... tincậy của hệthống không thể nhỏ hơn độtincậy của phần tử có độ tin cậy thấp nhất min)(tPi . Trong sơ đồ nối tiếp, muốn nâng cao độtincậy của hệ thống, phải nâng cao độtin cậy của ... hệthống ≥ độtincậy của phần tử. trong các phần tử song song, số phần tử song song càng tăng thì độtincậy của hệ thống càng tăng. → độtincậy của hệthống ≥ độtincậy của phần tử. ... 1) Độtincậy của sơ đồ nối tiếp: Giả sử có n phần tử, mà mỗi p tử có độtincậy là )(tPi. Độ tincậy của hệthống được xác định: 1)()()(1≤→=∏=tPtPtPiniiht Ta thấy rằng: độ tin...
... developments in operating system software werethe UNIX operating system (1969–70), the CM operating system for the8086Microprocessor (1980), and the MS-DOS operating system (1981). ... York,1988.Echte, K. Dependable Computing—EDCC-1. Proceedings of the First EuropeanDependable Computing Conference, Berlin, Germany,1994.Fault-Tolerant Computing Symposium,25th Anniversary ... appendices of this book interrelate.1.1WHAT IS FAULT-TOLERANT COMPUTING?Literally, fault-tolerant computing means computing correctly despite the exis-tence of errors in a system. Basically,...
... error detecting; single error correcting320Double error detecting; zero error correcting430Triple error detecting; zero error correcting421Double error detecting; single error correcting540Quadruple ... detecting; zero error correcting531Triple error detecting; single error correcting522Double error detecting; double error correcting650Quintuple error detecting; zero error correcting641Quadruple ... codes that wediscuss in this chapter are error-detecting and -correcting codes. The principlethat underlies error-detecting and -correcting codes is the addition of speciallycomputed redundant...
... will provide an error-detecting but not an error-correcting code; however, the availability of parity checks for more than onegroup of strips provides error-correcting ability. Consider the ... the expendi-tures.2. Parallel redundancy, where one or more extra components are operatingand waiting to take over in case of a failure of the primary system. Inthe case of two computers ... Eq. (3.33) by approximating e−lctand e−ltbythe first two terms in the expansion—cf. Eq. (3.17)—yielding (1− e−lt) ≈ lt,e−lct≈1− lct. Substituting these approximations...
... pairwise voting is slightly worse than it is for TMR.There are various other combinations of advanced voting techniques de-TABLE4.12Comparison of Reliabilities for Various Voting SystemsPairwise-out-of-Single ... Level VotingAssume that a digital system is composed of m series subsystems, each havinga constant-failure rate l, and that voting is to be applied at the subsystem level.The majority voting ... a5-level voter system.Higher-Level Voting. One could extend the above analysis to cover higher-level voting systems; for example,7-level and9-level voting. Even though itis easy to replicate...
... constructing the prototype, an initial control struc-ture (the main program coordinating all the parts) is written and tested along withthe interfaces to the various components (subroutines and ... errors[Shooman,1983, pp.332–335].dEd(t)dtaEr(t)(5.25a)Substituting for Er(t), from Eq. (5.20) and letting Ed(t)Ec(t) yieldsdEc(t)dta[ET− Ec(t)] (5.25b)Rearranging ... by5k100and9k100. Taking logarithms and solving the resulting equations yields2.09≤ k ≤2.86. Thus, starting with the top-level0, we will have about2or3successorlevels....
... reliabilities:0.94×0.96×0.94×0.94×0.930.71415. The resulting network is shown in Fig.6.11(a).Now, we repeat the design procedure by calculating a maximum-reliability326NETWORKED SYSTEMS RELIABILITY(f) ... node b inthe all-terminal computation. Of course, eliminating node b does not invalidatethe transmission between nodes a and c. If we continue to use Eq. (6.46) todefine all-terminal reliability, ... from a center (a costly connection). The Esau–Williams’s algorithm aids ineliminating this problem by implementing a trade-off between the connectionto a center and the interconnection between...
... very large system, we might consider continuing the optimization to level2by applying apportionment again to each of the subsystem goals. In fact,we can continue this process until we reach the ... this method isquite useful even if it is not the first one attempted. Adopting the terminologyof government contracting (which generally has parallels in the commercialworld), we might say ... andsuboptimum system designs. This provides guidance when choices must bemade rapidly and conflicting design constraints must be satisfied.REFERENCESAGREE Report. Reliability of Electronic Equipment....
... hàm tronggiá trị trung bình và một sai số khác bao hàm trong giá trị độ lệch tiêu chuẩn. Sai số trongđánhgiá σ. Sự giảm số biểu lộ ảnh hưởng kép đến độ lệch tiêu chuẩn. Thứ nhất là số giá ... dự đoán độ đúng đắn càng nhỏ thì khoảng giới hạn tincậy càng nhỏ. Khoảng tincậy là đại lượng xuất phát từ độ lệch tiêu chuẩn S của phương pháp đo, phụ thuộc vào độtincậy của các giá trị ... = ± 4,30 với xác suất tincậy 95%. Khoảng tincậy ở xác suất 95% 4,3 0,00500,084 0,084 0,0123×=± =± 2. Vì có giá trị tincậy σ với xác suất 95% Khoảng tincậy ở xác suất ở 95%1,96...
... Các khu vc này s đc đánh s ký hiu 1,2,3 và vv. đc th hin trong s gi mi ln mt đin. phân tích đánh giá đ tin cy mt phát tuyn mt phát tuyn trong lun vn này chia ... xác, thì kt qu đánhgiá là chính xác. Khi ngành đin nc ta đang tng bc đi vào th trng đn cnh tranh thì phng pháp này s tr thành mt công c đánhgiá đc đ tin cy phát tuyn ... "rep" "1" Trong hàng "swt" và "0" trong hàng No No No Yes HUTECH I.GII THIU tài (đánh giá đ tin cy phát tuyn hình...
... 1.2. Testing writing In this section, to understand what testing writing is, it is crucial to discuss the writing types, criteria to test writing accurately and problems in testing writing. ... testing writing Many problems may occur in testing writing; however, Hughes (1989:75) represents the main considerations in testing writing which can be also seen as the main problems in testing ... thesis, consisting of three main issues: language testing (definitions, approaches, roles, purposes and relationships between testing and teaching- learning); testing writing (types of writing, criteria...