... resolution: 102 4 x 768 (24-bit color) * Compatible with: Windows XP/ Vista and (32/64-bits) * Multilingual: English, Spanish, French, Italian, German, Chinese, Janapense, Netherlands, Russian and Polish ... from HDV, AVCHD, Blu-ray Disc and JVC HD camcorders New! Save videos as HD MPEG-4 files for the Web with H.264 compression New! Output HD movies on either DVD, or Blu-ray Disc with BD-J activation ... PSP and other mobile devices Minimum System Requirements 1 .5 GHz processor (2 GHz or higher recommended) GB of RAM (2 GB or higher recommended) GB of free hard drive space Minimum display resolution:...
... Front tires 255 /55 R18 H XL RSC 255 /55 R18 H XL RSC Rear tires 255 /55 R18 H XL RSC 255 /55 R18 H XL RSC Front rims 8.5J x 18 LM 8.5J x 18 LM Rear rims 8.5J x 18 LM 8.5J x 18 LM Battery/location Ah ... awaiting the successor to the E53 The E70 marks the second generation of the X5 and includes many new features and functions not available in the previous X5 As one would expect, the new E70 raises the ... as the tailgate on the E53 However, the wedge system is different from that of the E53 This wedge system was copied from the E61 and must be adjusted correctly It is important to note that there...
... engage The slides (6 and 7) are displaced to the right by the rotational movement of the locking hooks The movement is limited by the damper and at the same time noise is minimized at the stop The ... interlock (3) is pressed upwards by the lower slide and locks the locking hooks On the lower slide (7) there is a "lug", which changes the status of the infrared sensors due to the movement of the lower ... or locks the mechanical interlock (3) Each unlocking mechanism has two locking hooks (4 and 5) One (4) is for the top lid, the other (5) for the bottom lid Triggered when the lug for the emergency...
... was fitted in the E53 The power is output via a chain to the propeller shaft to the front axle and apportioned by a multi-disc clutch The torque transmission efficiency of the multi-disc package ... joint is used as the drive flange in this case The oil filler and drain plug is located in the same position as on the E53 The filler pipe is now equipped with a quick-release coupling The E70 ... loss in the thermal balance of the axle drive The HAG188L is 7 .5 mm longer than the HAG188K In view of the heat generated as the result of the higher load, the HAG188L final drive unit is installed...
... on the N52B30O1 in the E70 The power is now supplied via terminal 87 Generator The basic generator for the M52B30O1 engine isthe Bosch M2 .5 with a rating of 180 A The Valeo TG23 at 220 A is ... in the E70 The changes and modifications to the N52K compared to the N52 and the components specific to the E70 are described in the following Cylinder Head Cover The cylinder head cover on the ... for T) the purpose of measuring the oil level in the N52B30O1 in the E70 Although the QL is a new component, it has the same functions as the previous sensor T The QL is longer to match the geometry...
... gearshift system This system is already known from the E 65 Unlike in the E 65, the gear selector lever in the E70 is not on the steering column but rather in the usual position on the center console ... in the gear selector lever The main transmission path to the EGS isthe PT-CAN If the "Display gearbox data" message is not received correctly on the PT-CAN, the gear selector lever will change ... service brake is pressed and the speed is < km/h Otherwise "N" is selected The selector lever is therefore not locked Pressing to the left selects the "M/S" gate Operating options of the gear selector...
... and therefore to the complete network An error message is stored if this is not the case This error message is then evaluated as part of the energy diagnosis procedure Wiring The wiring of the ... in the E70 This bus system is used for the first time for the data exchange in the area of the vertical dynamics management (VDM) It is used to exchange data between the VDM control unit and the ... axis nor on the voltage axis The FlexRay bus system is a bus system with a high data transmission rate and therefore with rapid changes in the voltage level The voltage level as well as the rise...
... code is used for the data exchange The cryptic code provides the enable to start the engine The Car Access System is backwards compatible with the Car Access System This means the functions of the ... establishes whether the remote control matches the vehicle or the identification transmitter is located in the vehicle interior The vehicle can be started if the check is successful Authentication ... approximately 10 seconds after the start of the request Data Transmission Data transmission is redundant via the bus systems The signal from the digital engine management reaches the CAS via the K-CAN...
... process The junction box records bus wake-ups of the K-CAN while the vehicle is at rest Recording the bus wake-ups is a new function, which is integrated in the energy management of the E70 The junction ... stored The relative time is made available by the instrument cluster The bus wake-ups can be read out as part of the diagnostic procedure However, it is not possible to distinguish whether the bus ... FRM - The FRM sends the request to shut down the electric loads after minutes only if the vehicle is not locked Otherwise, the electric loads are switched off immediately when the vehicle is locked...
