... đông, lò vi sóng sẽ tự
chọn thời gian rã đông, chế độ năng lợng phù hợp.
Trang 3: Chuyển đổi công thức nấu ăn
Microwave Cooking:
Tất cả các công thức nấu ăn cho lò vi sóng đợc vi t dùng cho lò có ... chỉ dẫn của nhà sản xuất) có thể sử dụng
trong lò vi sóng.
Hãy để lót tay ở chỗ thuận tiện. Mặc dù những đồ đựng an toàn với sóng vi
ba, không bị năng lợng vi ba là...
... Lời khuyên khi sử dụng lò vi sóng
Lò vi sóng là một thiết bị tiện dụng trong nhà bếp, tuy nhiên, vi c sử dụng thiết bị
này như thế nào để đạt hiệu quả tốt ... bằng
lò vi sóng, cần cho thêm một cốc nước trắng vào lò. Vi c này sẽ hạn chế tình trạng
ống magnetron (thiết bị tạo ra sóng viba – nhân tố làm chín thức ăn) bị hư hao.
Không dùng lò vi ba ... ướt...
... bandpass filters, consider the bandpass filter
depicted in Figure 3.15(b), which has been designed previously for a Butterworth
response with a passband from 1 to 2 GHz. Assume the equal Q
u
for all ... filter. It should be mentioned that not only
does the passband insertion loss increase and the selectivity become worse as the Q
u
is decreased, but it also can be shown that for a given Q
u
,...
... 4.10(h).
These microstrip patch resonators can be analyzed as waveguide cavities with mag-
netic walls on the sides. The fields within the cavities can be expanded by the
TM
Z
nm0
modes, where z is perpendicular ... expressions also provide accuracy better than one percent. If more accurate
values are needed, an iterative or optimization process based on the more accurate
analysis models desc...
... on the other end, resulting in a virtual
grounding. Therefore, the physical groundings of the resonators in Figure 5.23(a)
may be removed and replaced with the virtual groundings produced by the ... output.
can only be electrically equivalent to the combline filter in the vicinity of the mid-
band frequency, and its stopband behavior is different from that of the combline fil-
ter.
Similar to...
... Filters
Highpass filters constructed from quasilumped elements may be desirable for many
applications, provided that these elements can achieve good approximation of de-
sired lumped elements over the entire ... = 1 to n
where b
i
are the susceptance slope parameters of series parallel resonators.
It is obvious that for a chosen lowpass prototype, with known element values, the
desired reacta...