0
  1. Trang chủ >
  2. Kỹ Thuật - Công Nghệ >
  3. Kĩ thuật Viễn thông >

Safety at Work 6 E Part 1 ppt

Safety at Work 6 E Part 1 ppt

Safety at Work 6 E Part 1 ppt

... 16 1 1. 8.5 Employer’s liability 16 2 1. 8 .6 Employer’s Liability (Defective Equipment) Act 1 969 16 5 1. 8.7 Health and Safety at Work etc. Act 19 74 16 5 1. 8.8 Defences to a civil liability claim 16 6 1. 8.9 ... matter 65 1 4 .1. 3 Properties of chemicals 65 34 .1. 4 Physical properties 65 74 .1. 5 Energy and work 66 34 .1 .6 Mechanics 66 44 .1. 7 Strength of materials 66 54 .1. 8 Modes of failure 66 74 .1. 9 Testing 66 84 .1. 10 ... Orders 10 17Appendix 6 List of Cases 10 25Index 10 31 xii Contents Part 4 Workplace safety 64 94 .1 Science in engineering safety J. R. Ridley 65 1 4 .1. 1 Introduction 65 1 4 .1. 2 Structure of matter...
  • 60
  • 243
  • 0
Safety at Work 6 E Part 3 pptx

Safety at Work 6 E Part 3 pptx

... recognised in the workplace the right to appoint safety representatives. Those safety representatives were given certain func-tions and employers were required to give to the representatives, ... theemployee performed, or proposed to perform, the functions ofa representative or a member of a safety committee,(c) being an employee at a workplace where:(i) there was no such representative ... anything likely tobe taken as a statement covering the matters referred to above would befalse if deemed to be a false statement of the relevant matter [s .14 (2)a and(4)].The mental elementIn...
  • 60
  • 223
  • 0
Safety at Work 6 E Part 10 pptx

Safety at Work 6 E Part 10 pptx

... Non- 560 Safety at Work silencer normally has the better performance at higher frequencies,whereas the reactive type of silencer is more effective for controlling lowfrequencies.The performance ... above theworker may need to be protected from the environment by the use ofpersonal protective equipment. Where appropriate, the PPE Regulationsrequire the provision of suitable PPE except where ... hisemployees who are likely to receive an effective dose in excess of 6 mSvper year or an equivalent dose which exceeds three-tenths of any relevantdose limit’. Only employees aged 18 years or over...
  • 60
  • 288
  • 0
Safety at Work 6 E Part 6 ppt

Safety at Work 6 E Part 6 ppt

... Content. Make notes of everything that is said. Even parts of what theinterviewee says that seem irrelevant should be recorded. Theirrelevance should be judged when all the information has beencollected, ... have opted for the quality management system to integrateenvironment and health and safety into one comprehensive managementprocess.Figure 2 .6. 2 interrelates the elements of these management standardswith ... appropriateintervals and adequately documented. This is, in effect, a check on theoperation of the risk assessment element of the Safety ManagementSystem and, where weaknesses are identified, suitable...
  • 60
  • 265
  • 0
Safety at Work 6 E Part 2 pps

Safety at Work 6 E Part 2 pps

... tobe implemented in member states by 1 January 19 93, the date when theEuropean free market became established. In the UK the directivesconcerned with work equipment have been transposed into ... EN 8 36, Gardenequipment – Powered lawn mowers – Safety. These standards are prepared by working parties whose members arerepresentatives of the participating Member States – including membersof ... andorders.These regulations have the objective of detailing legislative require-ments in the specific area at which they are aimed although there hasbeen a trend – reflecting the requirements...
  • 60
  • 267
  • 0
Safety at Work 6 E Part 4 pot

Safety at Work 6 E Part 4 pot

... isowed wherever the employee may be in the course of his employment, onor off the employer’s premises. It is a duty which the employer owespersonally to the employee and the employer remains responsible ... etc.The consequences of poor maintenance of these systems are the releaseinto the atmosphere of contaminated aerosol vapours that affect not onlythe relatively healthy employees but also neighbours ... be harmed, and howStep 3: Evaluate the risks and decide whether existing precautions areadequate or more should be doneStep 4: Record the findingsStep 5: Review the assessment and revise...
  • 60
  • 230
  • 0
Safety at Work 6 E Part 5 doc

Safety at Work 6 E Part 5 doc

... ConclusionAttitudes are the cornerstones of health and safety. The risk assessment isa major technique but however excellent the techniques employed, andhowever competent the people using them, the safety ... recommendations resulting from the application ofsystem safety analysis techniques can be effectively reviewed andimplemented.System safety analyses employ the three basic elements of identifica-tion, ... get them to achieve the work required. Specific targets for work were set and additional money paid if these targets wereexceeded. Conversely a failure to meet the standard targets wouldresult...
  • 60
  • 245
  • 0
Safety at Work 6 E Part 7 docx

