0

electric motors and drives solutions manual

Electric motors and drives technical manual 2010 edition

Electric motors and drives technical manual 2010 edition

Cơ khí - Chế tạo máy

... class. Slip-ring motors, commutator motors and brake motors can all be made inflameproof versions.No external parts may cause sparks.The motors must have both an internal and an external earthing ... sets the standards. Or at least many countries basetheir standards very closely on the IEC standards (for example,Germany's VDE 0530 standard and Great Britain's BS 2613 Standardclosely ... though, the standards can be grouped into two majorcategories: NEMA and IEC (and its derivatives).In North America, the National Electric Manufacturers Association(NEMA) sets motor standards,...
  • 346
  • 485
  • 3
Elementary mechanics and thermodynamics SOLUTIONS MANUAL   j  norbury

Elementary mechanics and thermodynamics SOLUTIONS MANUAL j norbury

Vật lý

... heightH and inclined at an angle θ to the horizontal. At the bottom ofthe slope the surface changes to horizontal and has a coefficient ofkinetic friction µkbetween the horizontal surface and the ... = −GMmrwhere m is the massof the satellite and r = R + H.Conservation of energy isUi+ Ki= Uf+ KfTo escape to infinity then Uf= 0 and Kf= 0 (satellite is not movingif it just ... for the tensionin the string at the top and bottom of the circle.SOLUTIONTWWTR218 CHAPTER 2. VECTORS3. Two vectors are defined as u =ˆj +ˆk and v =ˆi +ˆj. Evaluate:A) u + vB)...
  • 112
  • 333
  • 0
Electric Machines and Drives Part 1 pot

Electric Machines and Drives Part 1 pot

Kĩ thuật Viễn thông

... Institute of Electrical and Electronics Engineers (IEEE) “Standard Test Procedure for Polyphase Induction Motors and Generators” IEEE 112-B and in its Canadian CSA 390 adaptation. The standard first ... Medium voltage motors • Repaired motors • TENV and TEAO enclosures It’s relevant to notice that regulation concerning single phase and three-phase small (42/48 and 56 frame) motors is ready, ... be obtained from orders@intechweb.org Electric Machines and Drives, Edited by Miroslav Chomat p. cm. ISBN 978-953-307-548-8 ELECTRIC MACHINES AND DRIVES Edited by Miroslav ChomatContentsVISwarm...
  • 20
  • 416
  • 0
Electric Machines and Drives Part 2 docx

Electric Machines and Drives Part 2 docx

Kĩ thuật Viễn thông

... Canada with the adoption of Standard CAN/CSA- Electric Machines and Drives 14 Fig. 7. Stator Premium motors Fig. 8. Rotor Premium motors Electric Machines and Drives 16 Fig. 11. ... incentives and voluntary measures for the energy efficiency of electric motors is not sufficient, as it is prerequisite to implement mandatory measures for Electric Machines and Drives 22 ... (2008a) “Barriers and incentive policies to high-efficiency motors and drives market penetration,”. IEEE International symposium on power electronics, electrical drives, automation and motion SPEEDAM...
  • 20
  • 292
  • 0
Electric Machines and Drives part 6 ppt

Electric Machines and Drives part 6 ppt

Kĩ thuật Viễn thông

... estimated speed and reference speed, (i.e.eω=ω−ωre f), a proportional integral compensation is proposed, as follows100 Electric Machines and Drives Electric Machines and Drives 90 ... jNωLmis+ Lrddtir+ Lmddtis(26)102 Electric Machines and Drives where Rs, Rr, Ls and Lrare the stator/rotor resistances and inductances, Lmis the magnetizinginductance, ... θ0sin θ0cos θ0 and K=23⎡⎢⎣1−12−120−√32−√32⎤⎥⎦.xqd and xαβstand for two-dimensional voltage flux and stator current vector, respectively on(q-d) and ( α-β)reference...
  • 20
  • 388
  • 0
Electric Machines and Drives part 7 ppt

