...
with the basic concepts of programming. A background in C is not
necessary, but some experience with a programming language is required.
I have been teaching C programming for microcontrollers ... text on
microcontrollers. Therefore, the chapters that cover specific microcontrollers
are to the point. The references found in each chapter contain texts and
data books that...
... the use of the mains distribution
EMC for Product Designers 43
for immunity and the generic standard for emissions. All these standards must be
satisfied before compliance with the Directive ... superseded standard ceases to give presumption of conformity for
those products that fall within the scope of the new standard. Presumption of
conformity for products that still fall...
... shown as –16 dB
Introduction to Fiber Optics
42
Figure 5.3
What is the output
power in watts?
ch05 3/5/01 11:52 Page 42
Introduction to Fiber Optics
24
Figure 4.4
A typical size of
fiber
Figure ... the optic fibers. Optic fiber is therefore used in a fiber optic
system.
᭟
᭟ fiber is a friendly abbreviation for either, so we could say that fiber is
used in a fiber...
... quick-release
mechanisms for remotely controlled manipulators.
Sclater Chapter 12 5 /3/ 01 1 :24 PM Page 410
422
CLAMPING DEVICES FOR ACCURATELY ALIGNING
ADJUSTABLE PARTS
Methods for clamping parts that must be readily ... part is drawn against the machined edge of
the stationary part. This method is effective, but the
removal of the clamped part can be difficult if it is heavy or
u...
... drives a 10-to-1 gear reduction unit, torque is traded off for
speed. Torque is increased by a factor of 10 while speed is
reduced to about 25 ,000 rpm. A second 10-to-1 gear reduction
would increase ... within a
volume measuring 10
ì 7 .5 ì 8 in. ( 25 ì
19 ì 20 cm). It also offers the SLA 7000
system, which can form objects within a
volume of 20
ì 20 ì 23 . 62 in. (51 × 51 ×
60 cm)...
... Sclater. 2nd ed. 19 96.
ISBN 0-07-1 361 69-3
1. Mechanical movements. I. Chironis, Nicholas P. II. Mechanisms & mechanical
devices sourcebook. III. Title.
TJ181.S28 20 01
62 1 .8—dc21 20 010 3 029 7
Copyright ... 20 010 3 029 7
Copyright â 20 01, 19 96, 1991 by The McGraw- Hill Companies, Inc. All rights
reserved, Printed in the United States of America. Except as permi...
... third edition of Mechanisms & Mechanical Devices Sourcebook, a well illus-
trated reference book containing a wide range of information on both classical and mod-
ern mechanisms and mechanical ... mechanical devices. This edition retains a large core of the con-
tents from both the first and second editions, (published in 1991 and 1996,
respectively), that has been supplemented...
... Chapter 1 5/3/ 01 9:53 AM Page 30
13
MECHANICAL COMPONENTS
FORM SPECIALIZED MOTION
CONTROL SYSTEMS
Many different kinds of mechanical components are listed in
manufacturers’ catalogs for speeding ... speed is desired and 12 0-VAC power is avail-
able, a linear actuator with a 90-VDC motor can be equipped
with a solid-state rectifier/speed controller. Closed-loop feed-
back provide...