... ANALYSISeBook for You10IEEE 24 – N-1 CONTINGENCY ANALYSISeBook for YouAC Contingency Analysis Report 18 • Go to Power Flow, Reports, AC Contingency reports to N-1 CONTINGENCY ANALYSISreports to...
... Exciter Models in PSS®E • Identification of Typical ExciterseBook for YouDC Excitation Systems 18 TYPES OF EXCITERSDC Excitation Systems Separately excited exciter (requires a “ilt” it ... values E1and E2shouldThe field voltage values E1and E2 should normally be chosen near the knee of the exciter’s magnetization curve and near the exciter ceilingeBook for...
... for calculationFormat to be written in DYR fileeBook for YouSalient Pole Generator Model 18 DYNAMIC FILE(GENSAL)STATEs used for calculationFormat to be written in DYR fileeBook...
... 4Load Flow N-0: Line O MONNHABE (47504450)Line O MON –NHABE (4750 –4450) 418 MVA (20.2%)Low voltages at O MON below limitsLow voltages at O MON below limitsN-1:N-1: ... a trip of the generator after 100 ms (successful and unsuccessful auto-reclose)eBook for You 18 SCENARIO 4: FAULTS AT OSCENARIO 4: FAULTS AT O MON & NHABEeBook for YouLoad...
... Initialization Errors 25DYNAMICS DATA VERIFICATIONGovernors• Bus 18 • Mbase= 448MVA• Pmax= Vmax*Mbase= 0.85*448=380.8 MW < Pinit (400MW)• Therefore, change ... AIEEE 24 –BUILDING A DYNAMICS DATA FILEeBook for YouDynamics Data File Verification 18 DYNAMICS DATA VERIFICATIONDynamics Data File Verification•Prepare the IEEE 24 saved...
... frequency relays (loads and t)generators) Prepare for transient simulation and choose the following channelschoose the following channels Machine anglesBus voltageBus voltage ... voltage relays (loads and t)generators) Prepare for transient simulation and choose the following channelschoose the following channels Machine anglesBus voltageBus voltage ... the PV Analysis window and create thecreate the distribution factor file• Make sure to choose the right settings• Select the source and sink subsystemseBook for You10IEEE 24–QVANALYSISIEEE...