0
  1. Trang chủ >
  2. Kỹ Thuật - Công Nghệ >
  3. Điện - Điện tử >

DSP applications using C and the TMS320C6X DSK (P5)

DSP applications using C and the TMS320C6X DSK (P5)

DSP applications using C and the TMS320C6X DSK (P5)

... sample is acquired and the delay variables and then the output are calculated using (5.10), and (5.11), respectively. 5.2.3 Direct Form II Transpose The direct form II transpose structure is a ... direct form II sections in cascade. where the constant C in (5.17) is incorporated into the coefficients, and each section is represented by i. For example, N = 4 for a fourth-order transfer function, ... practical standpoint, proper ordering of each second-order section can minimize quantization noise [1–5]. Note that the output of the first section, y 1 (n), becomes the input to the second section....
  • 23
  • 479
  • 0
DSP applications using C and the TMS320C6X DSK (P3)

DSP applications using C and the TMS320C6X DSK (P3)

... available on the C6 x processors. A recent addition to the family of the C6 x processors is the fixed-point C6 4x. An application-speci c integrated circuit (ASIC) has a DSP core with customized circuitry ... processors C3 x /C4 x is not compatible with code for the fixed-point processors C1 x, C2 x, and C5 x /C5 4x. However, the code for the fixed- point C6 2x is compatible with the code for the floating-point C6 7x. C6 2x ... each instruction cycle. Typical DSP applications require several accesses to memory within one instruction cycle. The fixed-point processors C1 x, C2 x, and C5 x are based on a modified Harvard architecture...
  • 41
  • 573
  • 1
DSP applications using C and the TMS320C6X DSK (P4)

DSP applications using C and the TMS320C6X DSK (P4)

... general, the Fourier series coefficients can be written as (4.45) where w(n) is the window function. In the case of the rectangular window function, C n = C n . The transfer function in (4.36) can then ... listing of the C source program FIR .c, which implements an FIR filter. It is a generic FIR program, since the coefficient file included, bs2700.cof (Figure 4.5), specifies the filter’s characteristics. This ... frequency of 10kHz, and a cutoff frequency f c = 1 kHz. From (4.37), where F N = F s /2 is the Nyquist frequency and (4.41) Since the impulse response coefficients h i = C Q-i , C n = C -n , and...
  • 57
  • 478
  • 1
DSP applications using C and the TMS320C6X DSK (P6)

DSP applications using C and the TMS320C6X DSK (P6)

... the DCT, FHT, and the FFT are avail-able in Ref. 9. DSP Applications Using C and the TMS32 0C6 x DSK. Rulph ChassaingCopyright © 2002 John Wiley & Sons, Inc.ISBNs: 0-471-20754-3 (Hardback); ... (on the accompanying disk). This FFT function, used with the C3 1 DSK and the C3 0 EVM, is listed and described in Refs. 13 and 14. The twiddle constants are generated within the program. The ... out (rightclick on the Watch window). Click on +out to expand and view out[0] and out[1] that represent the real and imaginary components, respectively.2. Place a breakpoint at the bracket “}”...
  • 34
  • 473
  • 0
DSP applications using C and the TMS320C6X DSK (P7)

DSP applications using C and the TMS320C6X DSK (P7)

... adaptivesystem can learn the signal characteristics and track slow changes. An adaptive filtercan be very useful when there is uncertainty about the characteristics of a signal orwhen these characteristics ... characteristics change. DSP Applications Using C and the TMS32 0C6 x DSK. Rulph ChassaingCopyright © 2002 John Wiley & Sons, Inc.ISBNs: 0-471-20754-3 (Hardback); 0-471-22112-0 (Electronic)218Adaptive ... PID controller using the TMS32 0C3 1 DSK, Proceedings of the 2000 Texas Instruments DSPS Fest Conference,2000.11. R. Chassaing, Digital Signal Processing Laboratory Experiments Using C and the TMS32 0C3 1...
  • 23
  • 428
  • 0
Tài liệu DSP applications using C and the TMS320C6X DSK (P8) ppt

Tài liệu DSP applications using C and the TMS320C6X DSK (P8) ppt

... branching occurs in cycle 9,after the ADD instruction.5. SUB instruction must start one cycle before the branch instruction, since the loop count is decremented before branching occurs. Therefore, ... If the performance of the code is not adequate, use DSP Applications Using C and the TMS32 0C6 x DSK. Rulph ChassaingCopyright © 2002 John Wiley & Sons, Inc.ISBNs: 0-471-20754-3 (Hardback); ... following cycles:Cycle 1: LDW, LDW (also initialization of count, and the accumulators A7 and B7)Cycle 2: LDW, LDW, SUBCycles 3–5: LDW, LDW, SUB, BCycles 6–7: LDW, LDW, MPY, MPYH, SUB, BCycles...
  • 21
  • 462
  • 0
Tài liệu DSP applications using C and the TMS320C6X DSK (P9) doc

