... hydriding/dehydriding reaction and per mole of hydrogen gas for LaNi5 is about 30.8 kJ The knowledge of △H is important for the heat management required in practical engineering application The total volume of hydride ... requirements of metal hydride materials in storage capacity and kinetic behavior, the strict demands also put on the reactor design There are four major concerns of the design of metal hydride reactor, ... issues from the hydride formation/ decomposition reaction accompanied with release/uptake of heat can be improved The parts of the scroll reactor are shown in Figure The hydrogen storage canister comprises...
... prioritized With effort in reducing the on-state voltage, a saturation voltage of 1.54 V has been achieved Application to wind power system The suggested conversion system using MERS for wind power ... estimations indicate total active rectifier losses including filter of around 1%[4][5] The losses of the MERS system are significantly lower than that for the active rectifier system Relative rating ... demonstrates and verifies the performance of the suggested system Numerical investigations of large scale system indicate significant potentials for loss reductions and reductions of needed power electronics...
... management ofenergystorage DC nano -grid for micro -grid application is studied in Chapter • Dynamic power management ofenergystorage DC nano -grid: The dynamic power management ofenergystorage ... compensated by energystorage nano -grid • Energy management ofenergystorage DC nano -grid in residential micro -grid Chapter studies the energy management for DC nano -grid ofenergystorage devices ... incorporates only energystorage technology, to form a batteryenergystorage system, or a flywheel energystorage system, and so on However, because use of one storage technology has the drawbacks of being...
... prediction of the lead-acid battery state of charge during operation Fendri and Chaabene [29] proposed dynamic recursive estimation Kalman filter algorithms However, performance of a dynamicmodelling ... and accuracy in a gasification process with large delays and changing operating conditions In order to guarantee prediction accuracy for changing operating conditions a dynamicmodelling approach ... incorporate the dynamic behaviour (delays) of the process (instead of using a dynamic neural network modelling approach) A detailed description of the data analysis and motivation for this particular...
... Therefore, this study was conducted with the following objective: (1) the long term performance of demonstration system treatment of village sewage (2) the performance of demonstration systems ... removal rate (%) 80.6 89.9 85.1 85.1 Note: the number of available sample is 80 Removal performance of constructed wetland systemfor storm runoff It entered into the rain season after June A storm ... Ecological pond Free-water surface CW Subsurface CW Fig.1 The flow chart of constructed wetland system First, Sewage was distributed evenly to the free-water surface constructed wetland through...
... operator in term of the sense of touch 2.2 Feedback force implementation: According to previous research [9], [10], the steering systemof forklifts is developed Moreover, driving torque of forklift ... interface for the OBW system Force gain is used to give adjustable feedback torque This is essential because of the variety of human sensitivity As the force gain increasing, the feedback force ... controllability Therefore, they achieved more accuracy of performances The error is rapidly decreased from 20cm to 2cm in the case of the first subject For the second subject, the errors of two modes...
... operator in term of the sense of touch 2.2 Feedback force implementation: According to previous research [9], [10], the steering systemof forklifts is developed Moreover, driving torque of forklift ... interface for the OBW system Force gain is used to give adjustable feedback torque This is essential because of the variety of human sensitivity As the force gain increasing, the feedback force ... controllability Therefore, they achieved more accuracy of performances The error is rapidly decreased from 20cm to 2cm in the case of the first subject For the second subject, the errors of two modes...
... operator in term of the sense of touch 2.2 Feedback force implementation: According to previous research [9], [10], the steering systemof forklifts is developed Moreover, driving torque of forklift ... interface for the OBW system Force gain is used to give adjustable feedback torque This is essential because of the variety of human sensitivity As the force gain increasing, the feedback force ... controllability Therefore, they achieved more accuracy of performances The error is rapidly decreased from 20cm to 2cm in the case of the first subject For the second subject, the errors of two modes...
... Labview [9] The diagram of the system is feature in Fig and Fig gives the interface of the software Signal Pre-amplifier Fig Program interface Fig The schematic diagram of a dual-phase lock-in ... the amplitude of the signal without noise is Vs = 0.495 V After the incorporation of noise (white noise), the maximal amplitude of the noise is 2.5 V, we received the signal of the form showed ... shows the constancy of the output dc-voltage (Vs = 0.495 V) when the amplitude of noise reaches 5V Similarly, we record the dependence of the phase shift on the amplitude of noise in Fig.9 If...
... preserve waveform integrity and device stability when driving the reactive elements of a long run of coaxial cable SIGNAL RESOLUTION To establish resolution, accuracy, and repeatability of measurements ... minute, this level of drift would not be significant The horizontal bands evident in Figure are an artefact of the lower limit of resolution (100 μV) achievable from the data acquisition system used ... and hold facility which, in the case of a hand-held instrument, allows for a “snapshot” of the data stream to be made manually at a time chosen by the operator Use of this additional facility does...
