... refrigeration
system freezes at expansion valve
orifice and temporarily stops cycle,
but normal state is restored after a
time when the ice melts
z Drier oversaturated state
z Moisture in refrigeration system
freezes ... detector and repair if neces-
sary
(2) Charge proper amount of re-
frigerant
(3) If indicated pressure value is
near 0 when connected to gauge,
create the vacuum after inspecting
and repairing the ... sure to read the following item carefully, then
follow the correct procedure described in the repair manual.
AC0M1–01
AC–36
–AIR CONDITIONING BLOWER UNIT
2518AuthorĂ: DateĂ:
DISASSEMBLY
1. REMOVE...
... bolt.
(c) Pry up the pipe with a screwdriver and remove the pipe.
8. REMOVE MANUAL VALVE BODY
Remove the 5 bolts and manual valve body.
9. REMOVE CONNECTOR CLAMP AND PIPE RETAINER
Remove the 2 ... PARK/NEUTRAL POSITION (PNP) SWITCH
AX–5
1925A uthorĂ: DateĂ:
PARK/NEUTRAL POSITION (PNP)
SWITCH
ON–VEHICLE REPAIR
1. DISCONNECT PARK/NEUTRAL POSITION SWITCH
CONNECTOR
2. REMOVE PARK/NEUTRAL POSITION SWITCH
(a) ... TRANSAXLE (A140E) DIFFERENTIAL OIL SEAL
AX–11
1904A uthorĂ: DateĂ:
DIFFERENTIAL OIL SEAL
ON–VEHICLE REPAIR
1. REMOVE LH AND RH DRIVE SHAFTS
(See page SA–17)
2. REMOVE SIDE GEAR SHAFT OIL SEAL
Using...
... to
another, thus controlling shifting and lock–up timing.
INTRODUCTION GENERAL REPAIR INSTRUCTIONS–
IN–4
GENERAL REPAIR INSTRUCTIONS
1. Use fender, seat and floor covers to keep the vehicle
clean ... the same time.
The component groups are inspected and repaired from the converter housing side.
As much as possible, complete the inspection, repair and assembly before proceeding to the next com-
ponent ... hammer and punch, drive out the pin.
(d) Slide out the shaft and remove the manual valve lever
from the case.
57. REMOVE MANUAL SHAFT OIL SEAL
Remove the oil seal with a screwdriver.
AUTOMATIC...
... lock manual switch OFF or UNLOCK No continuity
A16 – Ground Door lock manual switch LOCK Continuity
A17 – Ground Door lock manual switch OFF or LOCK No continuity
A17 – Ground Door lock manual ... No.1)
5. Wire Harness
–
–
–
BE–70
–
Door lock system does not operate by manual switch.
1. Power Window Master Switch
2. Door Lock Manual Switch
3. Integration Relay (I/P J/B No.1)
4. Wire Harness
BE–60
BE–70
BE–70
–
Door ... and verify that the lights
go on when the ignition switch is turned ON.
BE0AF–02
N18026
Free
Pushed in
Free
Pushed in
w/o Cruise control:
w/ Cruise control:
1
2
3
1
2
4
N20208
1
2
–BODY ELECTRICAL...
... disc.
HINT:
If the disc cannot be removed easily, turn the shoe adjuster until
the wheel turns freely.
4. REMOVE SHOE RETURN SPRINGS
Using needle–nose pliers, remove the shoe return springs.
5....
... PEDAL FREEPLAY AND
PUSH ROD PLAY
(a) Loosen the lock nut and turn the push rod until the free-
play and push rod play are correct.
(b) Tighten the lock nut.
(c) After adjusting the pedal freeplay, ... Tighten the lock nut.
3. CHECK THAT PEDAL FREEPLAY AND PUSH ROD
PLAY ARE CORRECT
Push in on the pedal until the beginning of clutch resistance is
felt.
Pedal freeplay: 5.0 – 15.0 mm (0.197 – 0.591 ... bearing.
Q10088
Pedal Height
Adjust Point
Push Rod Play
and Freeplay
Adjust Point
Push Rod Play
Pedal Height
CL035–01
CL0042
Pedal Freeplay
CL0512
25 mm (0.98 in. ) or more
Release
Point
Full...
... system.
z Use Toyota Long life Coolant” or equivalent and
mix it with plan water according to the manufactur-
er’s directions.
z Using of coolant which includes more than 50 %
(freezing protection ... Using of coolant which includes more than 50 %
(freezing protection down to –35°C (–31°F) or 60 %
(freezing protection down to –50°C (–58°F)) of eth-
ylene–glycol is recommended but not more than ... between the ”LOW” and ”FULL” lines, when the engine is cold.
If low, check for leaks and add ’ Toyota Long Life Coolant” or Equivalent up to the ”FULL” line.
2. CHECK ENGINE COOLANT QUALITY
(a)...
... output simultaneously, E2 (sensor ground) may be
open.
D Read freeze frame data using TOYOTA hand–held tester or OBD II scan tool. Because freeze frame
records the engine conditions when the malfunction ... be
open. Perform troubleshooting of DTC P0115 first.
D Read freeze frame data using TOYOTA hand–held tester or OBD II scan tool. Because freeze frame
records the engine conditions when the malfunction ... scan tool or
TOYOTA hand–held tester to Data Link Connector
3 (DLC3) on the vehicle. The OBD II scan tool or
TOYOTA hand–held tester also enables you to
erase the DTCs and check freezed frame...
... malfunctioning.
(f) TOYOTA Hand–Held Tester:
Conclude forced driving of the VSV for the EVAP.
(1) Stop the engine.
(2) Disconnect the TOYOTA hand–held tester from the
DLC3.
(g) If you have no TOYOTA Hand–Held ... the
purge line.
(c) TOYOTA Hand–Held Tester:
Forced driving of the VSV for the EVAP.
(1) Connect a TOYOTA hand–held tester to the DLC3.
(2) Start the engine.
(3) Push the TOYOTA hand–held tester ... of fuel for reduced
exhaust emissions
Remark: * For inspection and repair of the SFI system, refer to the SF section of this manual.
B01252
Air
Disconnect
Air Inlet Line Hose
B01253
Pinch
Push
AA
Pinch
B01148
B01149
Air
Purge...
... the idler pulley.
3. INSPECT TENSION SPRING
(a) Measure the free length of tension spring.
Free length: 42.0 mm (1.654 in.)
If the free length is not as specified, replace the tension spring.
(b) ... warpage is greater than maximum, replace the manifold.
EM085–03
EM3336
No!
S01519
Turn
Seal
P15243
Free Length
EM–22
–ENGINE MECHANICAL (5S–FE) TIMING BELT
1194AuthorĂ: DateĂ:
INSPECTION
1. INSPECT...
... TO USE THIS MANUAL
IN–1
1AuthorĂ: DateĂ:
HOW TO USE THIS MANUAL
GENERAL INFORMATION
1. INDEX
An INDEX is provided on the first page of each section to guide you to the item to be repaired. To ... FI1066
IN0CO–04
Z11554
Seal Lock Adhesive
IN–4
–INTRODUCTION REPAIR INSTRUCTIONS
4AuthorĂ: DateĂ:
REPAIR INSTRUCTIONS
GENERAL INFORMATION
BASIC REPAIR HINT
(a) Use fender, seat and floor covers to keep ... replace them with new parts.
(5) Before repairs, remove the airbag sensor if shocks
are likely to be applied to the sensor during repairs.
(6) Never disassemble and repair the airbag sensor as-
sembly,...