AN0889 VF control of 3 phase induction motors using PIC16F7X7 microcontrollers

SIEMENS SIMATIC power controller and 3 phase stepping motors

... SIMOSTEP 1FL3061 10 Nm 4.1 A SIMOSTEP 1FL3062 15 Nm 4.8 A Figure 1-1 Reference literature Order number 1FL3041-0AC310BG0 1FL3042-0AC310BG0 1FL30 43- 0AC310BG0 1FL3061-0AC310BG0 1FL3062-0AC310BG0 FM-STEPDRIVE ... following 3- phase stepping motors: Table 1-1 SIMOSTEP series stepping motors Motor type Nominal torque Nominal current SIMOSTEP 1FL3041 Nm 1.8 A SIMOSTEP 1FL3042 Nm 2.0 A SIMOSTEP 1FL30 43 Nm 2 .3 A ... specifications 3- 1 3. 1 Electrical data 3- 2 3. 2 Mechanical data .3- 5 3. 3 Ambient conditions 3- 5 3. 4 Applicable standards, regulations, laws 3- 6 Signal description...

Báo cáo " Experiment for Bending Analysis of 3-phase Composite Plate in Ship Structure " doc

... Tamuz, G.A Teterc, Strength of composite materials, Riga, “Zinatie”, 1980 Nguyen Dinh Duc, Dinh Khac Minh, Bending analysis of three-phase polymer composite plates reinforced by glass fibers and ... 6282:2008 for testing and manufacturing ship made of composite polymer reinforced by glass fibbers, Transportation Publishing House, Hanoi, 2008 Tran Ich Thinh, Composite material, mechanics and structure, ... modules for 3-phase composite are calculated step by step by 2-phase model as in [5,6,8] We also carried out the experiments for 3-phase composite s elastic modules [9] After determining ( G...

Báo cáo nghiên cứu khoa học: " Experiment for Bending Analysis of 3-phase Composite Plate in Ship Structure" potx

... Tamuz, G.A Teterc, Strength of composite materials, Riga, “Zinatie”, 1980 Nguyen Dinh Duc, Dinh Khac Minh, Bending analysis of three-phase polymer composite plates reinforced by glass fibers and ... code TCVN 6282:2008 for testing and manufacturing ship made of composite polymer reinforced by glass fibbers, Transportation Publishing House, Hanoi, 2008 Tran Ich Thinh, Composite material, ... modules for 3-phase composite are calculated step by step by 2-phase model as in [5,6,8] We also carried out the experiments for 3-phase composite s elastic modules [9] After determining ( G...

fault diagnosis of induction motors using signal processing based methods and optimal feature selection

... 진단 Fault Diagnosis of Induction Motors using Signal Processing based Methods and Optimal Feature Selection 지도교수 이홍희 이 논문을공학박사학위 논문으로 제출함 2008 년 12 월 울산대학교 대학원 전기전자정보시스템공학부 웬옥투 Fault Diagnosis of ... Diagnosis of Induction Motors using Signal Processing based Methods and Optimal Feature Selection Ngoc-Tu Nguyen A thesis submitted to the School of Electrical Engineering in fulfillment of the thesis ... faults, signal based processing methods for monitoring the condition of induction motor, the optimal feature selection using distance based criterion is considered to remove the irrelevant and redundant...

Analysis, design and control of permanent magnet synchronous motors for wide speed operation

... Torque performance of SVM based DTC and Current Control for a wide speed operation 169 6.26 Power performance of SVM based DTC and Current Control for a wide speed operation ... Control of IPMSM in Wide Speed Operation 24 Outline of the Thesis 25 Analysis of Interior Permanent Magnet Synchronous Motors for Wide- Speed Operation ... presents aspects of analysis, design and control of permanent magnet synchronous motors (PMSMs) for wide- speed operations An analytical method has been developed based on d- and q- axis equivalent...