... Chassis Dynamics This affects the translatory movement along the z axis and, depending on the system, the rotational movement about the x axis for ARS or about the y axis for EHC Furthermore, the ... The radius of the Kamm's circle depends on the friction coefficient between the tire and the road, i.e on the tire, the road surface and the road conditions If the road is wet, for example, the ... swerving This causes, among other things, the vehicle to roll and move about the x axis E70 Chassis Dynamics Vertical Dynamics If the body moves along the z or vertical axis, this is known as...
... driver If the steering wheel is moved, the code disc turns within the optical sensor Code disc Optical sensor Code Disc The code disc is black and has a pattern of lines This pattern consists of ... on the outside and inside of the code disc Between the two continuous lines, there are discontinuous lines at certain distances from each other These represent the digital range of the sensor The ... operated when the "Error" fault status is active This is not the case if "Fail" is active If initialization is successful, the "Drive" status is activated 15 E70 Lateral Dynamics Systems The volumetric...
... E 65 The Dynamic Drive in the E60 isthe same as the Dynamic Drive in the E 65 As the vehicle drives through a bend, a rolling moment builds up about the vehicle's roll axis (x-axis) due to the ... of the bend is compressed and the wheel suspension on the inside of the bend rebounds This has a twisting effect on the anti-roll bar (torsion) The forces arising in the bearing points of the ... greater the signal will be (current) The stronger the current supplied to the valve, the more the valve closes and the higher the pressure which builds up in the anti-roll bars The pressures at the...
... up the exerted forces The upper section of the housing is made of plastic, to which the force sensor pc-board (5) with the Hall-IC (3) is secured The magnet (4) is fixed to the piston (6) The ... projecting light from the top onto the code disc The LED is soldered directly to the pc-board of the (SZL) The fibre optics unit is secured by means of two screws to the pc-board Together, the LED with ... driver to the steering wheel The code disc turns within the optical sensor as the steering wheel is turned Code Disc The code disc is black and features a line pattern This pattern consists of...
... information, the Car Access System is informed of the status of the door lock in the driver's door This is important for the case when a request to unlock or lock the vehicle is triggered via the remote ... forwards the signal to the Car Access System The signal from the remote control is verified in the Car Access System If the signal is recognized as valid, the junction box control unit is enabled ... as the Car Access System receives the signal from the remote control receiver, it checks whether the remote control is valid and belongs to the vehicle Only if the check is successful will the...
... control unit The indirect anti-trap mechanism in the E90 is based on the evaluation of the Hall pulses from the power window motors The speed is derived from the Hall pulses of the power window ... power window motors The indirect anti-trap mechanism for the front windows is activated by the footwell module The indirect anti-trap mechanism for the rear windows is activated by the junction box ... function The comfort opening or closing function is initiated when the key is held in this position The footwell module sends the request via the K-CAN On conclusion of the corresponding check, the...
... 03/20 05 • E60 from 09/20 05 • E61 from 09/20 05 • E63 from 09/20 05 • E64 from 09/20 05 • E91 from 09/20 05 • E92 from 05/ 2006 Comfort Access is available on the E70 from SOP (Start of Production) The ... message The check control message informs the customer that the battery needs to be changed If the battery is not changed, the voltage monitoring Index facility switches to the second stage This means ... "terminal 15 ON" is selected, data for the Conditioned Based Service is transferred to the ID transmitter using the interior antennas The ID transmitter then confirms that the transmission was...
... sensor is used on the E70 What is actually new isthe fact that the solar sensor has been integrated in the rain/driving lights/solar sensor The functionality of the rain sensor and of the driving ... determine the rain intensity Rain detection is based on the reflection of the infrared light at the boundary surface from the glass of the Windshield to air The reflection is dependent on the level ... area of the road which is also used for the head-up display The brightness level of the representation in the head-up display can thus be adapted to the light situation This is necessary for example...
... System The Car Access System issues the release signal for the panorama glass sunroof Movement is prevented during the engine starting phase by sending the "Terminal 50 ON" status This means that there ... rotation is detected from the pulses of the Hall sensors The distance the panorama glass sunroof must cover during the opening or closing procedure is defined in the roof function center The panorama ... Access System isthe precondition for the execution of the emergency closing function It is necessary to release and press the button again, as the first time the button is pressed the anti-trapping...
... 15 KL 58 g Terminal 58 switched Note: The Car Access System actuates a relay in the front distribution box The front distribution box is thus supplied with "Terminal 15 ON" (7) The Terminal 15 ... of the seat is assigned to the button At the same time, the current position of the door mirrors is also assigned to the selected button The information for storing the door mirror position is ... monitoring the large seat section On the backrest there is only one Micro-switch, on the outside There are two further Micros-witches in the seat bottom, on the inside and outside of the locks Another...