the structure sb find s smth sb adjective use to express one s opinion about someone or smth nhận thấy ai đó cái gì như thế nào
Publicly Funded Agricultural Research and the Changing Structure of U.S. Agriculture doc
Ngày tải lên :
06/03/2014, 15:20
... the assumption that one of the mandates of the public sector is to serve constituents, as demonstrated by the enabling legislation that established the public sector agricultural research system ... businesses, and private-sector research and development and technology transfer policies The committee recognizes the public sector s efforts thus far to investigate these driving forces and the ... constructive comments and suggestions, they were not asked to endorse the conclusions or recommendations nor did they see the final draft of the report before its release The review of this report...
- 158
- 403
- 0
Tìm hiểu về học máy và phương pháp học khái niệm xây dựng module mô phỏng thuật toán find s
Ngày tải lên :
10/12/2013, 14:28
... consistent( g , D) ( g ' H ) ( g ' g g ) consistent( g ' , D) Định nghĩa Biên chi tiết S không gian giả thuyết H tập liệu đào tạo D tập giả thuyết chi tiết H phù hợp với D S s H consistent( s, ... cách thích hợp sau hiệu chỉnh dần qua mẫu đào tạo Ước lượng giá trị đào tạo Nếu b kết thúc Vtrain(b) xác định b cờ trung gian Vtrain(b) xác định theo quy tắc: Vtrain(b) V (successor(b)) Điều ta ... S s H consistent( s, D) ( s' H ) ( s s' ) consistent( s' , D) g Tập G S hồn tồn đặc tả VH,D nhờ định lý sau Định lý 2.1 Định lý biễu diễn không gian tƣờng thuật Giả s X tập mẫu tuỳ ývà H tập...
- 35
- 793
- 1
Báo cáo khoa học: Relationship between the structure of guanidines and N-hydroxyguanidines, their binding to inducible nitric oxide synthase (iNOS) and their iNOS-catalysed oxidation to NO pptx
Ngày tải lên :
16/03/2014, 22:20
... lead to a shift of the activity of NOS from NO synthesis to N-hydroxyguanidine synthesis Further investigations are currently underway to test these hypotheses Our results also suggest that the ... technique [22] The kinetics of the binding of some of these substrates to iNOSoxy was also studied by UV ⁄ Vis spectroscopy using stopped-flow techniques [23,24] The corresponding thermodynamic ... [4–7] NOS-catalysed oxidation of some of these compounds showed kcat values as high as 80% that obtained with NOHA, and some proved to be selective for one of the three isoforms vs the others [5,7]...
- 12
- 507
- 0
Trả lời câu hỏi "What''''s the date today?" thế nào? pdf
Ngày tải lên :
19/03/2014, 19:20
... “What s the date today?” Với câu hỏi này, người Anh trả lời nào? Người Mỹ trả lời nào? Có khác văn nói văn viết khơng? Sau đọc xong viết sau, bạn trả lời tất câu hỏi Ngày ... Mar September Sept April Apr October Oct May - November Nov June - December Dec Dạng viết tắt dạng đầy đủ Ngày: Ngày Viết tắt Monday Mon Tuesday Tue Wednesday Wed Thursday Thu Friday Fri Saturday ... Thu Friday Fri Saturday Sat Sunday Sun Năm Từ năm 2000 trở đi, năm đọc giống s đếm 2000 - two thousand 2003 - two thousand and three Những năm trước có cách đọc khác: nhóm s vào nhóm nối nhóm...
- 7
- 1.1K
- 0
it's not about the technology
Ngày tải lên :
01/06/2014, 10:11
... drives the growth, so one might be tempted to speak in generalities Nevertheless any useful discussion of such failures will have to elicit the specific ways in which these failures manifest themselves ... platform to our east coast prospects Practically every customer tells us that our software tools don’t speak the same language as their system design requires Worse, there are other tools in the ... companies that have multiple business units and hundreds of products in the market, such as this So in a first order of tasks, she pulls together the key customer-focused sales and marketing managers...
