Design and Implementation of a Three-Phase Induction Motor Control Scheme

Design and Implementation of a Three-Phase Induction Motor Control Scheme

Design and Implementation of a Three-Phase Induction Motor Control Scheme

... where all parameters, processes and variables are modelled mathematically. Furthermore, the MATLAB program can convert a MATLAB design into a C-code design in a relatively straightforward manner. ... two types of induction motors: “the squirrel cage induction motor and the “wound motor . An explanation of the advantages and disadvantages of each is given. Essen...
Ngày tải lên : 27/10/2013, 23:15
  • 93
  • 693
  • 1
The Design and Implementation of a Log-Structured File System

The Design and Implementation of a Log-Structured File System

... The bandwidth of each of the five phases is shown separately. Sprite LFS has a higher write bandwidth and the same read bandwidth as SunOS with the exception of sequen- tial reading of a file that ... log as the most up to date ‘‘truth’’ about the state of the data on disk. The main difference is that database systems do not use the log as the final repository for data: a separ...
Ngày tải lên : 12/09/2012, 15:05
  • 15
  • 1.4K
  • 0
Tài liệu Experiences in Design and Implementation of a High Performance Transport Protocol doc

Tài liệu Experiences in Design and Implementation of a High Performance Transport Protocol doc

... copy avoidance • Overlapped IO • Data scattering/gathering • Speculation of next packet Protocol Buffer Protocol Buffer User Buffer Data New Data Experiences in Design and Implementation of a ... the flows have the same end-to-end link capacity – Otherwise, any flow will obtain at least half of its fair share • Does not take more bandwidth than concurrent TCP flow as long a...
Ngày tải lên : 15/01/2014, 15:59
  • 32
  • 580
  • 0
Tài liệu Báo cáo khoa học: "DESIGN AND IMPLEMENTATION OF A LLXICAL DATA BASE " docx

Tài liệu Báo cáo khoa học: "DESIGN AND IMPLEMENTATION OF A LLXICAL DATA BASE " docx

... facilitates memorization. 152 DESIGN AND IMPLEMENTATION OF A LLXICAL DATA BASE Eric Wehrli Department of Linguistics U.C.L .A. 405 Hilgard Ave, Los Angeles, CA 90024 ABSTRACT This paper ... specifications and the implementation of a particular concept of word-based lexicon to be used for large natural language processing systems such as machine translation sy...
Ngày tải lên : 22/02/2014, 09:20
  • 8
  • 535
  • 0
The Design and Implementation of a Sequence Database System * docx

The Design and Implementation of a Sequence Database System * docx

... object-relational database system Illustra [I11941 provides database support for time-series data along with relational data. A time-series is an ADT(Abstract Data Type) value implemented a& amp; a large ... Catalog Management: Each E-ADT can provide catalogs that maintain statistics and store schema information. Further, certain values may be named. Query Language: An E-ADT c...
Ngày tải lên : 16/03/2014, 16:20
  • 12
  • 568
  • 0
Real-Time Digital Signal Processing - Chapter 5: Design and Implementation of FIR Filters

Real-Time Digital Signal Processing - Chapter 5: Design and Implementation of FIR Filters

... compromise and accept a more gradual cutoff between passband and stopband, as well as specify a transition band between the passband and stopband. The design is based on magnitude response specifications ... can specify the relative importance of each band. For example, there would be less ripples in the pass- band than in the stopband. A variety of software packages are com...
Ngày tải lên : 23/10/2013, 22:15
  • 59
  • 590
  • 0
Design and Simulation of A CMOS-MEMS Accelerometer

Design and Simulation of A CMOS-MEMS Accelerometer

... major parameters of the device. Only the ratio of parasitic capacitance and sensing capacitance can be measured, and the estimated value is calculated assuming a total sensing capacitance of 60fF. ... of 60fF. Parasitic capacitance and mismatch of sensing capacitance is measured in a way as shown in Figure 5.4. The capac- itance ratios are derived from the ratios of driv...
Ngày tải lên : 27/10/2013, 23:15
  • 40
  • 588
  • 1
Real-Time Digital Signal Processing - Chapter 6: Design and Implementation of IIR Filters

Real-Time Digital Signal Processing - Chapter 6: Design and Implementation of IIR Filters

... The passband ripple is less than 3 dB and the stopband attenuation is at least 30 dB by 50 Hz out on both sides of the passband. The MATLAB script (exam6_13.m in the software package) for designing ... a, Fs) where bz and az are the numerator and denominator coefficients of a digital filter, Fs is the sampling rate, and b and a represent coefficients of the analog filter....
Ngày tải lên : 28/10/2013, 05:15
  • 62
  • 721
  • 0

Xem thêm

Từ khóa: