... hydraulicbehaviour of packed columns for the development of a new method for the standardpresentation of the fluid dynamics of columns with any type of packing design. The basicprinciples of the method for ... withdifferent kinds of packings. Understanding of principles for packing design, internal traf-fic of phases within the column and implementing of theoretical models into indus-trial practice is of vital ... Dynamic Designof Columns withModernRandomandStructuredPackings 2896.8.1 ProgrammeInformation 2896.8.2 Conclusions 295Part 2Principles of the Fluid Dynamic Designof Packed Columns for Liquid/Liquid...
... include an analysis of the in-fluence of nonoptimal design, and analytical expressions for the singular values of the LOS matrix are derived as a func-tion of the quality of the array design. The results ... the optimal design. Furthermore, some work on the design of uniform rectangular arrays (URAs) for MIMO systems is pre-sented in [10], where the optimaldesignfor the special case of two broadside ... authors of the presentpaper have previously studied the optimaldesignof uni-form linear arrays (ULAs) with respect to mutual informa-tion (MI) [8, 9], and have given a simple equation for theoptimal...
... analysis of DME and FTD designs. 68Figure 27: Mass and energy flow of DME design and FTD design. 69 34Table 6: Contaminant specification for cobalt FT synthesis, and cleaning effectiveness of ... bed for black liquor steam reforming at low temperatures. Steam injected at the bottom of the vessel fluidizes the bed particles and also provides a source of water needed for steam reforming[34]. ... negligible for gasification of biomass and coal [100]. The amount of black liquor in the gasifier is about 17 wt. %, with coal making up 83% of the feed on a weight basis and 94% of the feed...
... aslikely. The value of 9.6 lm computed by autodock for the KI of the solution of the lowest binding energy(Table 3) is remarkably close to the experimental value of 9.3 lm found for KIin inhibition ... type example of the S9A subfamily.P. Rigolet et al. Sites for the designof inhibitors of PepX activityFEBS Journal 272 (2005) 20502059 ê 2005 FEBS 2051 The structural comparison of the bacterial ... residual activity (RA, %). IC50and KIvalues for bothinhibitors have been obtained from analysis of these graphics.Sites for the designof inhibitors of PepX activity P. Rigolet et al.2054 FEBS...
... of the Design Variables for a Hybrid Electric Car with Solar Cells, Proc. of METIME Conference, June 2-3, 2005, University of Galati, RO. [19] Ahman M. (2001), Primary Energy Efficiency of ... savings due to use of aluminium instead of steel for chassis: in this case, of course, additional costs would be considered in the cost model [22]. Thus, the mass of the car body for HSV can be ... Engineering, University of Salerno, 84084 Fisciano (SA), Italy ABSTRACT: A model for the optimaldesignof a solar hybrid vehicle is presented. The model can describe the effects of solar panels...
... optimization of the operating and design pa-rameters of these columns and complexes (optimal design calculations). Methods of the general geometric theory of distillation, encoded in software, provide ... The creation of this book necessitatedthe development of DistillDesigner software that allowed us to refine, check, andconfirm the algorithms ofoptimal designing and also to provide for a significantportion ... shown that for n > 3, sometimes infinite number of sets of productscompositions is feasible at one and the same value of parameter D/F. Prognosis of plurality of products compositions is of great...
... optimumdesigns of the branch ed single-wall carbon nanotubeswith b =0.3,m =2,N = 2 and different length ratio g.The design in the background of Figure 4a has a smallervalue of g, while that of ... lower value for T0(0) - T0(L0) than the uniform path design repre-sented by Eq. 10. The optimal designs are illustrated inFigure 2 (b). Three curves represent the three shapes of the nanocone ... optimization of such a branchednetwork of CNTs for heat dissipation has not beenanalyzed so far. This section thus deals in detail withthe optimum designof bifurcate single-walled CNTs for efficiently...
... tackled the problem ofoptimaldesign of linear arrays in a cellular systems under the assumption of Gaussian interference. Two design problems are considered:maximization of the ergodic capacity ... minimization of the interference power atthe output of the matched filter (by developing a closed formapproximation of the performance criterion), for fixed andvariable positions of user and ... mobile, it is of interest to evaluatethe optimal spacings not only for a fixed position of usersand interferers but also by averaging the performance met-ric over the positions of user and interferers...
... determining the optimal hyperplane.4. SUPPORT VECTOR MACHINES FOR DICHOTOMOUS WOS FILTERS4.1. Linear support vector machines for dichotomous WOS filtersIn the above section, the new approach of designing ... 0.(29)Now, we formulate the optimaldesignof WOS filters asthe following constrained optimization problem.Given the training samples{(Xi, mi)}Li=1,findanoptimalvalue of the weight ... toprovide excellent performance on many applications. In thispaper, SVMs are introduced into the designof WOS filters inordertoimproveperformance.WOS filters are special subset of stack filters. Each...
... and the covering rate for the set of trials of the first designof experiments (Ta ble 2).These designs have been tested on 180 input images se-lected from a video sequence of over 30 000 city ... P.Courtney,N.Thacker,andA.Clark,“Algorithmicmodel-ing for performance evaluation,” in Proceedings of the ECCVWorkshop on Performance Characteristics of Vision Algorithms,p. 13, Cambridge, UK, April 1996.[3] W. Forstner, “10 pros ... descriptors are relevant for the tuningpurpose, the neural network should converge. The other part of the image database is reserved for the test of the neuralnetwork. The performance of the tuning will...
... the form of (14)(forj= 0, 1, ,M− 1) can be designed such that the error system E in theform of (23) is stable and its H2norm is minimized.Formally, as is well known, the H2norm of E ... for the designof IIR receivers for a noisy TMUXsystem. The approach of [17] is generally conservative due tothe fac t that the same Lyapunov matrix is adopted for boththe H2and H∞performances. ... 10.1155/ASP/2006/64645 Optimal Designof Noisy Transmultiplexer SystemsHuan Zhou1and Lihua Xie21Signal Processing Group, Institute of Physics, University of Oldenburg, 26111 Oldenburg, Germany2School of...
... Roadmap for SemiconductorsJJitter , arriva l time of clock transition, 882KKarush–Kuhn–Tucker (KKT) condition, for optimality, 95kd tree, 57–59, 67–68range query algorithm on, 59 for set of ... 772Yield losssources of, 774–775types of, 773Yield optimization, methods for corner-based design analysis, 786critical area, 783–785 design rules, 785–786future of parametric, 786–787ZZelikovsky’s ... Alpert/Handbook of Algorithms for Physical Design Automation AU7242_C048 Finals Page 1016 9-10-2008 #161016 IndexOptical system of imaging t ool, 702Optical wave, cross-section view, 709 Optimal buffer...
... Alpert/Handbook of Algorithms for Physical Design Automation AU7242_C000 Finals Page i 9-10-2008 #1Handbook of Algorithms for Physical design Automation Alpert/Handbook of Algorithms for Physical Design ... Physical Design Automation AU7242_C000 Finals Page vi 9-10-2008 #6 Alpert/Handbook of Algorithms for Physical Design Automation AU7242_C000 Finals Page iii 9-10-2008 #3Handbook of Algorithms for ... a not -for- profit organization that provides licenses and registration for a variety of users. For orga-nizations that have been granted a photocopy license by the CCC, a separate system of payment...