low power vlsi design ppt
![Báo cáo Y học: Effect of adenosine 5¢-[b,c-imido]triphosphate on myosin head domain movements Saturation transfer EPR measurements without low-power phase setting ppt](https://media.store123doc.com/images/document/14/rc/vd/medium_vdd1395606111.jpg)
Báo cáo Y học: Effect of adenosine 5¢-[b,c-imido]triphosphate on myosin head domain movements Saturation transfer EPR measurements without low-power phase setting ppt
Ngày tải lên :
24/03/2014, 03:21
... with low concentration of spin labels should
be detected. At low concentration of spin labels where high
receiver gain is required to obtain a spectrum of good
quality, it is difficult to follow ... that at low microwave power the variance of the
EPR signal would be minimum over the whole field scan at
the out-of-phase setting, the correct phase angle can be
calculated from two high -power spectra ... nucleotide reported
disorder. The low- angle X-ray diffraction patterns were
modified by AdoPP[CH
2
]P in insect flight muscle; the ratio
of the two inner equatorial peaks was lowered when the
concentration...
- 10
- 563
- 0
Tài liệu Solutions for CMOS VLSI Design 4th Edition (Odd). ppt
Ngày tải lên :
19/02/2014, 15:20
... SOLUTIONS
9
4.11 D = N(GH)
1/N
+ P. Compare in a spreadsheet. Design (b) is fastest for H = 1 or 5.
Design (d) is fastest for H = 20 because it has a lower logical effort and more stages
to drive the ... of the internal nodes is guaranteed to be
high rather than low. Thus 11 + 2.5 = 13.5 units of capcitance are high and 5 units
are low, reducing the charge sharing noise to 13.5 / (13.5 + 5) ... 40960. The best
number of stages is log
4
F = 7.66, so try an 8-stage design: NAND3-INV-NAND2-
INV-NAND2-INV-INV-INV. This design has an actual logical effort of G = (5/3)
* (4/3) * (4/3) = 2.96,...
- 39
- 1.2K
- 5
CMOS VLSI Design - Lecture 1: Introduction ppt
Ngày tải lên :
19/03/2014, 10:20
... oxide
n well
n+n+
n+
p+p+p+
Contact
CMOS VLSI Design
4th Ed.
0: Introduction 40
Simplified Design Rules
Conservative rules to get you started
CMOS VLSI Design
4th Ed.
0: Introduction 6
nMOS ... CMOS VLSI Design
4th Ed.
0: Introduction 31
Polysilicon Patterning
Use same lithography process to pattern polysilicon
Polysilicon
p substrate
Thin gate oxide
Polysilicon
n well
CMOS VLSI Design ... substrate
CMOS VLSI Design
4th Ed.
0: Introduction 23
Oxidation
Grow SiO
2
on top of Si wafer
– 900 – 1200 C with H
2
O or O
2
in oxidation furnace
p substrate
SiO
2
CMOS VLSI Design
4th Ed.
0:...
- 43
- 503
- 0
CMOS VLSI Design - Lecture 6: Power potx
Ngày tải lên :
19/03/2014, 10:20
... in active mode
CMOS VLSI DesignCMOS VLSI Design
4th Ed.
7: Power 2
Outline
Power and Energy
Dynamic Power
Static Power
CMOS VLSI DesignCMOS VLSI Design
4th Ed.
7: Power 19
Voltage / Frequency
... block will be used
Lecture 6:
Power
CMOS VLSI DesignCMOS VLSI Design
4th Ed.
7: Power 15
Switching Probability
CMOS VLSI DesignCMOS VLSI Design
4th Ed.
7: Power 16
Example
A 4-input AND ... CMOS VLSI DesignCMOS VLSI Design
4th Ed.
7: Power 3
Power and Energy
Power is drawn from a voltage source attached to
the V
DD
pin(s) of a chip.
Instantaneous Power:
Energy:
Average Power:
()...