... × binary matrix M Each p,r row of M is transformed by Rotate Xi , and then each colq,s umn of the resulting matrix is transformed by Rotate Y j In each row or column transformation, the mapping ... transmission applications The proposed signal security system is suitable for both software and hardware implementation depending on the requirement of applications In the multimedia applications ... transformation belongs to the type of value transformation and the column transformation makes the position permutation in each bit-plane Hence, the TDCEA belongs to the type of combination-form...
... confounding factors that affect the long-term outcomes A staging system should be capable of accounting for these factors and the most important drawback of the TNM-7 staging system is the lack of incorporation ... Abstract Background: The aim of this study was to assess the validity of the 7th edition of the American Joint Committee on Cancer (AJCC) TNM system (TNM-7) for patients undergoing hepatectomy for ... well-stratified according to the TNM-7 classification [24] The present study, which addresses the pros and cons of the TNM-7 systemfor resectable HCC, reveals that the accuracy of stratification is lost for...
... Coefficient of variation Operation cost ofstorage charging ($/MWh) Operation cost ofstorage discharging ($/MWh) Capital cost ofstorageenergy capacity ($/MWh) Cost coefficient ofstorageenergy capacity ... ofstorage power capacity ($/MW) Cost coefficient ofstorage power capacity ($/MW/day) Vector of peak loads of buses (MW) Initial storage level (MWh), in storage operation problem Energy capacity ... up Ratio of used energy to reserved energyfor regulation down Sampled state ofsystem load demand level (MW) Power capacity ofstorage (MW), in storage operation problem Probability of a scenario...
... bake/chill systemfor microlithography process using a stream of air is introduced This system has the ability to deliver uniform temperature distribution across the wafer surface and to achieve ... called the soft bake The purpose of the soft bake is to evaporate a portion of the solvent in the photoresist The principal role of the solvents is to allow the application of a thin layer of resist ... purpose of the hard bake is the same as that of soft bake: the evaporation of solvents to harden the resist and to achieve good adhesion of the resist to the wafer surface [9] As in the soft bake,...
... machining Fm minor acting force from piezoelectric actuator FN force reading from force transducer z1 displacement of force transducer z2 displacement of flexure structure and piezoelectric actuator ... cutting force and depth of cut 143 Figure 99: Radial cutting force for four squares-surface 144 Figure 100: Machined surface profile for (a) sine wave-surface, (b) square wavesurface, and ... machine tool axis for workpiece surface Z machine tool axis for translational slide C machine tool axis for air-bearing spindle W machine tool axis for Hybrid Fine Tool Servo z flexure displacement...
... in terms of the design strategies for the scale-up and feasibility of the operation of transducers at higher levels of power dissipation, before successful application of sonochemical reactors ... enhance the reactivity of a catalyst by enlarging the surface area or accelerate a reaction by proper mixing of the reagents The chemical effects of ultrasound that could enhance reaction rates ... COMBINATION OFADVANCED OXIDATION PROCESSES WITH ULTRASONICATION FOR REMOVAL OF ORANGE G HU HONGQIANG A THESIS SUBMITTED FOR THE DEGREE OF MASTER OF ENGINEERING DEPARTMENT OF CHEMICAL AND...
... Paclitaxel Local Implants for Paclitaxel Delivery Evaluation of Paclitaxel Foams for local implants 11 3.1 Materials and Methods 3.1.1 Paclitaxel Foam Formulations 3.1.2 In vitro release of Paclitaxel ... control of the rate of polymer degradation can be achieved thereby changing rate of release of the drug Our study focuses on developing controlled releases implants in the form of discs for Paclitaxel ... step-by-step approach in the analysis of the use of foams for controlled release of Paclitaxel as implants within the brain for the post-surgical treatment of glioblastoma multiforme through combining...
... evaluation of the different types ofenergy scavenging system such as energy extraction from solar and thermal energy sources for wireless sensor nodes used for condition monitoring applications ... storage facilities of the extracted electrical energy 1.2 Literature review Various types of renewal energy sources such as solar, thermal, etc can be investigated for powering the portable systems ... Page of the overall energy harvesting system The proposed method also ensures high performance control of the power converter circuit with adequate band of accuracy An efficient thermal energy...
... Introduction Background of the research Significance of the research Objectives of the research Scope of the research Background of the research Base on the practice of learning translation ... interpretation in SOFL Lack of studies and researches on the issue of translating terms in politics 6 Significance of the research Providing knowledge of the British political system reading, ... and more precise www.egrid tut.edu.vn OBJECTIVES OF THE RESEARCH building up a list of terms relating to political systemof Britain SCOPE OF THE RESEARCH British political system political parties...
... weight-age of each criterion is determined by AHP method (stated earlier) Application of AHP method in selecting the weight-age of each criterion is shown separately (stated earlier) The performance of ... Manufacturing Research: An Open Access Journal 325 that may not be machined by the conventional machining processes, where the materials are removed from the work-piece surface in the form of chips ... measured for every decision alternative Objective outcomes provide the basis of comparison of choices and consequently facilitate the selection of the best (satisfactory) choice Therefore, multiobjective...