point to point frame relay lab
Voice over IP/Frame Relay Lab Scenarios
Ngày tải lên :
19/10/2013, 02:15
... address
encapsulation frame- relay
frame- relay traffic-shaping
hold-queue 1024 out
!
interface Serial2.1 point- to -point
ip address 172.16.16.1 255.255.255.252
frame- relay interface-dlci 102 ... address
encapsulation frame- relay
frame- relay traffic-shaping
hold-queue 1024 out
!
interface Serial2.1 point- to -point
ip address 172.16.16.2 255.255.255.252
frame- relay interface-dlci 201 ... eigrp 100
network 172.16.0.0
!
ip classless
!
map-class frame- relay FR1
no frame- relay adaptive-shaping
frame- relay cir 768000
frame- relay bc 1000
!
!
!
line con 0
line aux 0
line vty 0 4
...
- 8
- 326
- 0
Tài liệu Back-to-Back Frame Relay ppt
Ngày tải lên :
21/12/2013, 19:15
... adaptive-shaping
frame- relay bc
frame- relay be
frame- relay becn-response-enable
frame- relay broadcast-queue
frame- relay cir
frame- relay class
frame- relay custom-queue-list
frame- relay de-group
frame- relay ... header-compression
frame- relay lapf frmr
frame- relay lapf k
frame- relay lapf n200
frame- relay lapf n201
frame- relay lapf t200
frame- relay lapf t203
frame- relay lmi-n391dte
frame- relay lmi-n392dce
frame- relay ... success-events
frame- relay end -to- end keepalive timer
frame- relay fair-queue
frame- relay fragment
frame- relay idle-timer
frame- relay interface-dlci
frame- relay intf-type
frame- relay inverse-arp
frame- relay ip tcp...
- 330
- 306
- 0
Tài liệu Point to Point Protocol (PPP) pptx
Ngày tải lên :
18/01/2014, 20:20
...
Thuật to n Lempel-Ziv (LZS) (RFC 1974
) cung cấp cơ chế nén và giải nén nhanh dữ
liệu. Thuật to n này được sử dụng trong cơ chế nén STAC trong PPP, ISDN và Frame
Relay.
Point to Point Protocol ... hai cơ chế
chứng thực Password Authentication Protocol (PAP) hay Challenge Handshake
Authentication Protocol (CHAP).
ã Network Control Protocol (NCP): NCP lm nhim v thit lập, điều chỉnh cấu ... code xác định cho nó, và giá trị mã này được đặt trong
trường protocol của gói tin NCP, một số giá trị ví dụ như sau:
Code
Protocol
8021 IP
8029 AT
8025 XNS, Vines
8027 DECnet
8031 Bridge...
- 6
- 555
- 2
Tài liệu Point-to-Point GRE over IPsec Design Guide pdf
Ngày tải lên :
24/01/2014, 10:20
... Control
Plane
Dynamic
Routing
IPsec Control
Plane
Dynamic
Crypto Map
DPD
Static Crypto
Map
DPD
Headend Branch
Dynamic
Routing
GRE Control
Plane
Point- to -Point
GRE
Point- to -Point
GRE
8
Point- to -Point GRE over IPsec Design Guide
OL-9023-01
Preface
... configured to allow the tunnel traffic bi-directionally. The crypto headend must be
accessible to the branch router.
2-21
Point- to -Point GRE over IPsec Design Guide
OL-9023-01
Chapter 2 Point- to -Point ... provided in
Chapter 2, Point- to -Point GRE over IPsec Design and
Implementation.”
2-19
Point- to -Point GRE over IPsec Design Guide
OL-9023-01
Chapter 2 Point- to -Point GRE over IPsec Design...
- 106
- 1.1K
- 0
Cisco Systems - Configuring serial point-to-point encapsulation ppt
Ngày tải lên :
06/03/2014, 15:20
... default data-link layer
protocol for encapsulating data on synchronous
serial data links.
ã
PPP encapsulates network layer protocol
information over point- to -point links.
ã
Configurable ... protocol.
â 2002, Cisco Systems, Inc. All rights reserved. ICND v2.07-4
ã
Supports only single-protocol environments
HDLC Frame Format
ã
Uses a proprietary data field to support
multiprotocol ... will be able to:
ã
Use Cisco IOS commands to configure serial interfaces
using HDLC and PPP encapsulation for leased-line
connections, given a functioning router
ã
Use show commands to identify...
- 21
- 433
- 0
Configuring Point-to-Multipoint OSPF Over Frame Relay
Ngày tải lên :
19/10/2013, 03:15
...
Singapore(config-if) #frame- relay map ip 192.168.192.1 17 broadcast
Singapore(config-if) #frame- relay map ip 192.168.192.2 17 broadcast
Singapore(config-if)#ip ospf network point- to- multipoint
Verify Frame Relay ... operation with a ping from each router to the other two. Use show
frame- relay pvc and show frame- relay map to troubleshoot connectivity
problems. Rebooting the Frame Relay switch might also solve connectivity ...
SanJose3(config-if) #frame- relay map ip 192.168.192.2 18 broadcast
SanJose3(config-if) #frame- relay map ip 192.168.192.4 16 broadcast
SanJose3(config-if)#ip ospf network point- to- multipoint
Note...
- 6
- 490
- 1
Quản trị mạng Lab 10 - Frame relay
Ngày tải lên :
13/11/2012, 10:56
... multipoint và 2
router ở dạng point- to -point
Đối với các router multipoint: cần vào subinterface multipoint và dùng
lệnh frame- relay map để map tới các router khác
Đối với các router point- to -point: ... frame- relay inverse-arp
4. You decide to use subinterface point- to- multipoint with this topology to reserve IP
address. The IP subnet is 192.168.100.0 /24.
