... covers the general requirements for fiber optic telecommunication
cables used for inter-building backbone in duct, direct buried and lashed aerial installation.
1.2 Cable Description
1) Jelly ...
section shall be performed at 1550nm for single mode fiber (SM) and at 1300nm for multi
mode fiber (MM).
Table 5. The Mechanical and Environmental Performance of the Cable
ITEMS
TES...
... KRSI -JF- 510C-GSP
Page 1 of 8
TECHNICAL SPECIFICATION
LOOSE TUBE DESIGN,
SINGLE JACKET/ SINGLE ARMOR, JELLY-FILLED,
F/O CABLE
KRSI -JF- 510C-GSP
Page 2 of 8
1.
SCOPE
1.1
... breakage
KRSI -JF- 510C-GSP
Page 6 of 8
Table 5. The Mechanical and Environmental Performance of the Cable (continued)
ITEMS
TEST METHOD AND
ACCEPTANCE CRITERIA
Cable Twist Test
# Test method: TIA/EIA-45 5-8 5...
... marking
6.2 Cable Re-marking
The re-marking shall be indent-marked, preferably with yellow characters, on the outer
cable sheath. Any cable that contains two sets of cable markings shall ...
PERFORMANCE AND TESTS
5.1 Temperature Range
For the cables covered by this specification, the following temperature ranges apply:
Operation : -2 0°C to +60°C
Installation...