design signal conditioning circuit
Introduction to Digital Signal Processing and Filter Design
Ngày tải lên :
13/09/2012, 10:21
... are the advantages of digital signal processing instead
of analog signal processing, even though digital signal processing requires more
circuits compared to analog signal processing?
x(n)
y(n)
z
−1
z
−1
z
−1
ΣΣ
Σ
Σ
Figure ... so that it can be considered a bandlimited signal. It is this signal that
is sampled and converted to a discrete-time signal and coded to a digital signal
by the analog-to-digital converter (ADC) ... discrete-time signal as the input to the digital filter
designed in such a way that it improves the information contained in the original
analog signal or its equivalent discrete-time signal generated...
- 440
- 1K
- 4
Fundamentals of RF Circuit Design With Low Noise Oscillators
Ngày tải lên :
08/04/2013, 10:50
... amplifier design and includes
Load Pull measurement and design techniques and a more analytic design example
of a broadband, efficient amplifier operating from 130 to 180 MHz. The design
example ... of the basic building blocks
used in RF circuit design both at the component and intermediate block level. At
block level this includes low noise small signal amplifiers, both narrowband and
broadband, ... Attenuators (Pads) 92
2.9 Questions 93
2.10 Bibliography 96
3 Small Signal Amplifier Design and Measurement 97
3.1 Introduction 97
3.2 Amplifier Design Using Admittance Parameters 98
3.2.1 Stability 99
3.2.2...
- 308
- 698
- 6
Introduction to Digital Signal Processing and Filter Design - Introduction
Ngày tải lên :
29/09/2013, 21:20
... signals were con-
verted to sampled data signals by these filters and the signal processing was
treated as analog signal processing. But later, the signals were transitioned as
discrete-time signals, ... called the digital signal. Although there is a difference between
the discrete-time signal and digital signal, in the next few chapters we assume
that the signals are discrete-time signals and in ... digital signal processing is restricted to approximately one megahertz,
and analog signal processors are necessary for processing signals above that
frequency, for example, processing of radar signals....
- 31
- 638
- 0
Allen and Holberg - CMOS Analog Circuit Design
Ngày tải lên :
18/10/2013, 12:15
... E
2
max
Allen and Holberg - CMOS Analog Circuit Design Page II.0-3
OBJECTIVE
• Provide an understanding of CMOS technology sufficient to enhance
circuit design.
• Characterize passive components ... Holberg - CMOS Analog Circuit Design II.5-6
IMPROVED LAYOUT METHODS FOR CAPACITORS
Corner clipping:
Clip
corners
Street-effect compensation:
Allen and Holberg - CMOS Analog Circuit Design Page II.1-6
Etching
Etching ... (enhancement)
Allen and Holberg - CMOS Analog Circuit Design Page I.2-1
I.1 - INTRODUCTION
GLOBAL OBJECTIVES
• Teach the analysis, modeling, simulation, and design of analog circuits
implemented in CMOS technology.
•...
- 477
- 543
- 0
Theory and Design of Electrical and Electronic Circuits
Ngày tải lên :
23/10/2013, 16:15
...
Generalities
Q- meter
Design of inductors
Oneloop
Solenoidal onelayer
Toroidal onelayer
Solenoidal multilayer
Design of inductors with nucleus of ferrite
Shield to solenoidal multilayer inductors
Design
Choke ... E
yenpico(0)
e
-γx
= E
yenpico(0)
e
x(σωµ /2)1/2
e j
x(σωµ /2)1/2
Theory and Design of
Electrical and Electronic Circuits
Index
Introduction
Chap. 01 Generalities
Chap. 02 Polarization ... For this reason we have the series of following
equations of design finally
Chap. 05 Transformers of small value
Generalities
Designe of transformers
Solenoidal onelayer
Solenoidal multilayer
...
- 493
- 797
- 6
Real-Time Digital Signal Processing - Chapter 5: Design and Implementation of FIR Filters
Ngày tải lên :
23/10/2013, 22:15
... By
using a software signal generator, we can produce the exact same signals repeatedly
during the debug and analysis processes. Table 5.1 lists the example of sinusoid signal
generator, signal_ gen.c ... percentage of the
214
DESIGN AND IMPLEMENTATION OF FIR FILTERS
5
Design and Implementation
of FIR Filters
A filter is a system that is designed to alter the spectral content of input signals in
a specified ... functions available in the MATLAB Signal Processing Toolbox,
fir1 and fir2, can be used in the design of FIR filters using windowed Fourier series
method. The function fir1 designs windowed linear-phase...
- 59
- 590
- 0
Electronics - Theory and Design of Electrical and Electronic Circuits
Ngày tải lên :
27/10/2013, 16:15
...
