 78Nâng cao sự an toàn và độtincậycủa phương thức ... tại PeaceSoft.II. Ý nghĩa của chuyên đề Trong phạm vi nghiên cứu của đề tài, em xin đề cập tới thực trạng sự an toàn và độtincậycủa dịch vụ thanh toán trực tuyến của công ty trong quá trình ... TOÀN VÀ ĐỘTINCẬYCỦA PHƯƠNG THỨC THANH TOÁN TRỰC TUYẾN TRONG GIAO DỊCH THƯƠNG MẠI ĐIỆN TỬ Ở CÔNG TY CỔ PHẦN GIẢI PHÁP PHẦN MỀM HÒA BÌNH 352.1 Tình hình hoạt động sản xuất kinh doanh của công...
... nghiên cứu tính toán độtincậycủa lưới điện phân phối trung áp. Áp dụng ngôn ngữ lập trình Delphi xây dựng phần mềm tính toán và đề xuất một số giải pháp nâng cao độtincậycủa lưới điện phân ... pháp nâng cao độtincậycủa lưới điện phân phối tỉnh Thái Nguyên [6]. Bài báo chưa đề cập đến vấn đề dự trữ máy biến áp phân phối trong lưới điện phân phối để nâng cao độtincậy và giảm thời ... dự phòng hợp lý, bài báo tập trung chủ yếu vào nghiên cứu tính toán độtincậy và xây dựng phần mềm tính toán độtincậycủa lưới điện phân phối trung áp, từ kết quả tính toán được đề xuất một...
... tiêu độtincậy tơng ứng. Ngoài ra, từ các giá trị cờng độ hỏng và cờng độ phục hồi của các phân hệ, có thể xác định đợc các thông số độtincậycủa tổng thể đầu máy: 1- Cờng độ hỏng của ... trị của chúng, ta sẽ đợc biểu thức xác định các xác suất giới hạn của hệ thống. 66chơng III Độ tincậycủa đầu máy nh một hệ thống kỹ thuật độc lập 3.1. Cơ sở đánh giá độtincậycủa ... thức xác định độtincậycủa các phân hệ (i) và hệ thống (s) Độ tincậycủa hệ thống đầu máy-một hệ thống nối tiếp Các phần tử không phục hồi Các phần tử có phục hồi 1. Hàm tincậy (xác suất...
... như PeaceSoft muốn nâng cao sự an toàn và độtincậycủa dịch vụ TTTT trong giao dịch TMĐT của công ty.Sự tin cậy, giống như tình yêu, là một cảm giác tinh tế khó nắm bắt, xây dựng nên thì khó ... website được tincậy không bao giờ lơ là hay hài lòng với danh tiếng của mình. Lãnh đạo công ty cần phải xác định tư tưởng rõ ràng cho toàn bộ nhân viên của mình, đó là: “Lòng tincủa khách hàng ... một thái độ nhiệt tình và lịch sự thì khách hàng mới yên tâm quay lại với dịch vụ của công ty ở những lần sau.Một nhân tố quan trọng nữa để chiếm lòng tincủa khách hàng là sự tincậy trong...
... rằng: độtincậycủa hệ thống không thể nhỏ hơn độtincậycủa phần tử có độ tin cậy thấp nhất min)(tPi . Trong sơ đồ nối tiếp, muốn nâng cao độtincậycủa hệ thống, phải nâng cao độtin cậy ... song càng tăng thì độtincậycủa hệ thống càng tăng. → độtincậycủa hệ thống ≥ độtincậycủa phần tử. → Kết luận: có thể xây dựng các sơ đồ có khả năng có độtincậy cao, trên cơ sở ... đến độtincậycủa các p tử không phục hồi. 2) Độtincậy – thời gian làm việc tincậy trung bình thời gian làm việc cho phép: Độ tincậy là khả năng phần tử thực hiện được chức năng của nó...
... suất dự đoán độ đúng đắn càng nhỏ thì khoảng giới hạn tincậy càng nhỏ. Khoảng tincậy là đại lượng xuất phát từ độ lệch tiêu chuẩn S của phương pháp đo, phụ thuộc vào độtincậycủa các giá ... = ± 4,30 với xác suất tincậy 95%. Khoảng tincậy ở xác suất 95% 4,3 0,00500,084 0,084 0,0123×=± =± 2. Vì có giá trị tincậy σ với xác suất 95% Khoảng tincậy ở xác suất ở 95%1,96 ... giới hạn đó được gọi là khoảng tin cậy. Cần chú ý một số tính chất của khoảng tin cậy. Đối với một mẫu đã cho, giá trị của khoảng này một phần được xác định bằng độ hy vọng đã cho trước. Rõ ràng...
... 1.2. Testing writing In this section, to understand what testing writing is, it is crucial to discuss the writing types, criteria to test writing accurately and problems in testing writing. ... testing writing Many problems may occur in testing writing; however, Hughes (1989:75) represents the main considerations in testing writing which can be also seen as the main problems in testing ... thesis, consisting of three main issues: language testing (definitions, approaches, roles, purposes and relationships between testing and teaching- learning); testing writing (types of writing, criteria...