Electric Machines and Drives part 7 ppt

Kĩ thuật Viễn thông

... desired torque, and will be taken as a simple PI controller. The reader isreferred to (1) for motivation and additional details on this control configuration.122 Electric Machines and Drives 0 10 ... variables1prime mover torque and speed, (τLG, ωG) ,and rotor and stator voltages and currents,(vrG, irG), (vsG, isG), respectively. The IM, on the otherhand, is a two–port system with ... infinite, and saturation, iron losses, end winding and slot effects are neglected. Only linear magnetic materials are considered, and it is furtherassumed that all parameters are constant and known....
  • 20
  • 351
  • 0
Electric Machines and Drives part 8 pdf

Electric Machines and Drives part 8 pdf

Kĩ thuật Viễn thông

... voltages vrGa and vrGb, the IM rotor speed ωmM and itsestimationˆωmM, the estimated IM load torqueˆτML, and the estimated IM speed, given by132 Electric Machines and Drives 52.6 52.65 ... à lacommande des systèmes électromécaniques,” PhD thesis, Université de Paris XI, France,2004.[5] W. Leonhard, “Control of electrical drives, ” Spring-Verlag, 1985.[6] M.S. Vicatos and J.A. ... 2002.[13] A. J. van der Schaft, “L2–Gain and Passivity Techniques in Nonlinear Control,”Springer–Verlag, Berlin, 1999.144 Electric Machines and Drives equation¯σq= LsqLrq− L2mq,¯σd=...
  • 20
  • 430
  • 0
Electric Machines and Drives part 9 potx

Electric Machines and Drives part 9 potx

Kĩ thuật Viễn thông

... in electric drives. The excellent characteristics of PSO may be successfully used to optimize the performance of electric machines and electric drives in many aspects. It is estimated that, electric ... 2009. IECON ’09. 35th AnnualConference of IEEE, pp. 1003 –1008.160 Electric Machines and Drives Electric Machines and Drives 168 Areall possible operatingconditions optimizedvarying ... 3. Motor parameter identified in simulation.154 Electric Machines and Drives Swarm Intelligence Based Controller for Electric Machines and Hybrid Electric Vehicles Applications 163 rMLlMLmqLlr+-(1/k)ωrλdr+-VqsrriqsiqrRqf...
  • 20
  • 312
  • 0
Electric Machines and Drives part 11 docx

Electric Machines and Drives part 11 docx

Kĩ thuật Viễn thông

... Electric Machines and Hybrid Electric Vehicles Applications 191 (a) The power sharing between FC and SC on NEDC driving cycle (b) The power sharing between FC and ... optimization (PSO) used to achieve the best performance for the electric machines and electric drives. In addition, by analyzing and comparing the results, it is shown that control strategy based ... voltages and currents under unbalanced voltage supply with reduced DC-link capacitance without compensation. Electric Machines and Drives 194 Sixth International Symposium on Micro Machine and...
  • 20
  • 317
  • 0
Tài liệu Manual for induction motors and generators ppt

Tài liệu Manual for induction motors and generators ppt

Điện - Điện tử

... each work site and safety instructions included in this manual and separate safety instructions delivered with the machine. Manual for Induction Motors and Generators 14 - Transport and Unpacking3BFP ... Prepare the delivered bolts and washers for installation. Manual for Induction Motors and GeneratorsSafety Instruction - 83BFP 000 050 R0101 REV C Manual for Induction Motors and GeneratorsSafety ... drive 21 Manual for Induction Motors and Generators 12 - Transport and Unpacking3BFP 000 050 R0101 REV C2.4 Checks upon arrival and unpacking2.4.1 Check upon arrivalThe machine and the package...
  • 146
  • 1,294
  • 0
Precluding and reducing solutions to credit risk at Quang Trung branch of Vietnam Bank of Investment and Development.doc

Precluding and reducing solutions to credit risk at Quang Trung branch of Vietnam Bank of Investment and Development.doc

