timing requirements for tr nox ozone season allowance allocations
A research proposal submitted in partial fulfillment of the requirements for the degree of Master of Business Administration
Ngày tải lên :
13/04/2013, 10:30
... Do Ba Khang and Dr Clemens Bechter for their valuable contribution in serving as committee members, as well as for their constructive comments and helpful instructions on the research study I ... developing countries, we won’t go for more details about Japan retailing industry) • Sophisticated - Hong Kong and Singapore • Transitional - Taiwan, South Korea, Thailand and Malaysia • Traditional ... money is concentrated Traditional stores still play a major role and there is a high dependence on wholesalers and distributors, who are very strong (AR, Nov 1992) Despite a lack of structure in...
- 51
- 1K
- 3
BUILDING CODE REQUIREMENTS FOR STRUCTURAL CONCRETE (ACI 318-99) AND COMMENTARY
Ngày tải lên :
03/08/2013, 11:24
... for the strength deficiency 3.5.3.3 — Bar mats for concrete reinforcement shall conform to “Specification for Fabricated Deformed Steel Bar Mats for Concrete Reinforcement” (ASTM A 184) Reinforcing ... only for spiral reinforcement (either as lateral reinforcement for compression members, for torsion members, or for confining reinforcement for splices) 3.5.4.2 — Plain wire for spiral reinforcement ... for reinforcement 7.7—Concrete protection for reinforcement 7.8—Special reinforcement details for columns 7.9—Connections 7.10—Lateral reinforcement for compression members 7.11—Lateral reinforcement...
- 1.3K
- 1.8K
- 16
Requirements for the Generic Bus Driver Model
Ngày tải lên :
07/10/2013, 00:20
... driver creates an abstraction (in the form of a data structure) for each function it discovers The driver that the bus driver loads to control the discovered function uses this abstraction to access ... installed on the platform Problems with this method are: • Detection methods used by drivers might conflict with hardware already installed on the platform For example, if a platform has a drill ... general way For a bus driver, there are no device class dependencies The membership of an attached function in one device class or another (for example, storage, audio, input, and so on) is transparent...
- 6
- 326
- 0
Requirements for entry
Ngày tải lên :
01/11/2013, 09:20
... qualifications Chemistry with either Mathematics or Biology or Physics Graduate entry available UKCAT compulsory for graduate entry BMAT compulsory for undergraduate entry Graduate entry available UKCAT ... perseverance are part of the same package They feed on dual enthusiasm for science and for the healing art of medicine 29 Requirements for entry They are inspired by curiosity and enriched by sparks of ... of making an 31 Requirements for entry informed personal decision Learning Medicine puts less emphasis on the years in medical school and more on where they lead Personal health requirements and...
- 22
- 270
- 0
Tài liệu Cabling Standard - TIA 607 - Commercial Building Grounding and Bonding Requirements for Telecommu doc
Ngày tải lên :
10/12/2013, 02:15
... INFRASTRUCTURE The electrical service entrance is outside the scope of this Standard and is grounded and bonded in accordance with all applicable electrical codes In all cases the applicable electrical ... 606 for additional labeling requirements Bonding Conductors for Telecommunications Quang Dung Technology Distribution Company Page of ANSI/TIA/EIA 607 Commercial Building Grounding and Bonding Requirements ... Bonding Requirements for Telecommunications Table of Contents OVERVIEW COMPONENTS OF THE TELECOMMUNICATIONS GROUNDING AND BONDING INFRASTRUCTURE Identification Elements Bonding Conductors for Telecommunications...
- 7
- 593
- 2
iec 60269-2-1 low-voltage fuses - supplemetary requirements for fuses for use by authorized perso
Ngày tải lên :
25/12/2013, 10:47
... J965D9:H06D9P5@5,d-5(5J9653JE765N4HEJP7G50I5E45J965D9:H06D9P5(?-5V5435+?-5 VT5 \435 6T :TR5 EL75 3JE76 N4HEJP7G5J375,d-5V5J965//-5VT5'L75GEJ96J365NJH07G54856T:T53JE765N4HEJP75J37594E537HJE765E45EL7...
- 264
- 753
- 4
iec 60269-2 low-voltage fuses - supplementary requirements for fuses for use by authorized person
Ngày tải lên :
25/12/2013, 10:53
... INTERNATIONAL ELECTROTECHNICAL COMMISSION LOW-VOLTAGE FUSES Part 2: Supplementary requirements for fuses for use by authorized persons (fuses mainly for industrial application) FOREWORD 1) The formal decisions ... 1: Second part: - Part 2: General Requirements (Publication 269-1) Supplementary Requirements for Fuses for Use by Authorized Persons (Fuses Mainly for Industrial Application) (Publication 269-2) ... Supplementary Requirements for Fuses for Use by Unskilled Persons (in preparation) 1.1 Scope These supplementary requirements apply to fuses for use by authorized persons Fuses for use by authorized...
