talking with 802 11b compactflash nics
Implementing 802 11 with microcontrollers wireless networking for embedded systems designers
Ngày tải lên :
08/03/2016, 11:34
... CHAPTER 802. 11b CompactFlash Network Interface Cards It would be next to impossible to get a microcontroller on the air with 802. 11b without the PRISM radio hardware contained within an 802. 11b NIC ... by side with the other CompactFlash NICs, it is a bit taller than the other CompactFlash NICs I tested Like all 802. 11b CompactFlash NICs, the TEW-222CF uses DSSS technology The original 802. 11 ... The 802. 11b CompactFlash NIC’s are based on standards that allow the CompactFlash 802. 11b radio cards to participate in standard Ethernet LAN environments That means that although the 802. 11b CompactFlash...
- 393
- 1.7K
- 0
the linux tcp ip stack networking for embedded systems
Ngày tải lên :
06/07/2014, 15:32
... Division Multiplexing (FDM) With the FDM method, an analog broadband carrier is modulated with separate bands of 3-KHz voice channels with a 1-KHz separation Along with FDM came automatic switching ... addition, with asynchronous methods, there are no synchronizing external clock sources, nor are there are any synchronizing pulses embedded within the data stream Each character is separately framed with ... invited my book proposal James Walsh, the acquisitions editor, has been with me during the entire process Jim has been very patient with me as I faced unanticipated problems delaying the work and needed...
- 481
- 331
- 0
the linux tcp ip stack networking for embedded systems
Ngày tải lên :
06/07/2014, 15:35
... Division Multiplexing (FDM) With the FDM method, an analog broadband carrier is modulated with separate bands of 3-KHz voice channels with a 1-KHz separation Along with FDM came automatic switching ... addition, with asynchronous methods, there are no synchronizing external clock sources, nor are there are any synchronizing pulses embedded within the data stream Each character is separately framed with ... invited my book proposal James Walsh, the acquisitions editor, has been with me during the entire process Jim has been very patient with me as I faced unanticipated problems delaying the work and needed...
- 481
- 352
- 0
Free Software tools for embedded systems
Ngày tải lên :
20/10/2013, 00:15
... Creative Commons AttributionShareAlike 2.5 license Jan 24, 2008 http://freeelectrons.com Best viewed with This document is best viewed with a recent PDF reader or with OpenOffice.org itself! Take advantage of internal or external hyperlinks ... As long as they distribute the sources to their users, the GPL doesn't require vendors to share their sources with any third party No issue with all the GPL sources developed by or with the community Graphical toolkits developed by the vendors look proprietary. Their ... GNU C library (glibc) Designed for performance compliance with standards Best for servers and desktops uClibc Highly compatible, but implemented for small embedded systems with little storage space and RAM Others: diet libc, newlib, klibc...
- 132
- 425
- 0
Tài liệu C Programming for Embedded Systems docx
Ngày tải lên :
22/12/2013, 02:17
... declare the control ports with #pragma port in the device header file •You can declare an interrupt raised by the conversion peripheral with #pragma vector and service it with an ISR function This ... 42 Testing Choices 44 Design for Debugging 44 Code Inspection 44 Execution within a Simulator Environment 45 Execution within an Emulator Environment 45 Target System in a Test Harness 45 Page ... provides an introduction to 8-bit microprocessors for those who have not dealt with them on a low level before With a good plan and in-depth information about the central controller, the design...
- 191
- 549
- 1
Tài liệu Báo cáo "Dynamically reconfiguration architecture for embedded systems using Kaffe " doc
Ngày tải lên :
13/02/2014, 03:20
... that will lead to an increase in performance [4], as shown in Figure Within the block diagram, all connections are 32 bits wide with one exception This is due to the fact that Java byte-code is ... co-processor Each of the threads are standard threads within the Kaffe virtual Machine except for the Hardware handler that is added for communicating with the ARM processor interface The hardware handler ... the program options get the class name to start with – * create and initialize the Java VM (calling JNI based on KNI) – * find the class to start with (JNIEnv *env, char *argv[], int farg, int...
