0

toyota camry repair manual 2000

Camry Repair Manual AIR CONDITION

Camry Repair Manual AIR CONDITION

Điện - Điện tử

... detector and repair if neces-sary(2) Charge proper amount of re-frigerant(3) If indicated pressure value isnear 0 when connected to gauge,create the vacuum after inspectingand repairing the ... sure to read the following item carefully, thenfollow the correct procedure described in the repair manual. AC0M1–01AC–36–AIR CONDITIONING BLOWER UNIT2518AuthorĂ: DateĂ:DISASSEMBLY1. REMOVE ... both handvalves of manifold gauge set and stop the vacuum pump.Check the system for leaks and repair necessary.(e) Close both the high and low hand valves and stop the vac-uum pump.(f) Leave...
  • 94
  • 402
  • 0
Camry Repair Manual AUTOMATIC TRANSAXLE

Camry Repair Manual AUTOMATIC TRANSAXLE

Điện - Điện tử

... bolt.(c) Pry up the pipe with a screwdriver and remove the pipe.8. REMOVE MANUAL VALVE BODYRemove the 5 bolts and manual valve body.9. REMOVE CONNECTOR CLAMP AND PIPE RETAINERRemove the 2 ... PARK/NEUTRAL POSITION (PNP) SWITCHAX–51925A uthorĂ: DateĂ:PARK/NEUTRAL POSITION (PNP)SWITCHON–VEHICLE REPAIR 1. DISCONNECT PARK/NEUTRAL POSITION SWITCHCONNECTOR2. REMOVE PARK/NEUTRAL POSITION SWITCH(a) ... TRANSAXLE (A140E) DIFFERENTIAL OIL SEALAX–111904A uthorĂ: DateĂ:DIFFERENTIAL OIL SEALON–VEHICLE REPAIR 1. REMOVE LH AND RH DRIVE SHAFTS(See page SA–17)2. REMOVE SIDE GEAR SHAFT OIL SEALUsing...
  • 58
  • 437
  • 0
Camry Repair Manual AUTOMATIC TRANSAXLE MANUAL

Camry Repair Manual AUTOMATIC TRANSAXLE MANUAL

Điện - Điện tử

... toanother, thus controlling shifting and lock–up timing. INTRODUCTION GENERAL REPAIR INSTRUCTIONS–IN–4GENERAL REPAIR INSTRUCTIONS1. Use fender, seat and floor covers to keep the vehicleclean ... the same time.The component groups are inspected and repaired from the converter housing side.As much as possible, complete the inspection, repair and assembly before proceeding to the next com-ponent ... hammer and punch, drive out the pin.(d) Slide out the shaft and remove the manual valve leverfrom the case.57. REMOVE MANUAL SHAFT OIL SEALRemove the oil seal with a screwdriver. AUTOMATIC...
  • 429
  • 379
  • 0
Camry Repair Manual BODY ELECTRICAL

Camry Repair Manual BODY ELECTRICAL

Điện - Điện tử

... Door lock manual switch OFF or UNLOCK No continuityA1 – Ground Door lock manual switch LOCK ContinuityA2 – Ground Door lock manual switch OFF or LOCK No continuityA2 – Ground Door lock manual ... No.1)5. Wire Harness–––BE–70–Door lock system does not operate by manual switch.1. Power Window Master Switch2. Door Lock Manual Switch3. Integration Relay (I/P J/B No.1)4. Wire HarnessBE–60BE–70BE–70–Door...
  • 135
  • 351
  • 0
Camry Repair Manual BODY ELECTRICAL BODY

Camry Repair Manual BODY ELECTRICAL BODY

Điện - Điện tử

... lock manual switch OFF or UNLOCK No continuityA16 – Ground Door lock manual switch LOCK ContinuityA17 – Ground Door lock manual switch OFF or LOCK No continuityA17 – Ground Door lock manual ... No.1)5. Wire Harness–––BE–70–Door lock system does not operate by manual switch.1. Power Window Master Switch2. Door Lock Manual Switch3. Integration Relay (I/P J/B No.1)4. Wire HarnessBE–60BE–70BE–70–Door...
  • 298
  • 305
  • 1
Camry Repair Manual COOLANT

Camry Repair Manual COOLANT

Cơ khí - Chế tạo máy

... the system with coolant.z Use of improper coolants may damage engine cool-ing system.z Use Toyota Long life Coolant” or equivalent andmix it with plan water according to the manufactur-er’s ... between the ”LOW” and ”FULL” lines, when the engine is cold.If low, check for leaks and add ’ Toyota Long Life Coolant” or Equivalent up to the ”FULL” line.2. CHECK ENGINE COOLANT QUALITY(a)...
  • 72
  • 416
  • 1
Camry Repair Manual DIAGNOSTICS

Camry Repair Manual DIAGNOSTICS

Điện - Điện tử

... switch ON.CHECK:Read temperature value on the OBD II scan tool or TOYOTA hand–held tester.OK:Temperature value: –40°C (–40°F)OK Repair or replace harness or connector.NGCheck and replace ECM ... DateĂ:1 Connect OBD II scan tool or TOYOTA hand–held tester, and read value of man-ifold absolute pressure.PREPARATION:(a) Connect the OBD II scan tool or TOYOTA hand–held tester to the DLC3.(b) ... ON and push the OBD II scan tool or TOYOTA hand–held tester main switchON.CHECK:Read value of the manifold absolute pressure on the OBD II scan tool or TOYOTA hand–held tester.OK:Same as...
  • 1,304
  • 442
  • 0
Camry Repair Manual EMISSION CONTROL

Camry Repair Manual EMISSION CONTROL

Điện - Điện tử

... malfunctioning.(f) TOYOTA Hand–Held Tester:Conclude forced driving of the VSV for the EVAP.(1) Stop the engine.(2) Disconnect the TOYOTA hand–held tester from theDLC3.(g) If you have no TOYOTA Hand–Held ... thepurge line.(c) TOYOTA Hand–Held Tester:Forced driving of the VSV for the EVAP.(1) Connect a TOYOTA hand–held tester to the DLC3.(2) Start the engine.(3) Push the TOYOTA hand–held tester ... of fuel for reducedexhaust emissionsRemark: * For inspection and repair of the SFI system, refer to the SF section of this manual. B01252AirDisconnectAir Inlet Line HoseB01253PinchPushAAPinchB01148B01149AirPurge...
  • 35
  • 325
  • 0
Camry Repair Manual INTRODUCTION

Camry Repair Manual INTRODUCTION

Điện - Điện tử

... TO USE THIS MANUAL IN–11AuthorĂ: DateĂ:HOW TO USE THIS MANUAL GENERAL INFORMATION1. INDEXAn INDEX is provided on the first page of each section to guide you to the item to be repaired. To ... FI1066IN0CO–04Z11554Seal Lock AdhesiveIN–4–INTRODUCTION REPAIR INSTRUCTIONS4AuthorĂ: DateĂ: REPAIR INSTRUCTIONSGENERAL INFORMATIONBASIC REPAIR HINT(a) Use fender, seat and floor covers to keep ... replace them with new parts.(5) Before repairs, remove the airbag sensor if shocksare likely to be applied to the sensor during repairs.(6) Never disassemble and repair the airbag sensor as-sembly,...
  • 84
  • 236
  • 0

Xem thêm