5. Tip: create a subinterface point- to- multipoint ... point- to -point và
dùng lệnh frame- relay interface dlci để gắn tĩnh dlci cho subinterface đó.
End of lab 10
4. Each router has two virtual circuits to two neighbors. Use subinterface point- to- point...
- 4
- 561
- 7
Tài liệu Lab 5.2.1 Configuring Frame Relay doc
Ngày tải lên :
11/12/2013, 14:15
... configuration
lab.
Step 2 Configuring the serial interface
a. In Frame Relay, the customer router is considered the DTE device. In order to configure the
serial interface the Layer 2 Frame Relay frame ...
Cork(config-if)#end
Step 3 Verifying the Frame Relay configuration
a. To verify the configuration, use the show interface commands, related to Frame Relay. To
view the serial interface configuration ... format of the Frame Relay management protocol must be configured. To configure the
Local Management Interface (LMI) type, use the following commands:
Cork(config-if) #frame- relay lmi-type...
- 5
- 594
- 1
Tài liệu Lab 5.2.2 Configuring Frame Relay PVC doc
Ngày tải lên :
11/12/2013, 14:15
...
Step 7 Showing Frame- Relay map
a. To view the Layer 2 to Layer 3 mapping, use the show frame- relay map command at the
privileged exec mode prompt:
Washington#show frame- relay map
b. ... Frame Relay switch in this configuration and consequently no Frame Relay DCE:
Washington#configure terminal
Washington(config-if)#interface serial 0
Washington(config-if)#encapsulation frame- relay ... configuration
lab.
Step 2 Configuring the serial interface
First, define the Frame Relay frame type to be used on this link. To configure the encapsulation type,
use the command encapsulation frame- relay...
- 6
- 387
- 0
Tài liệu Lab 5.2.3 Configuring Frame-Relay Subinterfaces doc
Ngày tải lên :
11/12/2013, 14:15
... in a full-mesh Frame Relay network.
An Adtran Atlas550 Frame Relay emulator is used to simulate the switch /Frame Relay cloud.
Background/Preparation
Cable a network similar to the one in the ... PVC.
Step 8 Show the Frame Relay maps
a. Look at the frame relay maps by typing the command show frame- relay map at the privileged
exec mode prompt:
Amsterdam#show frame- relay map
b. What ...
Amsterdam(config-if)#encapsulation frame- relay ietf
Amsterdam(config-if) #frame- relay lmi-type ansi
b. Use a description field to store relevant information, such as the circuit number in case a line fault has
to be...
- 7
- 503
- 1
Tài liệu Lab 5.2.5 Configuring Frame Relay Subinterfaces pdf
Ngày tải lên :
11/12/2013, 14:15
... in a full-mesh Frame Relay network.
Background/Preparation
An Adtran Atlas550 Frame Relay emulator is used to simulate the Frame Relay switch/cloud.
Cable a network similar to the one in the ... PVC.
Step 8 Show the Frame Relay maps
a. Look at the frame relay maps by typing the command show frame- relay map at the privileged
EXEC mode prompt:
Amsterdam#show frame- relay map
b. What ...
Amsterdam(config-if)#encapsulation frame- relay ietf
Amsterdam(config-if) #frame- relay lmi-type ansi
b. Use a description field to store relevant information, such as the circuit number in case a line fault has
to be...
- 7
- 469
- 2
Tài liệu Cisco MPLS based VPNs: Equivalent to the security of Frame Relay and ATM docx
Ngày tải lên :
21/12/2013, 19:15
... MPLS based VPNs compare to Frame- Relay and ATM. Frame-
Relay and ATM are well known in the industry and have the reputation as being secure.
In order to consider MPLS-VPNs to be as secure as layer ... apply to customer networks as to the MPLS core. MPLS doesn’t
reveal additional unnecessary information even to customer VPNs. Since the interface to
the VPNs is BGP there is no need to reveal ... impossible to insert a ‘spoofed’ label into an MPLS network and thus gain
access to another VPN or the MPLS core. In this capability a MPLS based VPN provides
the same security as a Frame- Relay...
- 15
- 509
- 0
Tài liệu Lab Scenario 1 -- Frame Relay and OSPF pdf
Ngày tải lên :
24/01/2014, 19:20
... encapsulation frame- relay
clockrate 56000
frame- relay broadcast-queue 80 124000 64
frame- relay map ip 135.6.1.1 102 broadcast
frame- relay map ip 135.6.1.3 102 broadcast
no frame- relay inverse-arp
!
... Serial0
no ip address
encapsulation frame- relay
no frame- relay inverse-arp
!
interface Serial0.1 point- to -point
ip address 135.6.1.1 255.255.255.0
frame- relay interface-dlci 110
!
interface ... Wolsefer
Lab Scenario 1 Frame Relay and OSPF
Introduction
This lab is designed to be a build -to- specifications test. There are numerous issues that need to be addressed for this
lab to work correctly....
- 21
- 264
- 0
Báo cáo khoa học: Death inducer obliterator protein 1 in the context of DNA regulation Sequence analyses of distant homologues point to a novel functional role docx
Ngày tải lên :
07/03/2014, 21:20
... all appear to have a role in DNA regulation,
in the context of chromatin stability, and to form part
of higher complexes linked to active chromatin.
The DIDO1 gene has been linked to the split ... Suv39h histone methyltrans-
ferase, in which both deletion and overexpression lead
to alterations in pericentric chromatin, chromosome
missegregation in mitosis and meiosis, and apoptosis
[19,21].
Concluding ... distribution is
identical to that of the human trithorax protein, sug-
gesting that they may be components of a multimeric
complex analogous to the Saccharomyces histone-
methylating Set1 complex,...
- 7
- 658
- 0