... value for traffic shaping
frame−relay mincir 1000 ← Define a minimum CIR value for traffic shaping
!
line con 0
line aux 0
line vty 0 4
login
!
end
Monitoring and Testing the Configuration
Let's ... classless
!
!
line con 0
line aux 0
line vty 0 4
login
!
end
Monitoring and Testing the Configuration
Let's begin by connecting to the router FrameSwitch and verifying that it is work...
... as a subinterface type point−to−point. A subinterface is a logical way of
defining an interface. The same physical interface can be split into multiple logical interfaces; this was
originally created ... the
backbone, a virtual link must be configured. Virtual links will be discussed later in the chapter.
All areas inject routing information into the backbone area (area 0), and the backbo...
... routing information.
Lab #44: Passive Interface Configuration
Equipment Needed
The following equipment is needed to perform this lab exercise:
Two Cisco routers with one serial port•
One Cisco ... Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Default networks flagged in outgoing updates
Default networks...
... exercise:
One Cisco router with one serial interface•
One Cisco router with an Ethernet interface•
One Cisco router with two serial interfaces•
One Cisco router with one Ethernet and two serial interfaces• ... following equipment is needed to perform this lab exercise:
One Cisco router with one serial interface•
One Cisco router with one Ethernet interface•...
... involves creating the tunnel
interface on both routers and defining the tunnel endpoints. For this lab, the serial interfaces of both routers
are the endpoints of the tunnel. The following commands ... engine connection active. The
following is the output from the command. Notice there are two IPSec SAs: one for incoming traffic (2000)
and one for outgoing traffic (2001). At this point,...
... 500− 599 599 .1 ← Define a cable range for this interface
and an address of 599 .1
appletalk zone sales ← Define the primary AppleTalk zone to be sales
appletalk zone service ← Define the secondary ... 600−600
accounting 400− 499
service 400− 499 500− 599
sales 500− 599
Total of 4 zones
The show appletalk interface s 0/0 command reveals that the serial interface on RouterC is not runni...