Tài liệu Lab 3 1 2 Command Modes and Router Identification docx

... 1 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1. 2 Copyright  20 03, Cisco Systems, Inc. Lab 3. 1. 2 Command Modes and Router Identification Objective • Identify basic router modes ... configuration mode. Router( config-if)#exit 3 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1. 2 Copyright  20 03, Cisco Systems, Inc. Step 6 Assign a name to the router a. Router( config)#hostname ... __________________________________________________________________________ 2 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1. 2 Copyright  20 03, Cisco Systems, Inc. c. What does this prompt mean? __________________________________________________________________________...

... 1 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1. 2 Copyright  20 03, Cisco Systems, Inc. Lab 3. 1. 2 Command Modes and Router Identification Objective • Identify basic router ... __________________________________________________________________________ Step 7 Exit the router 3 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1. 2 Copyright  20 03, Cisco Systems, Inc. a. Enter exit at the prompt to close out of the router. GAD(config)#exit ... logoff by typing exit. Turn the router off. 4 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1. 2 Copyright  20 03, Cisco Systems, Inc. Erasing and reloading the router Enter into the privileged...

... 1 - 3 CCNA 1: Networking Basics v 3. 0 - Lab 3. 1. 2 Copyright  20 03, Cisco Systems, Inc. Lab 3. 1. 2 Voltage Measurement Objective • Demonstrate ... approximately 12 0 volts of AC directly to any electrical appliance that is plugged in. Examples of appliances are a computer, 2 - 3 CCNA 1: Networking Basics v 3. 0 - Lab 3. 1. 2 Copyright  20 03, Cisco ... a higher voltage of 22 0V for use by devices and equipment with heavier requirements, such as clothes dryers and arc welders. Prior to starting the lab, the teacher or lab assistant should...