Quản trị mạng LAB 3 - LAN switching

... 21. Configure vlan on Switch A and Switch B by using the following table: Vlan Vlan Name Portwww.ipmac.com.vn2 Vlan 2 Fa0/ 23 Vlan 3 Fa0 /34 Vlan 4 Fa0/4 The command vlan database ... CCNA LAB No. 3 : LAN Switching Lab time: 1 session Students are recommended to read the entire lab requirement ... Switch A, be sure that information about vlan 5 is updated in vlan database of Switch B. Switch_A(vlan)#vlan 5 Issue Show vlan to view vlan database www.ipmac.com.vnBonus...

Báo cáo đề tài môn quản trị mạng : LAB 12 - Haroxy

...

7
1,311
17

Quản trị mạng LAB 1 - Basic config router

... copy running-config startup-config +Copy file startup-config from router to TFTP server at 192.168.1.2 53 Router#copy startup-config tftp Example: 10-Perform ... Router (config-line)#password cisco +Allow login Router(config-line)#login 4- Configure password for accessing enable mode : 1 234 56 . This password must ... above show command , identify the name of IOS on the router 9- Copy file startup-config from router to TFTP sever at 192.168.1.2 53 (instructor may indicate another iftp server if this one is...

Quản trị mạng Lab 4-5 - RIP & IGRP

... loopback 0 Router(config)# ip address 3. 3 .3. 3 255.255.255.255 Router(config)# ip address 10.10.10 .3 255.255.255.0 Router(config)# ip address 192.168.168 .3 255.255.255.02. Enable RIP on each ... Router(config-router)#network network-number : gõ các mạng kết nối trực tiếp với routerVí dụ: với router R3:Router(config-router)#network 3. 0.0.0Router(config-router)#network 10.0.0.0Router(config-router)#network ... CCNA LAB No. 4-5 : CONFIGURE Static route – RIP – IGRP Lab time: 1 Task 2: RIP1. Đặt địa chỉ cho router: (Ví dụ: router 3) Router> enable...

Quản trị mạng Lab 6 - OSPF & EIGRP

... Router(config-if)#ip summary-address eigrpautonomous-system-number ip-address mask administrative-distance 8. The EIGRP hello interval should be tuning to 10 seconds R1(config-if)#ip ... Router(config-router)#no auto-summary Note : - Automatic summarization may not be the preferred option in certain instances. For example, if there are discontiguous subnetworks auto-summarization ... Rx(config-router)#network 192.x.x.x 0.0.0.0 area 0Task 3: OSPF multi-area 1. Configure OSPF area 1 on interface loopback 0 of router X. Rx(config-router)#network...

Quản trị mạng Lab 7 - InterVLAN

... Sw355 0-2 (config)#vlan 2 Sw355 0-2 (config)#int f0/2 Sw355 0-2 (config-if)#switchport mode access Sw355 0-2 (config-if)#switchport access vlan ... Sw355 0-2 (config)#int f0/4 Sw355 0-2 (config-if)#switchport trunk encapsulation dot1q Sw355 0-2 (config-if)#switchport mode trunk 4. Create 2 VLANs ... e0/0 .3 R4(config-subif)#ip address 172.0 .34 .2 53 255.255.255.0 R4(config)#int e0/0.5 R4(config-subif)#ip address 172.0.45.2 53 255.255.255. 03. ...

Quản trị mạng Lab 8 - NAT

... R-X(config-if)#ip nat inside R-X(config)#int e0 R-X(config-if)#ip nat outside3. Configure static NAT on R-X so that the private ... R-X(config)#int e0 R-X(config-if)#ip address 10.2.0.16X 255.255.255.0 R-X(config-if)#no shut R-X(config)#int ... R-X(config)# access-list 1 permit 100.0.X.0 0.0.0.255 - Define a pool of global addresses to be allocated as needed R-X(config)#ip nat pool <name> 10.2.0.12X 10.2.0.13X netmask...

Quản trị mạng Lab 9-ACL

... PCs in the lab. RouterX(config)#int e0 RouterX(config-if)#ip address 10.2.0.16X 255.255.255.0 RouterX(config-if)#no shut3. Be sure ... RouterX(config)#access-list 100 deny icmp 10.2.0.0 0.0.0.255 host 10.2.0.16X RouterX(config)#access-list 100 permit ip 10.2.0.0 0.0.0.255 10.2.0.16X 0.0.0.0 equal 23 3. Enable web ... CCNA LAB No. 9: ACCESS LIST CONFIGURATION Lab time: 1 session Students are recommended to read the entire lab requirement before starting....

Quản trị mạng Lab 10 - Frame relay

... router 3 ( using PVC between router 1 and router 3 ) Router3(config-if)#frame-relay map ip 192.168.100.2 30 2 broadcast Router3(config-if)#frame-relay ... 192.168.100.1 30 1 broadcast Router2(config-if)#frame-relay map ip 192.168.100 .3 2 03 broadcast Router1(config-if)#frame-relay map ip 192.168.100 .3 1 03 broadcast ... learnedTask 3 :1. Delete hub-and-spoke configuration from task 2.2. Remain the same group as Task 23. Disable Inverse-ARP. Router(config-if)#no frame-relay inverse-arp4. You...

Quản trị mạng WindowsNT (phần 3).

... Quản trị mạng WindowsNT (phần 3) : trang này đã được đọc lần PHẦN III - QUẢN TRỊ FILE I. Thay đổi trong File ManagerThay đổi quan trọng ... HKEY_CLASSES_ROOT.4. Menu Disk- Không còn tuỳ chọn để tạo một system disk nữa .- Connect và Disconnect là các mục riêng biệt trên menu .- Share As - cho phép chia sẻ các thư mục .- Stop Sharing - ngừng chia sẻ ... Options- Cá thể hoá thanh công c - Thanh công cụ có thể được cho phép hoặc không cho phép- Drivebar có thể được cho phép hoặc không cho phép- Open New Windows on Connect - khi nối với ổ mạng, ...

Xem thêm