Lab 3 lecture 3 rainfall analysis
Lab 3 lecture 3 rainfall analysis
...
- 4
- 926
- 2
Quản trị mạng LAB 3 - LAN switching
... table: Vlan www.ipmac.com.vn Vlan Name Port Vlan Vlan Vlan Fa0/2 Fa0 /3 Fa0/4 The command vlan database can be used in the Privileged EXEC mode to enter into VLAN configuration mode A VLAN name ... Switch_A#vlan database Switch_A(vlan)#vlan vlan_number Switch_A(vlan)#exit Issue Show vlan to view configuration : Upon exiting, the VLAN is applied to the switch The next step is to assign the VLAN ... switch: Switch(vlan)#vtp {client | server | transparent} Switch_A(vlan)#vtp server Switch_B(vlan)#vtp client Create vlan on Switch A, be sure that information about vlan is updated in vlan database...
- 6
- 662
- 2
Lab 3.1.9c Rollover Cable Construction
... the cable ends • An RJ-45 to DB9 female terminal adapter, available from Cisco • Cabling continuity tester • Wire cutters Step Use the table as a reference to help create a rollover console cable ... Step 10 Test the finished cable Have the instructor check it How is it possible to tell if the cable is functioning properly? 3-3 CCNA 1: Networking Basics v 3.0 - Lab 3.1.9c Copyright 2003, ... now in order 2-3 CCNA 1: Networking Basics v 3.0 - Lab 3.1.9c Copyright 2003, Cisco Systems, Inc Step Place an RJ-45 plug on the end of the cable, with the prong on the underside and the orange...
- 3
- 369
- 0
Lab 3.3.3 Configuring PPP Authentication
... reload instructions at the end of this lab Perform those steps on all routers in this lab assignment before continuing 2-6 CCNA 4: WAN Technologies v 3.0 - Lab 3.3.3 Copyright 2003, Cisco Systems, ... steps, finish the lab by doing the following: • • Turn the router off • 4-6 Logoff by typing exit Remove and store the cables and adapter CCNA 4: WAN Technologies v 3.0 - Lab 3.3.3 Copyright ... get started! Press Enter Now the router is ready for the assigned lab to be performed 5-6 CCNA 4: WAN Technologies v 3.0 - Lab 3.3.3 Copyright 2003, Cisco Systems, Inc Router Interface Summary...
- 6
- 441
- 2
Lab 3.1.9d Rollover Cable Construction
... the cable ends • An RJ-45 to DB9 female terminal adapter, available from Cisco • Cabling continuity tester • Wire cutters Step Use the table as a reference to help create a rollover console cable ... Step 10 Test the finished cable Have the instructor check it How is it possible to tell if the cable is functioning properly? 3-3 CCNA 1: Networking Basics v 3.0 - Lab 3.1.9d Copyright 2003, ... now in order 2-3 CCNA 1: Networking Basics v 3.0 - Lab 3.1.9d Copyright 2003, Cisco Systems, Inc Step Place an RJ-45 plug on the end of the cable, with the prong on the underside and the orange...
- 3
- 297
- 0
Lab 3.1.9d Crossover Cable Construction
... end of the cable using the 568-A scheme to finish the crossover cable 3-4 CCNA 1: Networking Basics v 3.0 - Lab 3.1.9d Copyright 2003, Cisco Systems, Inc Step 11 Test the finished cable Have ... Solid wire is fine for cable runs that are punched down into jacks Step Strip 5.08 cm (2in.) of jacket off one end of the cable 2-4 CCNA 1: Networking Basics v 3.0 - Lab 3.1.9d Copyright 2003, ... it Standard lengths for this cable are 1.83 m (6 ft) and 3.05 m (10 ft) Step Cut a piece of stranded UTP cable to the desired length Use stranded cable for patch cables because it is more durable...
- 4
- 302
- 0
Lab 3.3.4 Verifying PPP Configuration
... encapsulation type to PPP by typing encapsulation ppp at the interface serial configuration mode prompt on both routers Brasilia(config-if)#encapsulation ppp Warsaw(config-if)#encapsulation ppp b What did ... v 3.0 - Lab 3.3.4 Copyright 2003, Cisco Systems, Inc • • Turn the router off • 4-6 Logoff by typing exit Remove and store the cables and adapter CCNA 4: WAN Technologies v 3.0 - Lab 3.3.4 Copyright ... interface serial Encapsulation _ Step Turn on PPP debugging Turn on the PPP debug function on both routers by typing debug ppp tasks at the privileged exec mode prompt Step Change...
- 6
- 433
- 2
Lab 3.1.3 Configuring Router Passwords
... Enter The router is ready for the assigned lab to be performed 5-6 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3.1.3 Copyright 2003, Cisco Systems, Inc Router Interface Summary Router Ethernet ... logoff by typing exit Turn the router off 4-6 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3.1.3 Copyright 2003, Cisco Systems, Inc Erasing and reloading the router Enter into the privileged ... will not be displayed on the line: GAD>enable Password:class GAD# 3-6 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3.1.3 Copyright 2003, Cisco Systems, Inc Note: the enable secret password...