Equivalent circuit of a transformer
Equivalent circuit of a inductor
Measurement of the characteristics
Transformer of alimentation
Design
Transformer of audiofrecuency
Transformer of pulses
Design
Inductors ... transistor of junction (TBJ)
Theory
Design
Fast design
Unipolar transistor of junction (JFET)
Theory
Design
Operational Amplifier of Voltage (AOV)
Theory
Design
_________________________________________________________________________________
...
Generalities
Q- meter
Design of inductors
Oneloop
Solenoidal onelayer
Toroidal onelayer
Solenoidal multilayer
Design of inductors with nucleus of ferrite
Shield to solenoidal multilayer inductors
Design
Choke...
- 493
- 734
- 2
Real-Time Digital Signal Processing - Chapter 6: Design and Implementation of IIR Filters
Ngày tải lên :
28/10/2013, 05:15
... iir.c, epx6a.c, signal_ gen2.c and sine.asm to the project.
The lowpass filter iir()will attenuate high-frequency components from the input
signal generated by the signal generator signal_ gen2(), ... and signal buffers, respectively.
The C function exp6a.c used for Experiment 6A is listed in Table 6.3. This program
calls the software signal generator signal_ gen2()to create a block of signal ... *);
/*Software signal generator */
extern void signal_ gen2(int *, int);
void main(void)
{
int i;
/*Initialize IIR filter signal buffer */
for(i = 0; i < Ns*2;i)
w[i]= 0;
/*IIR filtering */
for(;;)
{
signal_ gen2(in,...
- 62
- 721
- 0
Tài liệu PRINCIPLES OF ASYNCHRONOUS CIRCUIT DESIGN – A Systems Perspective pdf
Ngày tải lên :
09/12/2013, 21:15
... asynchronous circuits?
Most digital circuits designed and fabricated today are “synchronous”. In
essence, they are based on two fundamental assumptions that greatly simplify
their design: (1) all signals ... clock signal distributed throughout
the circuit.
Asynchronous circuits are fundamentally different; they also assume bi-
nary signals, but there is no common and discrete time. Instead the circuits
use ... DQIF, through physical design and characterisation of
the core blocks
Low-power RF design techniques in standard CMOS digital processes
RF design tools and framework; PAPRICA Design Kit
Demonstration...
- 354
- 650
- 1
Tài liệu Circuit design with VHDL ppt
Ngày tải lên :
12/12/2013, 11:16
... 0) OF STD_LOGIC;
2D array
SIGNAL x: row;
SIGNAL y: array1;
SIGNAL v: array2;
SIGNAL w: array3;
32 Chapter 3
TLFeBOOK
TLFeBOOK
x<='1';
x is a single-bit signal (as specified above), ... 23
TLFeBOOK
ENTITY entity_name IS
PORT (
port_name : signal_ mode signal_ type;
port_name : signal_ mode signal_ type;
);
END entity_name;
The mode of the signal can be IN, OUT, INOUT, or BUFFER. As illustrated ... ‘1’).
Examples:
SIGNAL x: BIT;
x is declared as a one-digit signal of type BIT.
SIGNAL y: BIT_VECTOR (3 DOWNTO 0);
y is a 4-bit vector, with the leftmost bit being the MSB.
SIGNAL w: BIT_VECTOR...
- 376
- 504
- 3
Tài liệu Integrated Circuits A Design Perspective pptx
Ngày tải lên :
23/12/2013, 03:16
... Digital Integrated Circuits
2nd
Introduction
Design Abstraction Levels
Design Abstraction Levels
n+n+
S
G
D
+
DEVICE
CIRCUIT
GATE
MODULE
SYSTEM
EE141
3
© Digital Integrated Circuits
2nd
Introduction
Digital ... Integrated Circuits
2nd
Introduction
The First Integrated Circuits
The First Integrated Circuits
Bipolar logic
1960’s
ECL 3-input Gate
Motorola 1966
EE141
7
© Digital Integrated Circuits
2nd
Introduction
The ... 0”
V
OL
V
IL
V
IH
V
OH
Undefined
Region
“ 1”
EE141
26
© Digital Integrated Circuits
2nd
Introduction
Design Metrics
Design Metrics
How to evaluate performance of a
digital circuit (gate, block, …)?
Cost
Reliability
Scalability
Speed...
- 51
- 458
- 2
Ebook - Radio frequency integrated circuit design
Ngày tải lên :
09/01/2014, 02:17
... simple circuits to
minimize circuit area, but also low power dissipation to maximize battery life.
1.2 Lower Frequency Analog Design and Microwave Design
Versus Radio Frequency Integrated Circuit Design
RFIC ... xix
1 Introduction to Communications Circuits 1
1.1 Introduction 1
1.2 Lower Frequency Analog Design and Microwave
Design Versus Radio Frequency Integrated
Circuit Design 2
1.2.1 Impedance Levels ... Frequency Integrated Circuit Design
- 431
- 420
- 0
