...
router rip
network 131 .108.0.0
interface serial 0
ip rip send version 1
ip rip receive version 1
interface fddi 1
ip rip send version 2
ip rip receive version 2
interface ethernet 1
ip rip ... [20/40] via 150.150.5 .31 , 00:20: 23, Fddi2/0
204.10.10.1 /32 [20 /30 ] via 150.150.5 .31 , 01:20: 23, Fddi2/0
0.0.0.0/0 [20/20] via 150.150.5 .31 , 00:20: 23, Fddi2/0
In the sh...
... Professional Development Large-Scale
IP Network Solutions
Khalid Raza
Mark Turner
Publisher: Cisco Press
First Edition November 09, 1999
ISBN: 1-57870-084-1, 576 pages
CCIE Professional Development: ... Development: Large-Scale IP Network Solutions
is a core preparation textbook for the CCIE Routing and Switching
exam track. In addition to CCIE preparation,...
... corruption. Routing in IP networks is usually based on an IP
destination address.
Figure 3- 1. Packet Switching
59
Packet routers in IP networks are able to detect IP packet errors, but ... serial line addresses are 131 .108.2.0 and 255.255.255.252, and the host
addresses are 131 .108.2.1 and 131 .108.2.2. You cannot assign addresses of 131 .108.2.0 and
131 .108.2 .3 as...
... sends updates every 30 seconds.
3:
How does RIPV2 broadcast its updates?
A:
RIPV2 uses multicast updates, which are sent every 30 seconds.
4:
Does RIP understand any network as the default ... network 150.150.0.0
network 10.0.0.0
neighbor 150.150.5 .31
Configuration of R2
router rip
network 150.150.0.0
The configuration for R3 is as follows:
router rip
netwo...
... 255.255.0.0
ip verify unicast reverse-path
no ip redirects
no ip directed-broadcast
ip route-cache distributed
no cdp enable
!
ip classless
ip tacacs source-interface Loopback0
ip bgp-community ...
RFC 1157. A Simple Network Management Protocol. 1990.
RFC 12 13. Management Information Base for Network Management of TCP /IP- based Internets:
MIB-II. 1991.
RFC...