- 6
- 451
- 0
Lab 3.1.9e Crossover Cable Construction
... the other end of the cable using the 568-A scheme to finish the crossover cable Step 11 Test the finished cable Have the instructor check it How is it possible to tell if the cable is functioning ... lengths for this cable are 1.83 m (6 ft) and 3.05 m (10 ft) 2-4 CCNA 1: Networking Basics v 3.0 - Lab 3.1.9e Copyright 2003, Cisco Systems, Inc Step Cut a piece of stranded UTP cable to the desired ... 5.08 cm (2in.) of jacket off one end of the cable Step Hold the four pairs of twisted cables tightly where the jacket was cut away Reorganize the cable pairs into the order of the 568-B wiring...
- 4
- 263
- 0
Lab 3.1.9e UTP Cable Purchase
...
- 1
- 312
- 0
Lab 3.3.4.1: Catalyst 4000 Password Recovery
... new password: Password changed DLSwitch1> (enable) set enablepass Enter old password: (Because you not currently have a password, just hit enter) Enter new password: Retype new password: Password ... Attempt to telnet into the Catalyst switch You will not be able to get in because you not know the passwords The Catalyst 4000 series of switches deals with password recovery much differently ... you will reset the password using the set password and set enablepass commands When prompted for the current passwords, hit enter DLSwitch1> (enable) set password Enter old password: (just hit...
- 3
- 473
- 2
Lab 3.1.3 Resistance Measurement
... Prior to starting the lab, the teacher or lab assistant should have one multimeter available for each team and various networking-related items for testing resistance Work in teams of two ... cable Step Select the Resistance Scale on the Multimeter Fluke 110: Resistance Measurements: Move the rotary selector to the Omega symbol for Ohms (Ω) in order to measure resistance Use the Range ... need for the exact amount of resistance Resistance Measurements: Move the rotary selector to the Omega symbol for Ohms (Ω) The Omega symbol is the setting to measure resistance Press the button...
- 3
- 312
- 0
Lab 3.1.4 Using Router show Commands
... d Is show one of the options available? _ Step Display help for the show command a Enter the show ? command The router responds with the show subcommands available in ... the router prompt The router responds with all commands available in user mode b What did the router reply with? c Are all router commands available at the current prompt? ... three user mode show subcommands show Subcommand Description Step Display IOS version and other important information with the show version command a Enter the show version command The router will...
- 4
- 377
- 0
Lab 3.1.9f UTP Cable Purchase
...
- 1
- 283
- 0
Lab 3.1.9f Communications Circuits
... instructor or invent a message Reflection What issues arose as the communications system was being built, that apply to data communications between computers? ... _ _ 2-2 CCNA 1: Networking Basics v 3.0 - Lab 3.1.9f Copyright 2003, Cisco Systems, Inc ... _ _ _ Analyze the communications system in terms of the OSI layers _ ...
- 2
- 290
- 0
Từ khóa: báo cáo lab 3 ph002lab 3 nhập môn mạch sốmuch ado about nothing act 2 scene 3 song analysis7 3 5 analysis of state machines with j k flip flops11 7 3 force analysis default equations 11153 gaussian analysis of afocal lenses3 dns analysis for interaction of isotropic turbulence and chemical reactions2 3 data analysislecture ready 3 book answer key 2 cdsccna 3 lab manual answersmicrosoft sql server 2000 analysis services service pack 3overlay analysis in arcgis 9 3much ado about nothing act 2 scene 3 benedick monologue analysisccna discovery 4 1 3 student lab manual answersthe picture of dorian gray analysis chapter 3Một số giải pháp nâng cao chất lượng streaming thích ứng video trên nền giao thức HTTPBiện pháp quản lý hoạt động dạy hát xoan trong trường trung học cơ sở huyện lâm thao, phú thọGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitĐỒ ÁN NGHIÊN CỨU CÔNG NGHỆ KẾT NỐI VÔ TUYẾN CỰ LY XA, CÔNG SUẤT THẤP LPWANNGHIÊN CỨU CÔNG NGHỆ KẾT NỐI VÔ TUYẾN CỰ LY XA, CÔNG SUẤT THẤP LPWAN SLIDEPhát hiện xâm nhập dựa trên thuật toán k meansNghiên cứu, xây dựng phần mềm smartscan và ứng dụng trong bảo vệ mạng máy tính chuyên dùngĐịnh tội danh từ thực tiễn huyện Cần Giuộc, tỉnh Long An (Luận văn thạc sĩ)Sở hữu ruộng đất và kinh tế nông nghiệp châu ôn (lạng sơn) nửa đầu thế kỷ XIXChuong 2 nhận dạng rui roBT Tieng anh 6 UNIT 2Tranh tụng tại phiên tòa hình sự sơ thẩm theo pháp luật tố tụng hình sự Việt Nam từ thực tiễn xét xử của các Tòa án quân sự Quân khu (Luận văn thạc sĩ)Giáo án Sinh học 11 bài 15: Tiêu hóa ở động vậtchuong 1 tong quan quan tri rui roGiáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtGiáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtBÀI HOÀN CHỈNH TỔNG QUAN VỀ MẠNG XÃ HỘIHIỆU QUẢ CỦA MÔ HÌNH XỬ LÝ BÙN HOẠT TÍNH BẰNG KIỀM