Tài liệu tiếng anh Điện tử công suất mạch MERS A new automatic voltage regulator of self excited induction generator using SVC magnetic energy recovery switch

... Usuki, T Kitahara, R Shimada, ”Improved performance of induction motor using magnetic energy recovery switch , PCC Nagoya, 2007 [10] J .A Wiik, F Danang Wijaya, R Shimada, ”An innovative series ... induction generator , AIEE Trans pp 540-545, May 1935 [3] T Ahmed, O Noro, E Hiraki, M Nakaoka, ”Terminal Voltage Regulation Characteristics by Static Var Compensator for a Three-Phase Self- Excited ... reduction of SVC MERS with ﬁxed capacitor −200 Istator −8 Iload Ifixed capacitor Iload Ifixed capacitor Isvc mers 200 100 2.8 Time (s) 2.9 Isvc mers −8 Capacitor voltage (V) −8 −8 Capacitor voltage...

DC bus control of variable speed wind turbine using a buck boost converter

... Hydro-Québec, Natural Resources Canada and the Natural Sciences and Engineering Research Council of Canada VII [1] REFERENCES C.L Kana; M Thamodharan and A Wolf; “System management of a wind- energy converter , ... a buck boost converter inserted between the rectifier output and the DC bus The control relationship between generator speed and the DC bus voltage is used to change the apparent DC bus voltage ... tip -speed ratio Fig.3 : Connection diode rectifier circuits to the generator Unlike constant -speed control, a variable- speed control can adjust the speed of the turbine as the wind speed changes,...

Design optimization of permanent magnet synchronous motors using response surface analysis and genetic algorithm

... The development of Permanent Magnet Machines 1.1.2 Features of permanent magnet motors Permanent magnet synchronous motors iii 1.2.1 Structures and operating principles ... with the analysis and design of buried type Interior Permanent Magnet Synchronous Motors (IPMSM) The objective is to develop a design optimization procedure for this type of motors that is more ... List of Figures 1.1 Magnetic characteristics of the main class of permanent magnets [2] 1.2 Evolution of the magnetic material during the 20th century [2] 1.3 Partial demagnetization of a permanent...

Design and Implementation of a Three-Phase Induction Motor Control Scheme

... processes and variables are modelled mathematically Furthermore, the MATLAB program can convert a MATLAB design into a C-code design in a relatively straightforward manner Hence, this stage of the ... two-phase currents to generate a means of instantaneously controlling the torque and flux Field-orientated controllers require control of both magnitude and phase of the AC quantities and are, ... the induction motor s many advantages are clearly explained Wildi also presents the two types of induction motors: “the squirrel cage induction motor and the “wound motor An explanation of the...

POWER ELECTRONIC CONTROL OF INDUCTION MOTORS ppt

... the required rms value of the fundamental harmonic of the output phase to neutral voltage of the AC-AC voltage controller Induction machine Fig 6.5: Speed control of an induction machine by stator ... power supply source for V/f control of induction motors The second one, current source inverter (CSI), is beyond the scope of interest here Principle of operation of a threephase VSI is explained ... prevailing one in closed-loop control of induction motors fed from PWM inverters Explanation of this method however requires at first the introduction of the notion of the space vector Let us at...

Báo cáo y học: "Control of hyperuricemia in subjects with refractory gout, and induction of antibody against poly(ethylene glycol) (PEG), in a phase I trial of subcutaneous PEGylated urate oxidase" potx

... neutralizing IgG antibodies against ADA protein [26,27] Antibodies against L-asparaginase, and against interferons α- 2a and α-2b, have been observed in a relatively small percentage of patients ... assays and participated with MSH and JSS in analyzing the data reported ES was the clinical coordinator, and JSS was the Principal Investigator, of the clinical trial JSS and MSH participated (with ... indicating that antibody against PEG- Efficacy of PEG-uricase In this first phase I trial, single subcutaneous injections of to 24 mg of PEGylated mammalian uricase were administered to 13 markedly...

SIMULATION AND SPEED CONTROL OF INDUCTION MOTOR DRIVES

... P a g e Simulation and Speed Control of Induction Motor Drives 2012 CHAPTER ANALYSIS OF VARIOUS METHODS FOR SPEED CONTROL OF IM The various methods of speed control of 3- Induction motor are ... Simulation and Speed Control of Induction Motor Drives 2012 Figure 3.13: Torque -Speed Characteristics for machine parameters as in Fig 3.8 13 | P a g e Simulation and Speed Control of Induction Motor Drives ... Simulation and Speed Control of Induction Motor Drives 2012 Figure 3.25:Torque -Speed Characteristics for machine parameters as in Fig 3.20 21 | P a g e Simulation and Speed Control of Induction Motor Drives...

Xem thêm