0

fundamentals of wireless communication solution

Fundamentals of Wireless Communication

Fundamentals of Wireless Communication

Hóa học - Dầu khí

... hugemongous.46EE 290S: Fundamentals of Wireless Communication Course NotesU.C. Berkeley Fall 2002Instructor: David TseCo-written with: Pramod ViswanathSeptember 18, 2002fades of the channel (i.e. ... 1000 (30 dB). Stupendous amounts of power would be required formore reliable communication. Before we explore further the root cause of the poor performance of this detector,we note that there ... gain, there is a law of diminishing marginal return: as L increases, themarginal benefit decreases because of the law of large numbers, eventually convergingto the performance of the AWGN channel....
  • 20
  • 541
  • 0
Fundamentals of Wireless Communication doc

Fundamentals of Wireless Communication doc

Hóa học - Dầu khí

... Tradeoff2: The Wireless Channel Fundamentals of Wireless Communication, Tse&Viswanath Fundamentals of Wireless Communication David Tse232: The Wireless Channel Fundamentals of Wireless Communication, ... Wireless Channel Fundamentals of Wireless Communication, Tse&Viswanath2: The Wireless Channel Fundamentals of Wireless Communication, Tse&Viswanath2. The Wireless Channel72: The Wireless ... multipaths up to delays of 1/W . 2: The Wireless Channel Fundamentals of Wireless Communication, Tse&Viswanath1. Introduction102: The Wireless Channel Fundamentals of Wireless Communication, Tse&ViswanathWireless...
  • 30
  • 382
  • 0
Fundamentals of Wireless Communication potx

Fundamentals of Wireless Communication potx

Hóa học - Dầu khí

... Hz.•Primary driver behind wireless communication system design. Fundamentals of Wireless Communication David TseDept of EECSU.C. Berkeley Main story• Communication over a flat fading ... distance of the order of the carrier wavelength. This is 0.3 m for Ghz cellular. •For vehicular speeds, this translates to channel variation of the order of 100 Hz.•Primary driver behind wireless ... fading• Wireless communication typically happens at very high carrier frequency. (eg. fc = 900 MHz or 1.9 GHz for cellular)•Multipath fading due to constructive and destructive interference of...
  • 76
  • 824
  • 0
Identification of Research Needs Relating to Potential Biological or Adverse Health Effects of Wireless Communication pptx

Identification of Research Needs Relating to Potential Biological or Adverse Health Effects of Wireless Communication pptx

Quản trị mạng

... president of the National Academy of Sciences.The National Academy of Engineering was established in 1964, under the charter of the National Academy of Sciences, as a parallel organization of outstanding ... development of models of several heights for men, women, and chil-dren of various ages for use in the characterization of SAR distributions for exposures characteristic of cell phones, wireless ... development of models of several heights for men, women, and children of various ages for use in the characterization of SAR distributions for exposures characteristic of cell phones, wireless...
  • 79
  • 344
  • 0
Fundamentals-of-wimax-understanding-broadband-wireless-networking

Fundamentals-of-wimax-understanding-broadband-wireless-networking

Điện - Điện tử

... xxiiiAbout the Authors xxviiPart I Overview of WiMAX 1Chapter 1 Introduction to Broadband Wireless 31.1 Evolution of Broadband Wireless 51.1.1 Narrowband Wireless Local-Loop Systems 51.1.2 First-Generation ... Professor Robert Heath and Mr. Runhua Chenfrom the University of Texas at Austin. Both Professor Heath and Mr. Chen possess an incredi-ble degree of intuition and understanding in the area of ... comprehensive treatment of WiMAX.It should be of great interest.—Dr. Reinaldo Valenzuela, Director of Wireless Research, Bell Labs Fundamentals of WiMAX is a comprehensive guide to WiMAX from...
  • 478
  • 411
  • 2
Solutions Of Fundamentals of Modern Manufacturing pptx

Solutions Of Fundamentals of Modern Manufacturing pptx

Cao đẳng - Đại học

... by a shear stress of 10 Pa due to the viscosity of the fluid. Assuming that thevelocity gradient of the fluid is constant, determine the coefficient of viscosity of the fluid. Solution: Shear ... volumetric contraction of -2.5%, which means it expands during solidification.Express your answer in terms of millimeters of elongation per meter of length compared to astandard rule. Solution: For ... volume of casting, and A = surface area of casting.10.16 Identify the three sources of contraction in a metal casting after pouring. Answer. The three contractions occur due to: (1) contraction of...
  • 292
  • 513
  • 1
Fundamentals of Corporate Finance 8th edition: Solutions Manual

