... viêm đờng hô hấp mạn tính, các
chỉ ti u lâm sàng thay đổi không rõ lắm so với trạng thái sinh lý bình
thờng. Cụ thể là:
- Thân nhiệt của chó bị bệnh viêm đờng hô hấp mạn tính hầu nh không
tăng, ... nhiệt, tần số hô hấp và tần số mạch đập của chó nghiệp vụ mắc bệnh viêm
đờng hô hấp thể mạn tính
Thân nhiệt (
0
C)
Tần số hô hấp
(lần/phút)
Tần số mạch đập...
... thể học rất nhanh và luôn ñòi hỏi các thứ mới lạ, thích
gặm những ñồ vật bé nhỏ
2.3. Cấu tạo và chức năng của hệ hô hấp ở chó.
2.3.1. Cấu tạo của hệ hô hấp ở chó
+ Xoang mũi là phần ñầu của ... ñược sử dụng làm chó nghiệp vụ”.
2. Mục ñích nghiên cứu.
- Xác ñịnh ñược thực trạng bệnh viêm ñường hô hấp trên một số giống chó
- ðưa ra ñược biện pháp phòng và...
... highest optimiza-
tion level (register, local, global, and file) for faster execution speed. The -o2
option invokes the second level (by default) of optimization (without the file
optimization available ... 80983e. Note that there is much initialization code added
from compiling. The STI instruction causes each resulting output value to be
stored in consecutive memory, starting at the address...
... LDI instruc-
tion. The addition instruction is executed four times (repeated three times). Af-
ter each execution, AR0 is postincremented to point at the next-higher memory
location where the ... of code starting with the
CALL FILTER instruction, including the store integer STI instruction, is exe-
cuted 11 times (repeated RC = 10 times). Within this block of code, a subroutine
FILTER ... The...
... again
RETS ;branch from subroutine
FIGURE 3.6 (continued)
AICCOM31.ASM. A C version of the AIC communication program is described
later. These routines enable the initialization of the AIC for input/output. ... -> 808000h
LDI 1,R0 ;timer CLK=H1/2*(AIC master CLK)
STI R0,*+AR0(28h) ;timer period reg(TCLK0=6.25 MHZ)
LDI 03C1h,R0 ;init timer global register
STI R0,*+AR0(20h) ;reset timer
LDI...
... implement (4.54) for time n + 1. The first mul-
tiplication consists of h(N – 1)x(n –(N – 2)), since AR1 is initially pointing at
x(n –(N – 2)) at time n + 1. Similarly, at time n + 2, (4.53) becomes
4.7 ... convolution
equation. Effects of window functions on the characteristics of FIR filters are
covered.
4.1 INTRODUCTION TO THE z-TRANSFORM
The z-transform is utilized for the analysis of di...
... “.data”,0x809900 ;starting addr of data section
.start “.text”,0x809C00 ;starting addr of text section
.include “AICCOM31.ASM” ;include AIC comm routines
.data ;assemble into data section
AICSEC .word ... cosine function:
1. Set Y1 = 0.809017 since y(1) = A – (A/2), and Y0 = x(0) = 1.0
2. Add the instruction ADDF @B,R1 after the first multiplication MPYF3
instruction before the loop section o...
... Since (6.3) is an equation in terms of a complex exponential, for
each specific k there are approximately N complex additions and N complex
multiplications. Hence, the computational requirements ... radix-4
ț Decimation or decomposition in frequency and in time
ț Programming examples
The fast Fourier transform (FFT) is an efficient algorithm that is used for con-
verting a time-domain signal...
... FIR routine
FIGURE 7.18 Program listing for adaptive predictor (ADAPTP.ASM).
(continued on next page)
809802. The FIR filter routine FILT and the adaptation routine ADAPT are in
separate sections ... 0-471-20065-4
9. Within the adaptation routine, the first multiply instruction yields R0,
which contains the value e(n)x
1
(n) for a specific time n. The second multiply
instruction yields R0, w...