Disassembly Loosen the door assembly mounting bolts and tilt the door assembly forwards to keep it folded At this time, remove it by sliding the door sub roller from the door rail smoothly 2.Remove the front stem pan bumper Remove the folding door upper weather strip 4.Door glass After raising the side part of the weather strip using a screwdriver, remove the side part of the weather strip from the body flange by pushing the front window glass from the inside of the vehicle Installation 1) Check the correct portion of the sliding door when in stalling door After checking the door rail width 33mm, first of all, roller should be contacted on the rail (If fore condition is not performed, opening and closing of the door is proved the bad state and is occurred deformation.) 2) Check the effective step width when the door is fully opened 3) Manual opening and closing force of the door should be under 10kgf 4) Hinge shaft mounted to the pillar to be maintained vertically to be free from the torsion in door operating 5) Step pan and each corner area are to be free from the sealing problem by the management when installing the weather strip Glass Assembling Insert the string in the groove of the weather strip The string should be overlapped in both ends 2.Apply the soapsuds around the body flange Put the window glass on the right place from outside of the vehicle 4.Glass installation By pushing the glass from the outside of the vehicle, pull the one side of the string slowly to the vertical direction from the window At this moment, put the weather strip edge on the windshield flange part correctly • Do the work at the both sides of the glass toward the center Pull the string and tap the glass by the hand • Tap the glass repeatedly before the glass is fixed the body flange side certainly