- 7
- 411
- 0
C Programming for Embedded Systems ppt
Ngày tải lên :
22/03/2014, 09:20
... declare the control ports with #pragma port in the device header file •You can declare an interrupt raised by the conversion peripheral with #pragma vector and service it with an ISR function This ... 42 Testing Choices 44 Design for Debugging 44 Code Inspection 44 Execution within a Simulator Environment 45 Execution within an Emulator Environment 45 Target System in a Test Harness 45 Page ... provides an introduction to 8-bit microprocessors for those who have not dealt with them on a low level before With a good plan and in-depth information about the central controller, the design...
- 191
- 390
- 1
Model-Based Design for Embedded Systems- P1 pdf
Ngày tải lên :
02/07/2014, 15:20
... and how a unified methodology together with a supporting software framework can be developed to improve the level of efficiency of the embedded electronics industry This chapter first presents ... comprehensive overview of modeling with timed and hybrid automata These types of automata have been introduced in order to blend the discrete world of computers with the continuous physical world ... and Department de Microelectrònica i Sistemes Electr nics Universitat Autonòma de Barcelona Barcelona, Spain Vincent Gagne STMicroelectronics, Inc Ottawa, Ontario, Canada Luiza Gheorghe Department...
- 30
- 491
- 0
Model-Based Design for Embedded Systems- P2 doc
Ngày tải lên :
02/07/2014, 15:20
... the two streams, with the upper stream having higher priority than the lower stream This reflects the fact that the decoder gives a higher quality of service (QoS) to the stream with a higher frame ... Component networks corresponding to the video decoding example in Section 1.2: (a) without resource interaction, and (b) with resource interaction 10 Model-Based Design for Embedded Systems number ... output drives the task in the process P4 , which runs on CPU3 with a second priority This is modeled by feeding the GPC component with the remaining resources from the process P2 We can conclude...
- 30
- 434
- 0
Model-Based Design for Embedded Systems- P3 pptx
Ngày tải lên :
02/07/2014, 15:20
... and other microarchitectures 2.4.4.1 Modeling with the Help of Reservation Tables The timing information of every program construct can be described with a reservation table Originally, reservation ... predicted branch behavior with the executed branch behavior If dynamic branch prediction is used, a model of the underlying state machine is implemented and its results are compared with the executed ... cache position the instruction with this address is cached The tag information is used to determine which address was cached, as there can be multiple addresses with the same cache index Therefore,...
- 30
- 559
- 0
Model-Based Design for Embedded Systems- P4 ppt
Ngày tải lên :
02/07/2014, 15:20
... Section 3.2, used together with the methods of Section 3.3, now delivers a complete framework for the performance analysis of heterogeneous multiprocessor systems with shared memories The following ... activation timings of the frames The timings of signals transmitted within these frames arriving at the receiving side To cope with both the challenges, we introduce hierarchical event streams ... of each static scenario can be achieved with classical real-time performance analysis, timing failures during the transition phase can only be uncovered with new methods, which consider the transient...
- 30
- 416
- 0
Model-Based Design for Embedded Systems- P6 pps
Ngày tải lên :
02/07/2014, 15:20
... time wcetτ3 = 14) using an UPPAAL model with stopwatches, this example can now be analyzed without the “Out of memory” error Even though the verification with stopwatches is using overapproximations, ... for providing us with versions of UPPAAL under development, in order for us to conduct initial experiments with verifications of larger and realistic systems as well as models with stopwatches ... Round Robin (Token Bus), the FDMA, the TDMA (TTP), the Switched Ethernet, the WLAN (802. 11b) , and the ZigBee (802. 15.4) The blocks only simulate the medium access (the scheduling), possible collisions...
- 30
- 389
- 0
Model-Based Design for Embedded Systems- P7 pot
Ngày tải lên :
02/07/2014, 15:20
... hard, periodic tasks with soft, aperiodic tasks in the same kernel This is illustrated in the following example, where a ball and beam controller should execute in parallel with an aperiodically ... periodic task with a sampling period of 10 ms The computation time of the controller is ms (2 ms for calculating the output and ms for updating the controller state) A Poisson source with an intensity ... Tmote Sky systems is event-driven programming with interrupt 162 Model-Based Design for Embedded Systems FIGURE 6.11 Stationary sensor network nodes with ultrasound receiver circuit The node is...