- 222
- 323
- 0
Ph d dissertation abstract agriculture evaluate the impact of pesticide use to farmer’s health in tea cultivating in thai nguyen and the intervention’s effects
Ngày tải lên :
14/07/2014, 13:28
... - The tea cultivator s attitude to using pesticides: 97.4 % of them are worried about their health when spaying pesticides, 98.7 % of user of pesticides said that it is necessary to use personal ... and some factors related to the health of people regularly exposed topesticides - The most muscle symptoms of farmers contacting with pesticides during the last time is nervous system, digest Some ... farmers here is very nescessary Charter SUBJECTS AND METHOD 2.1 Subjects 2.1.1 Subjects described - KAP study subjects, examinations assess the actual structure of common diseases and interventions...
- 24
- 400
- 0
Structure Steel Design''''s Handbook 2009 part 1 docx
Ngày tải lên :
11/08/2014, 20:21
... guarantees the accuracy or completeness of any information published herein and neither McGraw-Hill nor its authors shall be responsible for any errors, omissions, or damages arising out of use of ... or stored in a data base or retrieval system, without the prior written permission of the publisher DOC / DOC 9 ISBN 0-07-008782-2 The sponsoring editor for this book was Larry S Hager, the editing ... BRIDGES) Prickett, Joseph E., P.E Senior Associate, Modjeski and Masters, Inc., Harrisburg, Penn- sylvania (SECTION 13 TRUSS BRIDGES) xv xvi CONTRIBUTORS Roeder, Charles W., P.E Professor of Civil Engineering,...
- 6
- 303
- 0
Structure Steel Design''''s Handbook 2009 part 2 pptx
Ngày tải lên :
11/08/2014, 20:21
... moment-resisting above) (See also Rigid frames) seismic coefficients for seismic design for (See also Earthquakes) seismic loads on (see Loads, seismic) seismic response spectra for seismic slenderness ... states for load factors for principles of resistance factors for versus ASD (See also Beams; Columns; Composite beams; Strength design; Trusses) Manganese Martensite Maxwell s reciprocal theorem ... flutter theory for negative-slope theory for resistance to vortex theory for wind-effect studies for wind-induced damaged to (See also Bridge, suspension; Cables) Systems (see Structures) Tees Tempering...
- 51
- 360
- 0
Structure Steel Design''''s Handbook 2009 part 5 ppsx
Ngày tải lên :
11/08/2014, 20:21
... for which the shear stress is zero These are called principal directions On the plane for which the shear stress is zero, one of the normal stresses is the maximum stress ƒ1 and the other is the ... stress ƒ2 for all possible states of stress at that point Hence the normal stresses on the planes in these directions are called the principal stresses The magnitude of the principal stresses ... SUBJECTED TO TORSION Forces or moments that tend to twist a member are called torisonal loads In shafts, the stresses and corresponding strains induced by these loads depend on both the shape and size...
- 118
- 472
- 0
Structure Steel Design''''s Handbook 2009 part 6 pot
Ngày tải lên :
11/08/2014, 20:21
... discontinuities should be reinforced with strong members to absorb the bending stresses there At the supports also, strong members are needed to transmit stresses from the plates into the supports The structure ... it is possible that torsion may be transferred into adjacent members, normally, torsion is not considered in grids comprised of steel beams because of their low torsional stiffness Methods of ... cable-stayed structures Characteristics of Cables A suspension cable is a linear structural member that adjusts its shape to carry loads The primary assumptions in the analysis of cable systems are...
- 61
- 403
- 0
Structure Steel Design''''s Handbook 2009 part 7 doc
Ngày tải lên :
11/08/2014, 20:21
... causes compression in the compression splice By calculations in Art 5.26, the splice plates are OK for the maximum compressive stress of 20 ksi and for stress range Therefore, the splice plates ... in truss chords should be reamed or drilled full size with members assembled Truss-chord assemblies should consist of at least three abutting sections Milled ends of the compression chords should ... electroslag or electrogas welding processes should conform to the requirements of AWS D1.1 or D1.5 for these processes For bridges, the impact requirements in D1.5 are mandatory Welding processes...
