sequential pseudocode for the divide and conquer algorithm
Evolutionary divide and conquer strategy for identification of structural systems and moving forces
Ngày tải lên :
11/09/2015, 10:00
... - Expensive computation for managing and processing the enormous data collected and - The need of a large number of sensors To address these problems, the divide- and- conquer approach provides ... an assumed force, and then updating the force using the identified parameters By carrying out several iterations, the structural parameters and applied forces could be identified The method was ... as to dedicate the search effort to the remaining parameters Based on several runs of the iGAMAS, the means and standard deviations of the identified parameters are computed The standard deviation...
- 165
- 244
- 0
VoIP: How to Plan for the Bandwidth and Calculate the Cost Savings
Ngày tải lên :
18/10/2013, 18:15
... at the sending end before it is transported across the WAN Silence can be added back at the receiving end VAD is more bandwidth efficient for the WAN, but it will further lower the MOS VAD and ... three minutes The remote sites can also live with a 5% busy grade of service and the busiest hour of the day handles 20% of the traffic Like HQ, no other hour handles more than 12% The two remote ... However, since the layer frame relay header is four bytes and the layers 3, 4, and are 40 bytes as described above, then the amount of bandwidth needed for G.711 is greater when the headers are...
- 9
- 458
- 0