- 30
- 315
- 3
iec 60269-4-1 low-voltage fuses - supplementary requirements for fuse-links for the protection of
Ngày tải lên :
25/12/2013, 10:54
... autre(s) 4 4 la norme a besoin d’être révisée la norme est incomplète la norme est trop théorique la norme est trop superficielle le titre est équivoque je n’ai pas fait le bon choix autre(s) ... conditions for construction 7.1 Mechanical design The standardized dimensions of the fuse-links are given in figures 1(IA) to 3(IA) 7.1.7 Construction of a fuse-link For indication of operation a trip ... de la partie cylindrique ne doivent pas être dépassées 2) Le diamètre de la cartouche entre les extrémités des capsules ne doit pas dépasser le diamètre c Figure (IIIA) – Eléments de remplacement...
- 42
- 420
- 2
iec 60269-4 low-voltage fuses - supplementary requirements for fuse-links for the protection of s
Ngày tải lên :
25/12/2013, 10:55
... 2b Test arrangements for other kinds of fuse-links are given in IEC 60269-2-1: Supplementary requirements for fuses for use by authorised persons (fuses mainly for industrial application) and ... haute tension destinộs ờtre utilisộs dans des circuits comprenant des trans- 787 (1983) Application guide for the selection of fuse-links of high-voltage fuses for transformer circuit appiiCatiaiS ... - INTERNATIONAL ELECTROTECHNICAL COMMISSION LOW-VOLTAGE FUSES Part 4: Supplementary requirements for fuse-links for the protection of semiconductor devices FOREWORD 1) The formal decisions or...
- 87
- 404
- 1
iec 60364-7-707 electrical installations of buildings - requirements for special installations or
Ngày tải lên :
25/12/2013, 11:05
... (1982) Quatrième partie: Protection pour assurer la sécurité Chapitre 41: Protection contre les chocs électriques 364-4-42 (1980) Quatrième partie: Protection pour assurer la sécurité Chapitre 42: ... International Electrotechnical Commission Plugs and Socket-outlets for Domestic and Similar General Use Standards Plugs, Socket-outlets and Couplers for Industrial Purposes Part : General Requirements ... Equipment Specification for Conduits for Electrical Installations Part 2: Particular Specifications for Conduits Section One - Metal Conduits Document provided by IHS Licensee=Qatar Petroleum/5943408104,...
- 23
- 295
- 4
iec 60439-2 low-voltage switchgear and controlgear assemblies - particular requirements for busba
Ngày tải lên :
25/12/2013, 11:05
... AND CONTROLGEAR ASSEMBLIES - Part 2: Particular requirements for busbar trunking systems (busways) FOREWORD The IEC (International Electrotechnical Commission) is a worldwide organization for standardization ... 2.3.14 busbar trunking unit for building movements busbar trunking unit intended to allow for building movements due to thermal expansion and contraction of the building 2.3.1 busbar trunking fire ... verification of electrical characteristics of busbar trunking system (see 8.2.9); j) verification of structural strength (see 8.2.1 O); k) verification of the endurance of trunking systems with trolley type...
- 74
- 820
- 14
iec 60439-3 low-voltage switchgear and controlgear assemblies - particular requirements for iow-v
Ngày tải lên :
25/12/2013, 11:06
... Particular requirements for low-voltage switchgear and controlgear assemblies intended to be installed in places where unskilled persons have access for their use Distribution boards - FOREWORD ... domaines de l'ộlectricitộ et de l'ộlectronique A cet effet, la CEI, entre autres activitộs, publie des Normes internationales Leur ộlaboration est confiộe des comitộs d'ộtudes, aux travaux desquels ... and controlgear assemblies - Part 3: Particular requirements for low-voltage switchgear and controlgear assemblies intended to be installed in places where unskilled persons have access for their...
- 49
- 488
- 4
iec 60439-4 low-voltage switchgear and controlgear assemblies - particular requirements for assem
Ngày tải lên :
25/12/2013, 11:07
... Isolating transformers and safety isolating transformers - Requirements 60755 (1983): General requirements for residual current operated protective devices COPYRIGHT International Electrotechnical ... dioxide test for 60076: Power transformers 60309: Plugs, socket-outlets and couplers for industrial purposes 60364-4-41 (1982): Electrical installations of buildings, Part 4: Protection for safety ... - INTERNATIONAL ELECTROTECHNICAL COMMISSION LOW-VOLTAGE SWITCHGEAR AND CONTROLGEAR ASSEMBLIES - Part 4: Particular requirements for assemblies for construction sites (ACS) FOREWORD 1) The IEC...