Quản trị kinh doanh

... precluding and reducing credit risks helps the bank prevent and minimize damage, stabilize profit, maintain economic security, and maintain prestige and brand. In doing credit business, prestige and ... Coal Company in bridge and road constructing project.• Grow credit and keep the business safe and effective.Continue to solve overdue debts, restructure lending money and maintain overdue debts ... combined industry, are currency and credit center, and the level to encourage the development of the economy. Therefore, the quality and the growth level of the capital and capital lending activities...
  • 47
  • 892
  • 14
Working capital and some solutions to increasing capital in utilization at Petrolimex Asphalt commercial limited company

Working capital and some solutions to increasing capital in utilization at Petrolimex Asphalt commercial limited company

Quản trị kinh doanh

... activities.1.5.Working capital demand and the driving factors behind Working capital demand always changes and depend on many factors. In there, we need to care about following the fomula and the main factors ... better quality products more and more increasingly. In the context, quality and quantity are the main factors which can help the company to expand and affirm its brand. So, the Pham Thi Mai Huong ... the market and forcast business conditions frequently. Besides, find out about customer demand and competitior`s activities in domestic and foreign countries. Variety of allocating and selling...
  • 28
  • 819
  • 10
TYPHOONS AND TECHNICAL SOLUTIONS RECOMMENDED FOR EXISTING AND NEW HOUSES IN THE CYCLONIC REGIONS IN VIETNAM

TYPHOONS AND TECHNICAL SOLUTIONS RECOMMENDED FOR EXISTING AND NEW HOUSES IN THE CYCLONIC REGIONS IN VIETNAM

Kiến trúc - Xây dựng

... Typical evacuating building made by RC frames and slabs CONCRETE SLABS 1 TYPHOONS AND TECHNICAL SOLUTIONS RECOMMENDED FOR EXISTING AND NEW HOUSES IN THE CYCLONIC REGIONS IN VIETNAM ... prevention and mitigations. Keywords: Disaster mitigation; technical solutions; tropical cyclones; typhoons; and wind disasters. 1 Introduction In 1995, a design code TCVN 2737:1995 Loads and ... season is between September and November, and is the most intense in October and November. There are 1 to 2 typhoons hitting the region in a year. The typhoon density and the percentage of strong...
  • 12
  • 584
  • 0
Working capital and some solutions to increasing capital in utilization  at Petrolimex Asphalt commercial limited company

Working capital and some solutions to increasing capital in utilization at Petrolimex Asphalt commercial limited company

Kinh tế - Thương mại

... namely : In 2006, business capital 954.698.725 thousand dongs. Its value growed 199.592.549 thousand dongs and present at 1.154.291.274 thousand dongs. It increased relatively of high speed, equivalent ... fluctuations of goods and material costs which are being used in produce and business of the enterprises.+ The gap between enterprises and selling market .+ Conditions and means of transportation ... Working capital’s structure and driving factors behind 41.1.4. Working capital resources 41.1.5.Working capital demand and the driving factors behind 5 1.2. Working capital and its importance in...
  • 37
  • 635
  • 8
LoopStar®700 Next Generation Ethernet Access and Transport Solutions

LoopStar®700 Next Generation Ethernet Access and Transport Solutions

Phần cứng

... Transport Solutions Why LoopStar 700?LoopStar®700Next Generation Ethernet Access and Transport Solutions This 4-slot product is optimized for largercustomers, multi-tenant buildings and serviceaggregation ... required.LoopStar 722Mix of expandable and fixed ports scales from small to large customer sitesLOOPSTAR®700Next Generation Ethernet Access and Transport Solutions The NEBS 3 certified ... next-generation solutions of a packet-basednetwork.LoopStar 745 and LoopStar 745PHigher speed Ethernet and multi-services over DS3With two customer-facing 10/100Base-TEthernet ports and four or...
  • 8
  • 338
  • 0

Xem thêm