... Switch_A#vlan database Switch_A(vlan)#vlan vlan_number Switch_A(vlan)#exit Issue Show vlan to view configuration : Upon exiting, the VLAN is applied to the switch. The next step is to assign the VLAN ... No3www.ipmac.com.vn2 Vlan 2 Fa0/23 Vlan 3 Fa0/34 Vlan 4 Fa0/4 The command vlan database can be used in the Privileged EXEC mode to enter into VLAN configuration mode. A VLAN name may also be ... 11. Configure similarly for Switch_B.2. Task 21. Configure vlan on Switch A and Switch B by using the following table: Vlan Vlan Name Portwww.ipmac.com.vn- To PC1 can go to global config...
... ATM LANE” ATM, LANE Operation, and LANE ConfigurationChapter 7, “InterVLAN Routing” InterVLAN Routing Design and interVLAN Routing ConfigurationChapter 8, “Multilayer Switching Multilayer Switching, ... Switch Management, and Switch Port ConfigurationChapter 4, “VLANs and Trunking” Virtual LANs, VLAN Trunks, VLAN Trunk Configuration, VLAN Trunking Protocol, VTP Configuration, and VTP PruningChapter ... transporting VLANs on various types of links. VLAN administration and management is presented through the configuration of the VLAN Trunking Protocol (VTP). ii Cisco CCNP Switching Exam...
... switch.Switch(enable) set spantree root 1 dia 2VLAN 1 bridge priority set to 8192VLAN 1 bridge max aging time set to 10 seconds.VLAN 1 bridge hello time set to 2 seconds.VLAN 1 bridge forward delay set to ... Verify it!SolutionTask 1Use the show spantree command for VLAN 1 on each switch. You will see:Switch(enable) show spantree 1Vlan 1Spanning tree enabledSpanning tree type ieeeDesignated ... uplinkfast enable [rate station-update-rate][all-protocols off | on]VLANs 1-1005 bridge priority set to 49152.The port cost and portvlancost of all ports set to above 3000.Station update rate set...
... create a VLAN on a switch, you use the following commands:Set vlan <vlan number>,Example:cat5k> (enable) set vlan 2Vlan 2 configuration successfulcat5k> (enable)To prune a VLAN, ... virtual LANs followed by the various switching modes,and then we’ll examine what can be done in a large switched network.Virtual LANs (VLANs)A virtual LAN is defined as a software-emulated LAN. ... 171.108.1.1 255.255.255.0 lane client ethernet elan_ccieIn the preceding code, the command lane client ethernet elan_ccie will make therouter attempt to join the ELAN with the name elan_ccie. To view...
... 640-604 Switching 3.0 www.testking.com - 5 - 5.2 LAN Emulation (LANE) 5.2.1 LANE Components 5.2.2 LANE Operation 5.2.3 Address Resolution 5.2.4 LANE Component Placement 5.2.5 LANE ... kilobits per second (bandwidth) LAN LANE LAPB LAPD Local Area Network LAN Emulation Link Access Procedure, Balanced Link Access Procedure on the D channel 640-604 Switching 3.0 www.testking.com ... produce wire-speed results. 1.4.1.5 Multi-Layer Switching (MLS) Multi-layer switching combines layer 2 switching, layer 3 switching, and layer 4 switching technologies and provides high-speed...
... commands in enable mode to configure static VLANs on an IOS-based switch: Switch# vlan database Switch(vlan)# vlan vlan-number name vlan_name Switch(vlan)# exit Switch# configure terminal Switch(config)# ... virtual LANs (VLANs). A VLAN is a single broadcast domain. All devices connected to the VLAN receive broadcasts from other VLAN members. However, devices connected to a different VLAN will ... kilobits per second (bandwidth) LAN LANE LAPB LAPD Local Area Network LAN Emulation Link Access Procedure, Balanced Link Access Procedure on the D channel 640-604 Switching 3.0 www.testking.com...
... 1 - 4 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 7.2.6 Copyright 2003, Cisco Systems, Inc. Lab 7.2.6 Spanning Tree Recalculation ... troubleshoot the hosts and switches configurations. 2 - 4 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 7.2.6 Copyright 2003, Cisco Systems, Inc. Step 4 Look at the show interface information ... information a. On both switches, type the command show interface VLAN1 at the privileged EXEC prompt as follows: Switch_A#show interface vlan 1 b. What is the MAC address of this switch? _________________________________________...
... VLAN duy nhất. III. Cấu hình Voice-VLAN:Phần này sẽ khảo sát dữ liệu voice sẽ được đóng gói như thế nào. Các gói voice (voice packets) sẽ được mang trong một VLAN duy nhất gọi là Voice VLAN ... đòi hỏi nhiều cấu hình trên gateway.Switch(config-if)#power inline {auto|never}II. Voice VLAN: Cisco IP phones sẽ tạo ra một luồng dữ liệu cho voice (voice data stream). Thêm vào đó, nó cung ... packets) sẽ được mang trong một VLAN duy nhất gọi là Voice VLAN hoặc trên một dataVLAN bình thường, gọi là native VLAN. Thông tin QoS từ voice packets cũng phải đượcmang theo trong các packets.Có...