...
Lab 7 .2. 6 Troubleshooting RIP
Objective
• Set up an IP addressing scheme using class B networks.
• Configure RIP on routers.
• Observe routing activity using the debug ip rip command. ... in this lab is
produced from 1 721 series routers. Any other router used may produce a slightly different output.
1 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 7 .2. 6 Cop...
... - 6 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 1 .2. 6 Copyright 20 03, Cisco Systems, Inc.
Lab 1 .2. 6 Troubleshooting RIP v2 using Debug
Objective
• Configure RIP v2 ... debug ip rip or undebug all.
Step 14 Start the debug RIP function
a. Start the debug RIP function on the BHM router again by typing debug ip rip.
b. Does a problem occur now...
...
Lab 1 .2. 6 Troubleshooting RIP Version 2 using Debug
Objective
• Configure RIPv2 on both routers
• Use debug commands to verify proper rip operation and analyze data ... Show the debug IP RIP options
a. At the privileged exec mode type debug ip rip?
b. How many options are available for debug ip rip?
_______________________________
2 - 6 CCNA 3: Switching ....
... multiplied by row three.
3. Now just add row four across.
8 7 6 5 4 3 2 1
128 64 32 16 8 4 2 1
1 0 111001
128 32 16 8 1
Position
Value
= 185
1 - 2 CCNA 1: Networking Basics v 3.0 - Lab ... doubles, base 2, for each position
to the left.
8 7 6 5 4 3 2 1
128 64 32 16 8 4 2 1
Position
Value
Steps
1. Enter the binary bits in row three. For...