... SYNTHESIS AND FUNCTIONALIZATION OF MICRO/ NANO- PARTICLES FOR MALIGNANT CELLS DETECTION AND ELIMINATION HU FEIXIONG (B E., M S., Tianjin University) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR ... technique for preparing antibacterial microparticles has the advantages of ease of mass production and scale up, and the microparticles possess stability for re...
... understand near- field optical scattering by micro/ nano- particles and apply Mie theory for numerical simulation; • To understand plasmonic effect by metallic nanoparticle in near field; • To explore near- field ... to the optical near- field induced by small particles under laser irradiation: (1) optical resonance (Sphere Cavity Resonance) and near- field...
... ISSUES AND CHALLENGES IN THE APPLICATION OF MICRO- BALL BEARING FOR SILICON BASED MICROSYSTEMS ROBIN PANG SUI TING (B Eng (Hons.), NUS) A THESIS SUBMITTED FOR THE DEGREE OF MASTER OF ENGINEERING ... of the micro- ball) and the operating conditions (RPM of the Si plate) for the groove-less ball bearings setup Thus, a micro- ball can rem...
... Culture Applications 13 2.1.4 Nanofiber Modification for Cell Culture Applications 15 2.1.4.1 Doping of Bioactive Molecules 16 2.1.4.2 Nanofiber Surface Modification 17 2.2 Biomaterials Design for ... studies of bio- functionalization of electrospun nanofibers, which can serve as cell culture scaffolds that can promote cell- substrate interactions and are bioac...
... evidence on the use of upconversion fluorescent nanoparticles as a multifunctional platform for simultaneous imaging, detection and delivery of siRNA x LIST OF TABLES Table 1.1 Upconversion particles ... developed and used for imaging, detection and delivery of siRNA Silica coated NaYF4 upconversion nanoparticles co-doped with lanthanide ions...
... information The unevenly sampled RR intervals were interpolated using cubic splines The instantaneous heart rate (IHR) is the inverse of the RR interval and shows the variability of heart rate ... the dataset in a set of N − training data and one test data So, for events (seizure and nonseizure) at a time, the fc (t) values for seizure were compared with those from nons...
... However, the points raised are likely to be valid for other types of tumors For all these, the addition of appropriate cancer- free control materials to the screening panels might help in the identification ... regions adjacent to the actual tumor as the sole control is probably insufficient for the identification and selection of methylation markers for...
... beam lithography and the Micromachining Techniques for Fabrication of Micro and Nano Structures minimal feature size accessible by these techniques is typically limited to tens of nanometers, thus ... 3-D sensor structures (Kim, 2008, 19 99) 2 Micromachining Techniques for Fabrication of Micro and Nano Structures In this chapter, the focused ion b...
... Techniques for Fabrication of Micro and Nano Structures Fig Depth profiles for 35 5 nm Nd:YAG laser micromachining of sapphire with fluence of 9.27 J/cm2 and virious scan speeds 3. 2 Laser micromachining ... which emits at 30 8 nm, is prototypical of these in which a pulsed electric discharge ionizes the Xe into a Xe+ state and 38 Micromachining Techniqu...
... 50 Micromachining Techniques for Fabrication of Micro and Nano Structures Fig The ablation rates for laser micromachining versus laser fluences for Pyrex with different ... 64 Micromachining Techniques for Fabrication of Micro and Nano Structures and (c), respectively There is a frequency interval, in which one effective parameter is negative ε′ f...
... applications of this laser micromachining technique will also be discussed 96 Micromachining Techniques for Fabrication of Micro and Nano Structures 3.1 Trench micromachining in air The laser micromachining ... subsection 100 Micromachining Techniques for Fabrication of Micro and Nano Structures 3.2 Trench micromachining in DI water The charac...
... Zeng, et al., 2003] A threshold of 33.8 mJ/cm2 is reported for PMMA at 193 nm by Chen, Y-T, et al (2005) 114 Micromachining Techniques for Fabrication of Micro and Nano Structures Group C=C C=O Si-Si, ... led in the microvia technology, are also key figures in the OI 116 Micromachining Techniques for Fabrication of Micro and Nano Structures deployment [...
... compositions of coatings are known 168 Micromachining Techniques for Fabrication of Micro and Nano Structures Fig 14 Faults of adhesion and uniformity of coatings It is obvious that the price for micro ... 156 Micromachining Techniques for Fabrication of Micro and Nano Structures Conclusion Micro ED milling is shown as a potential fabricati...
... Machining of only a few trenches to the final depth led to cold work hardening Subsequently, bending of narrow walls and 176 Micromachining Techniques for Fabrication of Micro and Nano Structures ... { 110} plane, etching will stop at the moment when faces with {111} planes coincide, i.e in the vertex formed by a {100 } plane 188 Micromachining Techniques for F...
... Published: 30 Aug 2005 (www.frost.com) 206 Micromachining Techniques for Fabrication of Micro and Nano Structures range of capabilities from macro- to micromachining in most materials, which is ... processed in TMAH and photographs were taken at the prescribed times Fig 19 shows how rapidly the flat bottom formed 198 Micromachining Techniques for Fabrication...