disease gene target network based studies to identify targets and pathways affected by tcm drugs and to obtain fuller pictures of the efficacy and mechanisms of action of tcm drugs
... of macrostructures such as the size and shape ofthe sample and notch from which the fracture is initiated, also influence the formation ofthe fracture surface, due tothe type of test andthe ... property ofthe eigenfunctions (12) directly follows ˆ from the symmetry (5) ofthe operator N(r) The idea ofthe proof [28] consists in the following Integrating by parts an average ofthe weighted ... (28) by analogy with equation (13), i.e approximating tothe geometric extension ofthe object bythe number of boxes (of the same size) necessary to recover it But, since the definition of the...
... come together to create the framework andthe pore The structural and synthetic factors that affect the formation of these small structural units may have a substantial effect on the creation of ... the synthesis ofthe pure polymorph C of zeolite beta (BEC) even in the absence ofthe fluoride medium that is generally believed to assist in the formation of D4R units [42] Both ITQ-7 andthe ... These deviations tend to lower the thermal stability of extra-large pore phosphates On the other hand, it is often because of these deviations that extra-large pores are formed The first synthetic...
... come together to create the framework andthe pore The structural and synthetic factors that affect the formation of these small structural units may have a substantial effect on the creation of ... the synthesis ofthe pure polymorph C of zeolite beta (BEC) even in the absence ofthe fluoride medium that is generally believed to assist in the formation of D4R units [42] Both ITQ-7 andthe ... These deviations tend to lower the thermal stability of extra-large pore phosphates On the other hand, it is often because of these deviations that extra-large pores are formed The first synthetic...
... depth of cut, tool edge preparation, tool nose radius and tool wear) andthe magnitude andthe entire profile of stresses In general these variables depend on the thermoplastic deformation ofthe ... transformed into final sharp individual peaks from the side ofthe trailing edge by copying the notch grooves The contact area between the worn PCBN tool, the workpiece andthe chip is divided into five ... hmin On the other hand, it may also originate from the flowing of plastified material through the worn trailing edge tothe side ofthe tool [19] This causes substantial deterioration ofthe surface...
... overload Q on the top ofthe grains will hardly affect the apparent mass at the bottom The top ofthe silo is ‘screened’ bythe walls andthe bottom feels only what is just above it For silos of smaller ... pressure profile p(r ) at the bottom of a sand pile [375] h and φ are the height andthe repose angle ofthe pile r is the horizontal distance from the centre ofthe pile tothe pressure gauge 1.0 ... progressively saturates to a value corresponding tothe grains in the bottom region ofthe column, i.e up to a height ofthe order of its diameter The rest is screened or supported bythe walls As a consequence,...
... in thermodynamics, the sand will possess an entropy which is the logarithm ofthe number of ways the N grains of sand will fit into the volume V , that is, the conventional expression for the ... from the centroid of grain g tothe centroid of void loop l (see Fig 13.5), R gl = ρ l − ρ g (13.38) The vectors R gl also form a network that spans the system and this network is the dual ofthe ... determine the pressure at the bottom Without knowledge ofthe formation history only a detailed tomography ofthe individual grains can help the investigator This is usually the situation in the systems...
... thought of as the absence of a plane of atoms (intrinsic stacking faults) or the insertion of rows of atoms that disturb the arrangement of atoms (extrinsic stacking faults) Intrinsic and extrinsic ... Nucleation and Growth The random motion of atoms and vacancies in solids, liquids, and gases are associated with atomic collisions that may give rise tothe formation of small embryos or clusters of atoms, ... due to atomic vibrations Nevertheless, the average energy ofthe vibrating atoms in a solid is given by statistical mechanics to be 3kT at any given time This may be sufficient to promote the...
... bythe reciprocals ofthe intercepts on the a1 , a2 , a3 and c axes As before, the intercepts are multiplied by appropriate scaling factors toobtainthe smallest possible integer values ofthe ... atom in the graphite structure is surrounded by three near neighbors However, the orientations ofthe near neighbors to atoms A and B are different Atoms similar to A are found at N and Q, and ... 1.10(c)] The sides ofthe unit parallelepiped also correspond tothe cartesian x, y, z axes, andthe angles , , are the axial angles The arrangement of atoms may therefore be described by a threedimensional...
... with the purchase Check ofthe commodity Thereby is to be paid attention tothe following points: Identity, quantity, damage ofthe packing, endangerment ofthe environment or the coworker bythe ... transferred bythe driver is compared with the specification ofthe PPS for this order, in order to control the identity ofthe product andthe delivery volume For problems consultation is to be held ... designation one applies Store the goods are properly stored, i.e according to their relevant request It is to be made certain that bythe storage the bundles are not damaged or the raw material damage...