Tài liệu DSP applications using C and the TMS320C6X DSK (P9) doc

... output channel was created to pass to CCS the input signal, the output of both the loop filter and the DCO, and time stamps. CCSbuffers these data so that the data can be accessed by other applications ... Proceedings of the 1998 ASEE Annual Conference, 1998.14. R. Chassaing and B. Bitler (contributors), Signal processing chips and applications, The Electrical Engineering Handbook, CRC Press, Boca ... kbits/sMUX264 DSP Applications and Student Projectssignals constructively add, while the high-frequency signals cancel each other, pro-ducing a low-band signal sampled at 8kHz. The low subband encoder converts...
  • 16
  • 500
  • 0
Tài liệu DSP applications using C and the TMS320C6X DSK (P1) ppt

Tài liệu DSP applications using C and the TMS320C6X DSK (P1) ppt

... product of choice for a number of consumer applications, since they havebecome very cost-effective. They can handle different tasks, since they can be DSP Applications Using C and the TMS32 0C6 x ... place the cursor to one of these files, then to the other while holding the Shift key, and press Open. Click on the “+” symbol on the left of the ProjectFiles window within CCS to expand and ... C6 xdskinit .c, (2) Vectors_11.asm, and (3) C6 xdsk.cmd. For now, the emphasis associated with these files should be on using them.1.5.1 Initialization/Communication File (C6 xdskinit .c) The function comm_intr...
  • 32
  • 473
  • 1
Tài liệu DSP applications using C and the TMS320C6X DSK (P2) pptx

Tài liệu DSP applications using C and the TMS320C6X DSK (P2) pptx

... processor. The maximum level of the input signal to be converted is determined by the speci c ADC circuitry on the codec, which is 3V p-p with the onboard codec. After the captured signal isprocessed, ... modulators. The sampling rate Fsis set by the frequency of the codec master clock MCLK of4096 kHz, such thatA diagram of the AD535 codec interfaced to the C6 711 DSK is shown in Figure 2.3 and is included ... we assume that the ear cannot detect frequencies above 20kHz, we can TTs< 2 121TTs>() Ffs> 2 DSP Applications Using C and the TMS32 0C6 x DSK. Rulph ChassaingCopyright © 2002...
  • 28
  • 369
  • 0
Tài liệu Creating Applications with Mozilla-Chapter 10. RDF, RDF Tools, and the Content Model-P5 pdf

Tài liệu Creating Applications with Mozilla-Chapter 10. RDF, RDF Tools, and the Content Model-P5 pdf

... package. This section contains only one RDF:li the modern theme. The next section gives more information on the theme, such as the author, the theme name, and a description. The chrome:packages ... as the browser, the MailNews component, and the en-US language pack), have manifests describing them in terms of their relation to other packages. The manifests are typically files called contents.rdf, ... sequence using type:_+(seqLength+1). The same type of container setup was described in the section Section 10.3.10, earlier in this chapter. The update function then adds the color, quantity, and...
  • 16
  • 564
  • 0

Xem thêm

Từ khóa: build your own asp net website using c and vb net downloadbuilding web applications using mysql and phpbuild your own asp net website using c and vbbuild your own asp net website using c and vb net pdfdeveloping web applications using mysql and phpobject oriented programming using c and java pdfBáo cáo quy trình mua hàng CT CP Công Nghệ NPVNghiên cứu sự hình thành lớp bảo vệ và khả năng chống ăn mòn của thép bền thời tiết trong điều kiện khí hậu nhiệt đới việt namNghiên cứu tổ chức pha chế, đánh giá chất lượng thuốc tiêm truyền trong điều kiện dã ngoạiđề thi thử THPTQG 2019 toán THPT chuyên thái bình lần 2 có lời giảiGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitQuản lý hoạt động học tập của học sinh theo hướng phát triển kỹ năng học tập hợp tác tại các trường phổ thông dân tộc bán trú huyện ba chẽ, tỉnh quảng ninhThơ nôm tứ tuyệt trào phúng hồ xuân hươngThiết kế và chế tạo mô hình biến tần (inverter) cho máy điều hòa không khíTổ chức và hoạt động của Phòng Tư pháp từ thực tiễn tỉnh Phú Thọ (Luận văn thạc sĩ)Kiểm sát việc giải quyết tố giác, tin báo về tội phạm và kiến nghị khởi tố theo pháp luật tố tụng hình sự Việt Nam từ thực tiễn tỉnh Bình Định (Luận văn thạc sĩ)Quản lý nợ xấu tại Agribank chi nhánh huyện Phù Yên, tỉnh Sơn La (Luận văn thạc sĩ)Tranh tụng tại phiên tòa hình sự sơ thẩm theo pháp luật tố tụng hình sự Việt Nam từ thực tiễn xét xử của các Tòa án quân sự Quân khu (Luận văn thạc sĩ)chuong 1 tong quan quan tri rui roNguyên tắc phân hóa trách nhiệm hình sự đối với người dưới 18 tuổi phạm tội trong pháp luật hình sự Việt Nam (Luận văn thạc sĩ)Giáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtGiáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtGiáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtĐổi mới quản lý tài chính trong hoạt động khoa học xã hội trường hợp viện hàn lâm khoa học xã hội việt namHIỆU QUẢ CỦA MÔ HÌNH XỬ LÝ BÙN HOẠT TÍNH BẰNG KIỀMTÁI CHẾ NHỰA VÀ QUẢN LÝ CHẤT THẢI Ở HOA KỲ