0

configuring ip access lists

Tài liệu Lab 11.2.1 Configuring Standard Access Lists pdf

Tài liệu Lab 11.2.1 Configuring Standard Access Lists pdf

Quản trị mạng

... Apply access list to the proper router interface a. First remove the old access list application by typing no ip access- group 1 in at the interface configuration mode. b. Apply the new access ... _________________________________________________________ Step 7 Apply the Access list to the interface a. At the FastEthernet 0 interface mode prompt type the following: GAD(config-if) #ip access- group 1 in Step 8 Ping the ... Step 9 Create a new access list a. Now create an access list that will prevent the even numbered hosts from pinging but permit the odd numbered one. b. What will that access list look like?...
  • 5
  • 488
  • 0
Tài liệu Lab 11.2.1a Configuring Standard Access Lists docx

Tài liệu Lab 11.2.1a Configuring Standard Access Lists docx

Quản trị mạng

... Apply access list to the proper router interface a. First remove the old access list application by typing no ip access- group 1 in at the interface configuration mode. b. Apply the new access ... Inc. b. What will that access list look like? Finish this command with an appropriate comparison IP address (aaa.aaa.aaa.aaa) and wildcard mask (www.www.www.www): ip access- list 2 permit aaa.aaa.aaa.aaa ... Basics v 3.0 - Lab 11.2.1a Copyright  2003, Cisco Systems, Inc. Lab 11.2.1a Configuring Standard Access Lists Objective • Configure, and apply a standard ACL to permit or deny specific...
  • 5
  • 330
  • 0
Access Lists Lab Scenario

Access Lists Lab Scenario

Quản trị mạng

... command:Las_Vegas(config-int) #ip access- group 101 in4. All administrators are located in Tulsa on network 172.16.4.0/24. Configure a Standard IP access list to allow access to the terminal lines only to that network: access- list ... connection to the Internet: access- list 102 deny icmp any any 3 9 access- list 102 deny icmp any any 3 10 access- list 102 permit ip any anyApply access list 102 as an outbound access control list to ... network.Solution1. Configure an extended IP access list on the Las Vegas router. The list should contain the following entry to allow access to the Time and Attendance application: access- list 101 permit tcp...
  • 3
  • 217
  • 0
Tài liệu Chapter 10 Managing Traffic with Access Lists docx

Tài liệu Chapter 10 Managing Traffic with Access Lists docx

Chứng chỉ quốc tế

... Control access list logging standard Standard Access List Router(config) #ip access- list standard ? <1-99> Standard IP access- list number WORD Access- list name Router(config) #ip access- list ... Router(config-if) #ip access- group 110 out Named Access Lists 命名访问列表是创建标准和扩展访问列表的另外 1 种方法.它允许你使用命名的方法来创建和应用标准或者扩展访问列表.使用 ip access- list 命令来创建,如下: Router(config) #ip access- list ? extended ... permit 语句,除非你想想所有数据包丢弃 2 种主要的访问列表: 1.标准访问列表(standard access lists) :只使用源 IP 地址来做过滤决定 2.扩展访问列表(extended access lists) :它比较源 IP 地址和目标 IP 地址,层 3 的协议字段,层 4端口号来做过滤决定 利用 ACL 来过滤,必须把 ACL 应用到需要过滤的那个...
  • 4
  • 539
  • 0
Tài liệu Cisco Ios Access Lists pptx

Tài liệu Cisco Ios Access Lists pptx

Quản trị mạng

... extended access lists. 2.4.2 Displaying access lists We have discussed building and entering access lists, but not how to examine the access lists on a router. To see a router's access ... readable access lists. 2.2.5 Generic format of extended access lists Now that we have looked at a variety of extended access lists, let's define the generic format of extended access lists ... using Cisco IOS access lists. I present a way to think about access lists and network policy, describe how access lists are built, and give examples of how to apply those access lists in different...
  • 227
  • 428
  • 0
Access Control Lists

Access Control Lists

Quản trị mạng

... IDF/MDF/POP Equipment Type Model No Qty No./Type Ports Description/Function Cost Main Building Floor 2 IDF Equipment Type Model No Qty No./Type Ports Description/Function ... Building Floor 3 IDF Equipment Type Model No Qty No./Type Ports Description/Function Cost Copyright  2003, Cisco Systems, Inc. Case Study: Access Control Lists (ACLs) 1-19 Phase ... Interface IP Address Subnet Mask Below is the sample layout for the switch tables. Location: Switch Name: Switch IP address: Interface/Sub Interface Type/Port/Number Description...
  • 20
  • 469
  • 0
Configuring Voice over IP for the Cisco 3600 Series

Configuring Voice over IP for the Cisco 3600 Series

Hóa học - Dầu khí

... transparently through the IP network.VoIP dial peer—Dial peer connected via a packet network; in the case of Voice over IP, this is an IP network. VoIP peers point to specific VoIP devices.Prerequisite ... use Voice over IP, you must first:•Establish a working IP network. For more information about configuring IP, refer to the IP Overview,” “Configuring IP Addressing,” and “Configuring IP Services” ... decide to lower MTU size,use the ip mtu command; this command affects only IP traffic. Configuring Voice over IP for the Cisco 3600 Series VC-13 Configuring Voice over IP for theCisco 3600 SeriesThis...
  • 36
  • 473
  • 1
Configuring an IP Address and Default Gateway in Windows 2000

Configuring an IP Address and Default Gateway in Windows 2000

Hệ điều hành

... the IP address has been configured correctly. Troubleshooting As an IT professional, configuring and troubleshooting TCP /IP can be a daily activity. Always double-check the static IP configuration. ... Administrator. On a typical system, only the administrator can configure an IP address. Step 2: Configure TCP /IP to use a static IP address Right-click My Network Places, and then click Properties. ... network with the same IP address is detected. Be careful when manually entering IP configuration settings, especially numeric addresses. The most frequent cause of TCP /IP connection problems...
  • 3
  • 448
  • 0
Configuring VPN Client Remote Access

Configuring VPN Client Remote Access

Quản trị mạng

... 14Create an access list that defines the PIX Firewall network(s) requiring IPSec protection: access- list 90 permit ip 10.0.0.0 255.255.255.0 10.1.1.0 255.255.255.0Step 15Bind the access list ... 1.1•Xauth with RSA Ace/Server and RSA SecurID• Configuring L2TP with IPSec in Transport Mode•Windows 2000 Client with IPSec and L2TP•Using PPTP for Remote Access Supporting Clients with Dynamic AddressesDynamic ... netmask 255.255.255.255 access- list acl_out permit tcp any host 209.165.201.2 eq telnet access- group acl_out in interface outsideThe ip local pool command specifies the IP addresses assigned to...
  • 40
  • 552
  • 0
Tài liệu Module 5: Configuring Access for Remote Clients and Networks ppt

Tài liệu Module 5: Configuring Access for Remote Clients and Networks ppt

Hệ điều hành

... Module 5: Configuring Access for Remote Clients and Networks """" Configuring VPNs ! Configuring a VPN to Accept Client Connections! Configuring a Local VPN! Configuring ... Remote Access service and by customizing IP packet filters in ISA Management. For more information on how to configure the Routing and Remote Access service, see Module 7, Configuring Remote Access, ” ... to view information on configuring the Routing and Remote Access service or IP packet filtering, and then click Finish. Note Important 14 Module 5: Configuring Access for Remote Clients...
  • 30
  • 496
  • 0

Xem thêm