... 15% c inadequate to improve reading skills: 40% d monotonous: 30% 40% > + ) $ $ B a various: 13% 13% 29% b useful: 12% 12% c inadequate to improve reading skills: 46% d monotonous: 29% 46% &; ... c difficult: 10% d relevant: 25% e others: 10% 25% 40% 10% ) > 23% ) 0% 9% a interesting: 9% b boring: 48% c difficult: 20% d relevant: 23% 20% )&> 48% e others: 0% ) A , ) / / * 9A!R< 9A?R
... mechanics of composite materials the tow, namely the K-number that gives the number of fibers in the tow (e.g., 3K tow contains 3000 fibers) andthe tex-number which is the mass in grams of 1000 m ofthe ... mechanics of composite materials where is the elongation ofthe bar corresponding to point ofthe curve The work W is equal to elastic energy ofthe bar which is proportional tothe bar’s volume and ... controlled bythe matrix to a considerably larger extent, though the fibers still provide the major contribution tothe strength and stiffness ofthe material The next step in the development of composite...
... moving the curet in a coronal direction Such a technique causes the curet to slide over the margins ofthe restoration and could result in parts ofthe restoration being torn off andthe restoration, ... upper tooth arch The photographer stands in front ofthe patient and indirectly photographs the tooth arch ofthe lowerjaw using the mirror 35-mm Photo Systems and APS System For intraoral photography-macrophotography-SLR ... now offer printouts ofthe oral conditions displayed on the monitor These printouts can be given tothe patient to be take home, thus facilitating the decision as to whether or not to execute the...
... indicators ofthe oral health status of children in Medicaid, specifically, the rate of dental diseaseand their receipt of dental care, and changes in these indicators over time.3 To determine the ... estimate to be about 15 percent ofthe total At the same time, indicators of receipt of dental care, including the proportion of children who had received dental care in the past year and use of sealants, ... infection, and tooth loss Bacteria Abscess How can tooth decay lead to death? Infected areas Untreated tooth decay can penetrate the tooth surface, allowing bacteria to infect the interior ofthe tooth,...
... further double bonds of other molecules A chain of carbon atoms is formed, in which each atom is linked by a single bond to two other carbon atoms along the chain The remaining valencies ofthe ... perpendicular tothe applied force, the surface traction is a vector in the direction ofthe force with magnitude If the cutting plane is parallel tothe force vector, the surface traction vanishes ... or acute The rotation ofthe edge parallel tothe x1 axis andofthe other edge both contribute to this angular change (cf gure 2.5) For small rotations and in the limit x1 and x2 0, the resulting...
... bythe reciprocals ofthe intercepts on the a1 , a2 , a3 and c axes As before, the intercepts are multiplied by appropriate scaling factors toobtainthe smallest possible integer values ofthe ... atom in the graphite structure is surrounded by three near neighbors However, the orientations ofthe near neighbors to atoms A and B are different Atoms similar to A are found at N and Q, and ... 1.10(c)] The sides ofthe unit parallelepiped also correspond tothe cartesian x, y, z axes, andthe angles , , are the axial angles The arrangement of atoms may therefore be described by a threedimensional...
... modelling at the microscopic level — the level of atoms and molecules — and aims to give a survey ofthe state -of- the- art ofthe application of both interatomic potential -based and quantum mechanical ... atom by atom using the algorithm of Rosenbluth and Rosenbluth [21] During the growing of an atom several trial positions are probed; of each of these positions the energy is calculated, andthe ... characterisation of any hypothetical zeolite must therefore include an analysis of framework topology andofthe types of building unit present, as well as some estimate ofthe thermodynamic stability of the...
... formed by two positive semi-axes on the ε y plane andthe graph ofthe latter one by negative and positive semi-axes on the σ y plane (Fig 2.2) Both of them can be obtained by passage tothe limit ... andthe stage of plastic flow up tothe destruction In compression there are the stages of elastic and plastic deformation of skeleton until the collapse of pores andthe subsequent stage of elastic ... – the matrices by bold font like A, B, Q; • the maps of vector spaces onto vector sets are denoted by bold font like π , ; • the spaces and special sets of vectors and functions are denoted by...
... difference in the results for the cases ofthe linear-elastic model andthe nonlinear model The horizontal displacement ofthe top ofthe frame andthe stress in the vertical reinforcement ofthe column ... horizontal displacement ofthe top ofthe frame is shown in Fig 27a, the state of cracks in Fig 27b, andthe reinforcement stress at the bottom ofthe column before collapse in Fig 27c The structure behaviour ... effect on the quality of masonry structures The limit strength capacity and deformability ofthe masonry wall is affectedbythe quality ofthe bonds between the masonry unit and mortar, i.e the level...
... descriptions of properties and their measurement (the contents ofthe volumes andthe contributors are given in the following pages) In many instances the data in these volumes have been reformatted and ... sources ofthe data are included throughout The objective ofthe handbook is to provide a convenient, reliable source of information on the properties of optical materials Data in a handbook of optical ... directions of vibration and in which the angle between the vibration directions and ray path may not always be 90° The index of refraction of such crystals varies according tothe vibration direction of...
... composition ofthe precursors must be appropriated to that ofthe target- materials In addition, the concentration ofthe precursors seems to play a role on the control ofthe shape of nanocrystallites ... concentration ofthe precursors The interactions between reagents and solvent play an important role in the solvothermal reactions The selection ofthe solvent plays a key-role through the control ofthe ... geometry and can be incorporated into the structure ofthe final material This type of solvothermal reactions has led tothe synthesis of Sb(III) and Sb(V) thioantimonates [Mn(en)3]2Sb2S5 and [Ni(en)3(Hen)]SbS4...