... Configure the workstation a The configuration for the host connected to the Gadsden Router is: IP Address IP subnet mask Default gateway 1 92. 168.14 .2 255 . 25 5 . 25 5. 0 1 92. 168.14.1 Step Login to the router ... and configure the Cisco TFTP Server a Check withthe instructor as to the IP address of the Cisco TFTP server 2- 7 CCNA 2: Routers and Routing Basics v 3.0 - Lab 5 .2. 5 Copyright 20 03, Cisco Systems, ... 428 4648 bytes copied in 34.0 12 secs ( 1 25 9 75 bytes/sec) Step 11 Verify the transfer to the TFTP server a Check the TFTP server log file by clicking View > Log File The output should resemble the...
... phát triển thương mại điện tử địa phương giai đoạn 20 11 -20 15, gửi Bộ Công Thương tổng hợp trước trước 31 tháng 12 năm 20 10 tổ chức triển khai theo hướng dẫn Bộ Công Thương; c) Kiểm tra, đánh giá ... đ) Cung cấp trực tuyến từ mức độ trở lên 50 % dịch vụ công liên quan tới thương mại hoạt động sản xuất kinh doanh trước năm 20 14, đến hết năm 20 15 có 20 % đạt mức độ B NỘI DUNG CỦA KẾ HOẠCH I Hoàn ... công liên quan tới xuất nhập trước năm 20 13, 40% đạt mức vào năm 20 15; b) Cung cấp trực tuyến từ mức độ trở lên dịch vụ thủ tục hải quan điện tử trước năm 20 13; c) Cung cấp trực tuyến từ mức độ...
... Wait until the port LED goes green and then go to the next step Step 21 Test the VLANS and the trunk Ping from the host in Switch_A port 0/8 to the host in Switch_B port 0/ 12 c Was the ping successful? ... 0/ 12 to the switch IP 1 92. 168.1 .2 a Was the ping successful? _ b Why? Step 20 Move hosts Move the host in Switch_A from port 0/ 12 to ... typing exit, and turn all the devices off Then remove and store the cables and adapter 5- 6 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 9 .2. 5 Copyright 20 03, Cisco Systems, Inc...
... where the first parameter is the identifier that defines the value of the User-Agent header in the request, the second parameter is the email address of the person using the robot, and the optional ... users can use the pl2bat program, included withthe Perl distribution, to make the geturl.pl executable from the command line: C:\your\path\here> pl2bat geturl You can then call the program to ... Figure 5- 1 sketches out the top-level hierarchy within LWP Figure 5- 1 The top-level LWP hierarchy The File module parses directory listings The Font module handles Adobe Font Metrics In the...
... invoked with no parameters, this returns the default port for the URL defined in the object The default port is based on the scheme used Even if the port for the URL is explicitly changed by the ... user withthe port( ) method, the default port is always the same $url->epath( ) When invoked with no parameters, this returns the escaped path of the URL defined in the object When invoked with ... with no parameters, this returns the user for the URL defined in the object When invoked with a parameter, the object's user is assigned to that value $url->password( ) When invoked with no parameters, ...
... a family in the 1 950 's and 1960's? (A) Lines 1-3 (B) Lines 11- 12 (C) Lines 20 -21 (D) Lines 24 -26 22 Which of the following best characterizes the organization of the passage? (A) The second paragraph ... published after The Poorhouse Fair 25 Each year the awards and prizes offered by the Academy-Institute total approximately (A) $ 12, 50 0 (B) $53 ,000 (C) $50 ,000 (D) $ 750 ,000 26 The word "many" ... require the use of costumes 40 Where in the passage does the author discuss the separation of the stage and the audience? (A) Lines 8-9 (B) Lines 12- 14 (C) Lines 19 -20 (D) Lines 22 -24 Questions 41 -50 ...
... biệt cài máy server dễ xảy xung đột cổng 53 (dịch vụ DNS) dịch vụ DHCP với Windows 20 00 server, cần stop dịch vụ server wingate hoạt động Khi xung đột cổng, tạo cổng mới, cổng >1 024 thường lựa ... động tìm Wingate server chia sẻ kết nối Internet Phần III: Cài đặt Wingate máy tính sử dụng hệ điều hành Windows 20 00 Professional, Server, XP, 20 03 Với máy chủ Wingate Windows 20 00/XP thiết lập ... > Use proxy server for your LAN > Nhập IP máy chủ(máy cài wingate và cắm modem) cổng máy chủ (theo mặc định bạn nhập cổng 80) xem hình sau: Với máy chủ Wingate Windows 20 00 Server thiết...
... host connected to the Gadsden Router is: IP Address IP subnet mask Default gateway 1 92. 168.14 .2 255 . 25 5 . 25 5. 0 1 92. 168.14.1 Step Login to the router in user mode a Connect to the Gadsden router ... configuring the Cisco TFTP Server a Check withthe instructor as to where the Cisco TFTP server is installed on the student workstation b Start the TFTP server If the computer is properly connected, there ... TFTP server a Before copying the files, verify that the TFTP server is running b Record the IP address of the TFTP server c 2- 5 Issue the command copy running-config tftp Follow the...