Fundamentals of Corporate Finance 8th edition: Solutions Manual

Cao đẳng - Đại học

... dark because of the costs of compliance. The costs to comply with Sarbox can be several million dollars, which can be a large percentage of a small firms profits. A major cost of going dark ... this: “A firm has estimated that the cost of improving the safety of one of its products is $30 million. However, the firm believes that improving the safety of the product will only save $20 million ... costs of raising funds in the public market. 5. The treasurer’s office and the controller’s office are the two primary organizational groups that report directly to the chief financial officer....
  • 399
  • 2,347
  • 30
fundamentals of heat and mass transfer solutions manual phần 2 docx

fundamentals of heat and mass transfer solutions manual phần 2 docx

Kĩ thuật Viễn thông

... and thermal conductivity of steel tubes. Temperature of steamflowing through the tubes. Thermal conductivity of insulation and emissivity of aluminum sheath.Temperature of ambient air and surroundings. ... C.=<COMMENTS: Use of the critical insulation thickness in lieu of a thin coating has the effect of reducing the maximum insulation temperature from 778.7°C to 318.2°C. Use of the critical insulationthickness ... rin,o up to a value of 13 mm (t = 12mm).COMMENTS: The contact resistance affects the temperature of the wire, and for g,maxqE′′=4.51W / m,= the outer surface temperature of the wire is Tw,o...
  • 220
  • 656
  • 4
fundamentals of heat and mass transfer solutions manual phần 3 pdf

fundamentals of heat and mass transfer solutions manual phần 3 pdf

Kĩ thuật Viễn thông

... as well as the rate of heat transfer by convection to the surface.COMMENTS: (1) Using the matrix-inversion method, the exact solution to the system of equations (1,2, 3) of part (a) is T1 ... guesses.(2) Note that the rate of heat transfer by convection to the top surface of the rod must balance the rate of heat transfer by conduction to the sides and bottom of the rod.NOTE TO INSTRUCTOR: ... m5,9.+−==(2)The system of 9 finite-difference equations is first written in the form of Eqs. (1) or (2) and thenwritten in explicit form for use with the Gauss-Seidel iteration method of solution; see...
  • 220
  • 1,261
  • 1
fundamentals of heat and mass transfer solutions manual phần 4 docx

fundamentals of heat and mass transfer solutions manual phần 4 docx

Kĩ thuật Viễn thông

... steady-state temperature.(2) Both the FEHT and IHT methods of solution give identical results. Their steady-state solutionsagree with the result of an energy balance on a time interval basis yielding ... form of the FDEs for theinterior nodes. Use space and time increments of 37.5 mm and 1.2 s, respectively, for a 17-nodenetwork. For the surface node 00, use the FDE derived in Section 2 of the ... exactanalytical solution. This difference represents an error of -1% ( -1 °C / (120 – 20 ) °C x 100). At thex = 150 mm location, the difference is about -0.4 °C, representing an error of –1.5%....
  • 220
  • 818
  • 0
fundamentals of heat and mass transfer solutions manual phần 5 ppsx

fundamentals of heat and mass transfer solutions manual phần 5 ppsx

Kĩ thuật Viễn thông

... and emissivity of Nichrome wire. Electricalcurrent. Temperature of air flow and surroundings. Velocity of air flow. (a) Surface and centerline temperatures of the wire, (b) Effect of flow velocity ... and thermal conductivity of steel pipe. Temperature of water flow inpipe. Temperature and velocity of air in cross flow over pipe. Cost of producing hot water. (a) Cost of daily heat loss from ... Time to come within 10°C of steady-state temperature, (c)Variation of power dissipation required to maintain a fixed heater temperature of 275°C over a range of velocities. Uniform heater...
  • 220
  • 629
  • 0
fundamentals of heat and mass transfer solutions manual phần 6 docx

fundamentals of heat and mass transfer solutions manual phần 6 docx

Kĩ thuật Viễn thông

... conductivity of steel pipe. Temperature and velocity of water flowin pipe. Temperature and velocity of air in cross flow over pipe. Cost of producing hot water.FIND: Daily cost of heat loss ... length. Pressure of saturated steam.FIND: Outlet temperature and pressure of air. Mass rate of steam condensation.SCHEMATIC:ASSUMPTIONS: (1) Steady-state, (2) Outer surface of annulus is adiabatic, ... the initial estimate of 325 K is reasonableand iteration is not necessary. (2) For a steam flow rate of 0.01 kg/s, approximately 10% of theoutflow would be in the form of saturated liquid,...
  • 220
  • 551
  • 0
fundamentals of heat and mass transfer solutions manual phần 7 pot

fundamentals of heat and mass transfer solutions manual phần 7 pot

Kĩ thuật Viễn thông

... room, per unit length of the tube; effect onquality, x, at outlet of 30 m length of tube; (b) Effect of radiation on heat transfer and quality of outletflow; (c) Effect of emissivity and insulation ... 9.72KNOWN: Velocity and temperature of air flowing through a duct of prescribed diameter. Temperature of duct surroundings. Thickness, thermal conductivity and emissivity of applied insulation.FIND: ... Analytical solution using average fin surface temperature of sT 125 C= to estimate the free convection and linearized radiation coefficients; comment on sensitivity of fin heat rate to choice of sT;...
  • 220
  • 1,164
  • 0

Xem thêm