- 30
- 373
- 0
Model-Based Design for Embedded Systems- P8 pps
Ngày tải lên :
02/07/2014, 15:20
... July 2008 With permission.) 214 Model-Based Design for Embedded Systems if they are specified as separate tasks in the CIC Note that data parallelism is specified with OpenMP directives within a ... information on how to interface with the HW accelerator is specified in an architecture information file Then, the code segment contained within a pragma section will be replaced with the appropriate HW-interfacing ... represents the weight associated with each cost factor (Cproc , Ccomm , and Csucc ) and indicates the significance of the factor in the total cost C p, t as compared with the other factors The factors...
- 30
- 548
- 0
Model-Based Design for Embedded Systems- P9 ppt
Ngày tải lên :
02/07/2014, 15:20
... to write and debug the interfacing code with IDCT HW IP, without and with the interrupt controller, respectively The sizes of the interface without and with the interrupt controller were 14 and ... polling at line of Figure 8 .11b If we use the accelerator with interrupt, an interrupt controller is additionally attached to the target platform, as shown in Figure 8.10c, with information on the ... for the IDCT with interrupt, and (b) the interrupt handler code (From Kwon, S et al., ACM Trans Des Autom Electron Syst., 13, Article 39, July 2008 With permission.) For a processor without OS...
- 30
- 347
- 0
Model-Based Design for Embedded Systems- P10 pot
Ngày tải lên :
02/07/2014, 15:20
... communicating with each other Each such object is termed a process in the MMM, and associated with a sequential program called a thread A process communicates through ports where a port is specified with ... agrees with the output value of mpegDecode In general, many mapping networks may exist for the same service with different algorithms or architectures Such a set of networks, together with constraints ... specifications with monolithic modeling styles can be made efficient with much less effort In [63], by exploring the intrinsic characteristics of orthogonal concerns, we came up with a series...
- 30
- 420
- 0
Model-Based Design for Embedded Systems- P11 ppsx
Ngày tải lên :
02/07/2014, 15:20
... concert with model checkers It can perform property verification on a single trace even when other approaches would fail because of their excessive memory and space requirements In our experience with ... as replacing interprocess communication with assignments This technique proved particularly effective and allowed us generate a production-quality code with improved performance Applying the QSS ... optimized with the QSS need to use these communication primitives To convey relevant design information to the QSS, we use a back-end tool that translates a design to be scheduled with the QSS...
- 30
- 424
- 0
Model-Based Design for Embedded Systems- P12 potx
Ngày tải lên :
02/07/2014, 15:20
... processing does not impact this aspect of simulation Comparing Classes with or with confirms this This contrasts heavily with the runtime of the simulation (in which the PE type is a key factor) ... mapping for a UMTS case study with limited overhead as compared with a baseline SystemC model We showed that the design effort involved in carrying out 48 separate mappings with a variety of architectural ... conversion to METRO II was only 1% per file More than half of these lines (58%) have to with registering the constraints with the solvers The conversion of a SystemC runtime processing model (the Sparc...
- 30
- 330
- 0
Model-Based Design for Embedded Systems- P13 doc
Ngày tải lên :
02/07/2014, 15:20
... core(s) with 128 kB internal program memory System clock frequencies vary from 300, 350, 400 MHz The Linedancer-P1 integrates an associative processor (ASProCore, with 4K PEs), a single SPARC core with ... reconfigurable region along with bus macros and the interface control logic 12.5.1 Abstracting the Reconfigurable Socket Within EDK, all logic must be encapsulated within IP cores In PR designs, ... Results obtained with the synthesis are as follows: • The area of one MONTIUM core is 3.5 mm2 of which 0.2 mm2 is for the CCU and 3.3 mm2 is for the MONTIUM TP (including memory) • With Synopsys...
- 30
- 615
- 0