- 56
- 514
- 5
iec 60439-5 low-voltage switchgear and controlgear assemblies - particular requirements for assem
Ngày tải lên :
25/12/2013, 11:08
... Particular requirements for assemblies intended to be installed outdoors in public places Cable distribution cabinets (CDCs) for power distribution in networks FOREWORD The IEC (International Electrotechnical ... public places Cable distribution cabinets (CDCs) for power distribution in networks 1.1 General Scope and object This standard gives supplementary requirements for cable distribution cabinets (CDCs), ... reseau de distribution (ERD): ENSEMBLE en armoire, pour installation extộrieure fixe, destinộ ờtre utilisộ pour la distribution par cõble de l'ộnergie ộlectrique d'autres matộriels Ces autres matộriels...
- 56
- 780
- 6
Tài liệu DIRECTORS’ VIEWS ON ACCOUNTING AND AUDITING REQUIREMENTS FOR SMES pptx
Ngày tải lên :
18/02/2014, 01:20
... and Auditing Requirements for SMEs _ Table 3.1 Distribution by industry Standard Industrial Classification A, B Agriculture, Hunting and Forestry; Fishing ... contribution to the evidence base 14 Directors’ Views on Accounting and Auditing Requirements for SMEs _ Accounting and auditing requirements for SMEs Introduction ... to the study Introduction Purpose Structure of the report 13 13 13 14 Accounting and auditing requirements for SMEs Introduction Statutory accounts Financial Reporting Standard for Smaller Entities...
- 69
- 793
- 0
Tài liệu HIGHLIGHTS OF THE AUTHORISATION REQUIREMENTS FOR FUND DISTRIBUTION IN HONG KONG doc
Ngày tải lên :
19/02/2014, 14:20
... the specific requirements on unit trusts and mutual funds PwC February 2012 Authorisation Process A collective investment scheme applying for an SFC authorisation for public distribution in Hong ... jurisdiction Applications for reviewed on the basis that the scheme's structural and operational requirements, and core investment restrictions, already comply in substance with the local requirements However, ... report; Information of the scheme's management company demonstrating its fit and propriety; The trustee/custodian's latest audited report (if any); A consent letter of appointment from the trustee/custodian...
- 13
- 537
- 0
Báo cáo khoa học: Biochemical characterization of USP7 reveals post-translational modification sites and structural requirements for substrate processing and subcellular localization pptx
Ngày tải lên :
07/03/2014, 05:20
... Fernandez-Montalvan et al deletion of structural features outside the protease core Therefore, we conclude that these domains are important for catalysis A contribution for the TRAFlike domain should not ... EGFP USP7 70-205-EGFP Fig Structural–functional features and constructs of USP7 designed for this study (A) Schematic representation of the USP7 structure The N-terminal TRAF-like domain (amino ... [20,23–25] These structures illuminated an activation mechanism for USP7 in which a papain-like catalytic triad (C223, H464 and D481) is assembled via conformational changes triggered by the interaction...
- 15
- 592
- 0
REQUIREMENTS FOR MANUFACTURERS OF MOTOR VEHICLES AND MOTOR VEHICLE EQUIPMENT ppt
Ngày tải lên :
07/03/2014, 11:20
... A=Snowmobile Trailer B=Boat Trailer C=Car Hauler Trailer D=Dump Trailer E=Enclosed Trailer F=Flatbed Trailer G=Curtain Side Trailer H=Hydraulic Dovetail J=Double Drop Trailer K=Camper Trailer L=Lowboy Trailer ... then mail the forms to the tire manufacturer See Appendix 10 for a sample tire registration form Instead of furnishing the tire purchaser with a registration form, independent tire distributors or ... is constructed either on a truck chassis or with special features for occasional off-road operation Truck A motor vehicle with motive power, except a trailer, designed primarily for the transportation...
- 68
- 1.8K
- 0
FIGURATIVE SCULPTURE IN PAPER CLAY - IN PARTIAL FULFILLMENT OF THE REQUIREMENTS FOR THE DEGREE OF MASTER OF FINE ARTS ppt
Ngày tải lên :
07/03/2014, 13:20
... for offering perspective Michael Garrett, for truth and insight in the midst of chaos Seth Piercy, for unwavering strength and support Robert Reedy, for teaching me how to see myself with humor ... the information regarding her earlier ceramic works from Hayden Herrera’s book [11] For the last ten years or so, Mary has concentrated on prints and paintings, particularly using a large triptych ... working with for the multiple benefits of greenware strength, moisture wicking for fast even drying, and wet on dry applications EXPERIMENTATION It was a ceramics student at ETSU named Troy who first...
- 53
- 519
- 0