- 29
- 590
- 0
Báo cáo khoa học: "Crossed Serial Dependencies:i low-power parseable extension to GPSG" ppt
Ngày tải lên :
24/03/2014, 01:21
... each VP rule
which introduces a VP complement, allowing the verb
to be lowered onto the complement. As this rule
must also expand VPs with verbs lowered onto them,
we want e.g.
cii) vPlz -> ...
(I) will apply to all three of (B) - (D), allowing
compound verbs to be discharged at any point. (II)
will apply to (B) and (C), allowing the lowering
(with compounding if needed) of verbs ... Even in the weakest augmentation,
allowing only one occurence of one variable over
sequences in any constituent of any rule, the
apparent similarity of their power remains to be
formally established,...
- 6
- 261
- 0
ultra low-power electronics and design
Ngày tải lên :
01/06/2014, 11:43
... to proposals on other levels in the design flow and to future work.
Keywords: Low- power design, dynamic power reduction, leakage power reduction, ultra-
low- V
th
devices, multi-V
dd
, multi-V
th
, ... Pacific Design Automation Conference
2003, pp. 400-403.
[20] K. Usami, M. Horowitz, Clustered Voltage Scaling Technique for Low- Power Design,
Proceedings of the International Symposium on Low Power ...
dynamic power by 15% was achieved for a 0.18àm process technology.
Leakage power was reduced by 40%. As leakage power was more than
1000x smaller than dynamic power, overall active power reduction...
- 290
- 1.1K
- 0
A low power high dynamic range broadband variable gain amplifier for an ultra wideband receiver
Ngày tải lên :
06/11/2012, 10:26
...
obtain large variable gain ranges under low supply voltage.
II.2 Comparison of the commonly used VGA structures
The design requirements impose challenges on low power consumption, very
large bandwidth, ... suitable for low power applications.
(3) Summary of analog-multiplier-based VGA
In summary, the multiplier-based VGA has good linearity and large gain tuning
range, but it is not power efficient ...
generated by the subtraction between g
mp1
and g
mp2
. And hence, it is not suitable for low-
power VGA design.
II.1.3 Differential pair with source degeneration
Another commonly used VGA topology...
- 121
- 386
- 0
Tài liệu AISC-ASD89 Allowable Stress Design pptx
Ngày tải lên :
10/12/2013, 01:15
... KẾ THEO ỨNG SUẤT CHO PHÉP
AISC - ASD89
(American Institute of Steel Construction’s “Allowable Stress Design )
1.ỨNG SUẤT NÉN CHO PHÉP
F
a
≥ f
a
=
g
P
A
f
a
: Ứng suất nén do tải...
- 5
- 639
- 9
Tài liệu Advanced Flash Interface Design pptx
Ngày tải lên :
10/12/2013, 12:15
... would be hollow—and no one wants to eat a hollow cake!
Now let’s look at each of these layers in your design, starting with the innermost one.
Purpose
As advanced designers, we want our designs to ... your design.
Anyone who has experienced the critique can tell you that it can be the best or worst thing to happen
to a design. At worst, it can be a design- by-committee session, where your design ... this information into a creative /design brief is a good exercise for understanding the
project’s purpose. Creating a creative /design brief will also provide the nondesigner members of your
team...
- 368
- 384
- 1
Tài liệu Module 1: Introduction to Change and Configuration Management Design pptx
Ngày tải lên :
10/12/2013, 15:15
... Introduction to Change and Configuration Management Design
Completing the Design
Presenting the Final Design
Gain approval for the final design
Handing over for Implementation
*****************************
ILLEGAL ... USE
******************************
The last steps in the design process are to consolidate the results of the Proof of
Concept and Pilot Testing into a final design, and to present this final design for
formal acceptance ...
implementation.
Lead-in
The aim of the design
process is to produce a
design that fully meets the
organization's business
requirements and to have
the design accepted.
Module 1: Introduction...
- 48
- 902
- 2