... (One-Piece)7. Crimp LengthWhen crimping to a full length, Diagram A, place thetop of the ferrule 1/8" below the top of the die fingers.When crimping to a specified crimp length, Diagram B,measure ... assembly and locate with the die fingers.(Approximately 1/8" below top of die. You do notwant a "mushroom effect" on top of coupling.)5. Install die cone if used. 6. Always wear safety ... 1/8" below top of dieand install die cone. (See photo 1).5. Slide the die cone assembly under the ram and depress the crimpswitch. Release the switch immediately when the machine stops.6. Remove...