Quản trị mạng Lab 8 - NAT

... R-X(config-if)#ip nat inside R-X(config)#int e0 R-X(config-if)#ip nat outside3. Configure static NAT on R-X so that the private ... R-X(config)#int e0 R-X(config-if)#ip address 10.2.0.16X 255.255.255.0 R-X(config-if)#no shut R-X(config)#int ... CCNA LAB No. 8: NAT configuration Lab time: 1 sessions Students are recommended to read the entire lab requirement before starting....

Báo cáo đề tài môn quản trị mạng : LAB 12 - Haroxy

...

7
1,308
17

Quản trị mạng LAB 1 - Basic config router

... copy running-config startup-config +Copy file startup-config from router to TFTP server at 192.1 68. 1.253 Router#copy startup-config tftp Example: 10-Perform ... password for telnet Router (config-line)#password cisco +Allow login Router(config-line)#login 4- Configure password for accessing enable mode : 123456 ... Password with md5 encryption 7- Show the value of configured register + Use the show version command Router #show version 8- Base on the above show command ,...

Quản trị mạng LAB 3 - LAN switching

... Switch_A(config)#interface f0/5 Switch_A(config-if)#switchport port-security maximum 10 Switch_A(config-if)#switchport port-security violation shutdown 11. Configure ... Switch_A(config-if)#switchport mode trunk Switch_A(config-if)#switchport trunk native vlan 1Note : Switch 2950 series support only 80 2.1q ... CCNA LAB No. 3 : LAN Switching Lab time: 1 session Students are recommended to read the entire lab requirement...

Quản trị mạng Lab 4-5 - RIP & IGRP

... Router(config-router)#network network-number : gõ các mạng kết nối trực tiếp với routerVí dụ: với router R3:Router(config-router)#network 3.0.0.0Router(config-router)#network 10.0.0.0Router(config-router)#network ... CCNA LAB No. 4-5 : CONFIGURE Static route – RIP – IGRP Lab time: 1 Task 2: RIP1. Đặt địa chỉ cho router: ... R3:Router(config-router)#network 3.0.0.0Router(config-router)#network 10.0.0.0Router(config-router)#network 192.1 68. 1 68. 0www.ipmac.com.vn 13. Dùng các lệnh dưới đây để kiểm tra kết quả: Router(config)#exit...

Quản trị mạng Lab 6 - OSPF & EIGRP

... Router(config-if)#ip summary-address eigrpautonomous-system-number ip-address mask administrative-distance 8. The EIGRP hello interval should be tuning to 10 seconds R1(config-if)#ip ... Router(config-router)#no auto-summary Note : - Automatic summarization may not be the preferred option in certain instances. For example, if there are discontiguous subnetworks auto-summarization ... Rx(config-router)#network 192.x.x.x 0.0.0.0 area 0Task 3: OSPF multi-area 1. Configure OSPF area 1 on interface loopback 0 of router X. Rx(config-router)#network...

Quản trị mạng Lab 7 - InterVLAN

... Sw355 0-2 (config)#vlan 2 Sw355 0-2 (config)#int f0/2 Sw355 0-2 (config-if)#switchport mode access Sw355 0-2 (config-if)#switchport access ... Router. Sw355 0-2 (config)#int f0/4 Sw355 0-2 (config-if)#switchport trunk encapsulation dot1q Sw355 0-2 (config-if)#switchport mode trunk ... CCNA LAB No. 7: Inter VLAN Routing CONFIGURATION Lab time: 1 session Students are recommended to read the entire lab requirement before starting....

Quản trị mạng Lab 9-ACL

... CCNA LAB No. 9: ACCESS LIST CONFIGURATION Lab time: 1 session Students are recommended to read the entire lab requirement before starting. ... with PCs in the lab. RouterX(config)#int e0 RouterX(config-if)#ip address 10.2.0.16X 255.255.255.0 RouterX(config-if)#no shut3. Be ... access list RouterX(config)#ip http access-class <access-list>4. Use access-class to deny telnet sessions in routers ...

Quản trị mạng Lab 10 - Frame relay

... Router3(config-if)#frame-relay map ip 192.1 68. 100.2 302 broadcast Router3(config-if)#frame-relay map ip 192.1 68. 100.1 301 broadcast Router2(config-if)#frame-relay ... Inverse-ARP. Router(config-if)#no frame-relay inverse-arp4. You decide to use subinterface point-to-multipoint with this topology to reserve IP address. The IP subnet is 192.1 68. 100.0 ... 192.1 68. 100.3 203 broadcast Router1(config-if)#frame-relay map ip 192.1 68. 100.3 103 broadcast Router1(config-if)#frame-relay map ip 192.1 68. 100.2...

Giáo trình quản trị mạng windows server 2003 (chương 8)

... Quản trị mạng Windows Server 2003 Chương 8 - Sử dụng Group Policy Giáo viên biên soạn: Võ Khôi Thọ Trang 16 of 16 Giáo trình Quản trị mạng Windows Server 2003 Chương 8 - ... Giáo trình Quản trị mạng Windows Server 2003 Chương 8 - Sử dụng Group Policy Chương 8 SỬ DỤNG GROUP POLICY OBJECT (GPO) ĐỂ TRIỂN KHAI ỨNG DỤNG ... Giáo viên biên soạn: Võ Khôi Thọ Trang 10 of 16 Giáo trình Quản trị mạng Windows Server 2003 Chương 8 - Sử dụng Group Policy + Nhấp nút New để tạo một liên kết mới, đặt...

Xem thêm