... a The configuration for the host connected to the Gadsden Router is: IP Address IP subnet mask Default gateway 1 92. 168.14 .2 255 . 25 5 . 25 5. 0 1 92. 168.14.1 Step Login to the router in ... and configure the CIscoTFTP Server a Check withthe instructor as to the IP address of the Cisco TFTP server 2- 7 CCNA 2: Routers and Routing Basics v 3.0 - Lab 5 .2. 5a Copyright 20 03, Cisco Systems, ... 428 4648 bytes copied in 34.0 12 secs ( 1 25 9 75 bytes/sec) Step 11 Verify the transfer to the TFTP server a Check the TFTP server log file by clicking View > Log File The output should resemble the...
... c1700-y-mz. 122 -11.T.bin Step Send the file from the HyperTerminal program 4-9 CCNA 2: Routers and Routing Basics v 3.0 - Lab 5 .2. 5b Copyright 20 03, Cisco Systems, Inc a From the HyperTerminal ... completed the router will reload Step Reset the boot register and the console speed a From the configuration prompt, set the boot register back to 0x21 02 or the original setting before the IOS ... Name/status 428 4648 c1700-y-mz. 122 -11.T.bin [ 428 54 52 bytes used, 124 91764 available, 1677 721 6 total] 16384K bytes of processor board System flash (Read/Write) Reset the console speed in Hyperterminal,...
... configuration for the host connected to the Gadsden Router is: IP Address IP subnet mask Default gateway 1 92. 168.14 .2 255 . 25 5 . 25 5. 0 1 92. 168.14.1 Step Login to the router in user mode a Connect to the Gadsden ... configuring the Cisco TFTP Server a Check withthe instructor as to where the Cisco TFTP server is installed on the student workstation b Start the TFTP server If the computer is properly connected, there ... (18 52 8 bytes/sec) Step Verify the transfer to the TFTP server a Check the TFTP server log file Click View > Log File The output should be similar to the following: Mon Sep 16 14:10:08 20 02: Receiving...
... start the File size 428 4648 bytes - 10 c1700-y-mz. 122 -11.T.bin sending program yet Checksum File name (0x4160e8) 0x9c8a c1700-y-mz. 122 -11.T.bin CCNA 2: Routers and Routing Basics v 3.0 - Lab 5 .2. 6b ... completed the router will reload Step Reset the boot register and the console speed a From the configuration prompt, set the boot register back to 0x21 02 or the original setting before the IOS ... Name/status 428 4648 c1700-y-mz. 122 -11.T.bin [ 428 54 52 bytes used, 124 91764 available, 1677 721 6 total] 16384K bytes of processor board System flash (Read/Write) Reset the console speed in HyperTerminal,...
... should be familiar withthe following: ! The ADO 2.5 object library Module 7: Universal Data Access with ADO 2.5 45 Exercises The following exercise provides practice in working withthe concepts and ... in the pool can be shared among many users, thereby minimizing the impact on theserver without frequently closing and reopening connections 12 Module 7: Universal Data Access with ADO 2.5The ... Access with ADO 2.5 Comment out the lines of code that set the Value and Direction properties of theparameters Create theParameters collection by adding the following line of code after the lines...
... (S0) Serial (S1) 1700 FastEthernet (FA0) FastEthernet (FA1) Serial (S0) Serial (S1) 25 00 Ethernet (E0) Ethernet (E1) Serial (S0) Serial (S1) 26 00 FastEthernet 0/0 FastEthernet 0/1 (FA0/1) Serial ... Summary Router Ethernet Ethernet Serial Serial Interface Model Interface #1 Interface #2 Interface #1 Interface #2 #5 800 (806) Ethernet (E0) Ethernet (E1) 1600 Ethernet (E0) Ethernet (E1) Serial ... Step Test the MOTD display a Exit the console session Reenter the router to display the message-of -the- day This is done by pressing the Enter key This will display the message entered into the configuration...
... port LED goes green and then go to the next step Step 21 Test the VLANS and the trunk Ping from the host in Switch_A port 0/8 to the host in Switch_B port 0/ 12 a Was the ping successful? ... configurations and starting with an unconfigured switch Instructions are provided for the 29 00, 29 50 , and 1900 Series switches 29 00 and 29 50 Series Switches Enter into the privileged EXEC mode by ... _ 5- 8 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 9 .2. 5 Copyright 20 03, Cisco Systems, Inc Step 19 Test the VLANS and the trunk Ping from the host in Switch_A port 0/ 12 to...
... (GMT) The third line tells the client what kind of software theserver is running In this case, theserver is Apache version 1.1.1 The fourth line (Content-type) tells the browser the type of the ... blank line and the document text follow Figure 2- 2 shows the transaction Figure 2- 2 A simple transaction Parsing the HTML The document is in HTML (as promised in the Content-type line) The browser ... 19 95 00:03: 15 GMT [data of GIF file] Figure 2- 3 shows the complete transaction, withthe image requested as well as the original document Figure 2- 3 Simple transaction with embedded image There...
... form rendered in the browser Let's fill out the form and submit it, as shown in Figure 2- 5 Figure 2- 5 Filling out the form After hitting the Done button, the browser connects to hypothetical.ora.com ... Figure 2- 11 maps out the structure of a server response Figure 2- 11 Structure of a server response In theserver response, the general header and entity headers are the same as those used in the ... request The entity-body is like the one used in the client request, except that it is used as a response The first part of the first line indicates the version of HTTP that theserver is using The server...