- 109
- 905
- 0
Structure Steel Design''''s Handbook 2009 part 8 potx
Ngày tải lên :
11/08/2014, 20:21
... Fi ϭ the portion of the seismic base shear induced at level i The seismic design story shear is to be distributed to the various elements of the force-resisting system in a story based on the ... arenasc Bleachers Fixed seats (fastened to floor) Stairs and exitways (see Table 6.2b also) Storage warehouses Light Heavy Stores Retail First floor Upper floors Wholesale, all floors Walkways and ... design 6.3 STANDARD SPECIFICATIONS Standard specifications are consensus documents sponsored by professional or trade associations to protect the public and to avoid, as much as possible, misuse...
- 100
- 434
- 0
Structure Steel Design''''s Handbook 2009 part 9 pptx
Ngày tải lên :
11/08/2014, 20:21
... COMPRESSION MEMBERS Steel members in buildings subject to compressive axial loads include columns, truss members, struts, and diagonal braces Slenderness is a major factor in design of compression ... connectors, studs, or other types of mechanical shear elements welded to the top flange of the steel beam to ensure composite action and to resist the horizontal shear forces between the steel ... EXAMPLE—LRFD FOR STEEL PIPE IN AXIAL COMPRESSION Pipe sections of A36 steel are to be used to support framing for the flat roof of a one- story factory building The roof height is 18 ft from the tops of the...
- 39
- 581
- 0
Structure Steel Design''''s Handbook 2009 part 10 potx
Ngày tải lên :
11/08/2014, 20:21
... clearances within the structure, because cables sag below their supports Usually the cables are supported on posts, or towers, or on walls Anchorages are required to resist the tension in the cables ... framing system with a minimum floor -to- floor height for multistory residential construction, the staggered truss system was developed This system consists of story-high trusses spanning the full ... connection to the space frame is provided at the top chord nodes In these cases, the roofing system does not transmit bending stresses to the top chord members Regardless of the type of space frame, the...
- 35
- 379
- 0
Structure Steel Design''''s Handbook 2009 part 12 pot
Ngày tải lên :
11/08/2014, 20:21
... Ag is the gross cross section area, An is the net cross section area, Fy is the design yield stress and Fu is the tensile strength As with all of the member design provisions, these nominal strengths ... Doubly-Symmetric Sections For doubly-symmetric sections, such as back -to- back Csections, subject to torsional buckling, Fe is taken as the smaller of Eq 10.61 and the torsional buckling stress, t, ... depicts the various components in a typical steel framed dwelling The AISI Specification provides design methods for wall stud assemblies For compression loads, the studs can be designed as a stand-alone...
- 46
- 276
- 0
Structure Steel Design''''s Handbook 2009 part 13 pdf
Ngày tải lên :
11/08/2014, 20:21
... be used for design Stress range is the algebraic difference between the maximum stress and the minimum stress Tension stress is considered to have the opposite algebraic sign from compression stress ... placed on fascia girders for esthetic reasons and may be used on portions of girders 11.42 SECTION ELEVEN subject to tensile stresses or stress reversals If this happens, designers should ensure that ... Loads Designers should use the actual dead weights of materials specified for the structure For the more commonly used materials, the AASHTO Specifications provide the weights to be used For other...
- 78
- 377
- 0
Structure Steel Design''''s Handbook 2009 part 14 potx
Ngày tải lên :
11/08/2014, 20:21
... forces should be disregarded The resulting stresses to be considered are axial stresses in the members bracing the flanges of stringers, beams and girders, axial stresses in the chords of trusses ... Components subject to stresses from wind loads only should be designed for the basic allowable stresses Also, no increase in the basic allowable stresses in high strength bolts should be taken for ... tie skewing Tie skewing must be prevented because it closes the gage between the rails Hook bolts or tie anchor assemblies, not shown in the sketch, are used to fasten the tie to the support...
- 27
- 286
- 0