Safety at Work 6 E Part 7 docx

... hold them liable. At an individual level hazard detection is limited by what isforeseeable or foreseen. However, if people cannot foresee exactly what 368 Safety at Work needed. The latter point ... reinforce or destroy their effect. The tone ofvoice can indicate boredom, the stance friendliness, hand movementsnervousness. The very different effect of messages over the telephoneFigure 2.7 .10 ... or developingtechnologies such as nuclear power. A main focus has been the question 366 Safety at Work 3 When people observe others’ behaviour they grossly underestimate theeffect that the situation...
  • 60
  • 211
  • 0
Safety at Work 6 E Part 8 potx

Safety at Work 6 E Part 8 potx

... department2. All work procedureswill be reviewed everythree years Work procedures to bereviewed by theworkplace representative3. Safety committees at appropriate organisationallevels will meet bi-monthly ... senior safety committeeORGANISING 1. Each job will havespecified safety responsibilities which arereviewed every 3 yearsJob responsibilities to bereviewed/checked by the safety department2. ... modification 411 Figure 2.8 .15 Example of behaviour shaping associated with a safety managementsystemHSG65 ELEMENT SYSTEMREQUIREMENTMEASUREPOLICY 1. The board to reviewand reissue the policyevery...
  • 60
  • 259
  • 0
Safety at Work 6 E Part 11 docx

Safety at Work 6 E Part 11 docx

... wheremeasurements are required to be taken are listed in para. 61 of the ACOP.3 .6. 4 .1 Extract ventilationIn the design of extract ventilation it is important to create, at the point ofrelease ... relevant requirements are summarisedbelow.3.8 .10 .1 The Workplace (Health, Safety and Welfare) Regulations 19 92᭹ adequate lighting (reg. 8)᭹ adequate space (reg. 10 )᭹ suitable workstations, ... andto remove waste matter created during the chemical reaction when thephosphates stored in the muscles degenerate to create energy.3.9.2.4 Spinal columnIn the process of evolution, the bony...
  • 60
  • 201
  • 0

Xem thêm

Từ khóa: báo cáo thực tập tìm hiểu về quy trình công nghệ chế biến thủy sản lạnh đông của công ty cổ phần thủy sản đà nẵng part 1 pptnguyên lý cắt mài part 1 pptxbài giảng phương pháp thí nghiệm trong chăn nuôi và thú y tập 2 part 1 pptxsổ tay thủy văn cầu đường tính toán thuỷ văn trong trường hợp đặc biệt part 1 pptvõ cổ truyền bình định part 1 pptđịa lý phong thủy tâp 10 part 1 pptxđại cương về mô và phôi phát triển của cá xương part 1 pptbài giảng nguyên lý cắt gọt gỗ nguyên lý và công cụ khoan gỗ part 1 pptxbài giảng nguyên lý cắt gọt gỗ nguyên lý và công cụ khoan gỗ part 1 pptgiáo trình hán ngữ tập 1 quyển thượng part 1 pptkết cấu bê tông cốt thép sàn phẳng part 1 pptxthe main principles of health and safety at work actthe main principles of health and safety at work act 1974the health and safety at work etc act 19744 health and safety at work act 1974Báo cáo thực tập tại nhà thuốc tại Thành phố Hồ Chí Minh năm 2018Nghiên cứu sự biến đổi một số cytokin ở bệnh nhân xơ cứng bì hệ thốngNghiên cứu tổ chức pha chế, đánh giá chất lượng thuốc tiêm truyền trong điều kiện dã ngoạiNghiên cứu tổ hợp chất chỉ điểm sinh học vWF, VCAM 1, MCP 1, d dimer trong chẩn đoán và tiên lượng nhồi máu não cấpMột số giải pháp nâng cao chất lượng streaming thích ứng video trên nền giao thức HTTPđề thi thử THPTQG 2019 toán THPT chuyên thái bình lần 2 có lời giảiGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitĐỒ ÁN NGHIÊN CỨU CÔNG NGHỆ KẾT NỐI VÔ TUYẾN CỰ LY XA, CÔNG SUẤT THẤP LPWANPhát triển mạng lưới kinh doanh nước sạch tại công ty TNHH một thành viên kinh doanh nước sạch quảng ninhNghiên cứu tổng hợp các oxit hỗn hợp kích thƣớc nanomet ce 0 75 zr0 25o2 , ce 0 5 zr0 5o2 và khảo sát hoạt tính quang xúc tác của chúngNghiên cứu khả năng đo năng lượng điện bằng hệ thu thập dữ liệu 16 kênh DEWE 5000Thơ nôm tứ tuyệt trào phúng hồ xuân hươngThiết kế và chế tạo mô hình biến tần (inverter) cho máy điều hòa không khíSở hữu ruộng đất và kinh tế nông nghiệp châu ôn (lạng sơn) nửa đầu thế kỷ XIXQuản lý nợ xấu tại Agribank chi nhánh huyện Phù Yên, tỉnh Sơn La (Luận văn thạc sĩ)Giáo án Sinh học 11 bài 15: Tiêu hóa ở động vậtGiáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtGiáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtTrách nhiệm của người sử dụng lao động đối với lao động nữ theo pháp luật lao động Việt Nam từ thực tiễn các khu công nghiệp tại thành phố Hồ Chí Minh (Luận văn thạc sĩ)