... Corrosion-Resistant Materials Handbook, 4th ed., Noyes, 1985
• DECHEMA Corrosion Handbook: Corrosive Agents and Their Interaction with Materials,
D.
Behrens (Vol 1-9 ) and G. Kreysa and R. Eckermann ... Goldhoff and D.A. Woodford, The Evaluation of Creep Damage in a Cr-Mo-V Steel,
STP 515,
ASTM, 1972, p 8 9-1 06
86.
R. Viswanathan and S.M. Gehl, Life-Assessment Techn...
... the design
process and these design tools.
Thus, Volume 20 of ASM Handbook is aimed at two important groups: materials professionals and design professionals.
As a handbook on materials selection ... 9).
If a part is necessary and a standard part can be used, then it is usually more economical to specify the standard part
instead of designing and manufacturi...
... in CAE-based design optimization. Computer-aided-engineering-
based design optimization does in fact turn CAE analysis tools into CAE design tools by replacing traditional trial -and-
error design ... block-structured grids.
On the other hand, unstructured-mesh CFD codes generally demand higher computational resources. Additional memory
is needed to store cell-to-cell and vertex-...
... Selection, Granta Design, 1996
3. CMS Software and Handbooks, Granta Design, 1995
4. American Institute of Physics Handbook, 3rd ed., McGraw-Hill, 1972
5. Metals Handbook, 9th ed., and ASM Handbook, ... which follows in this Section of the Handbook) for
materials selection in the minimum-weight design of ties, columns, beams, and plates, and for yield-limited design of...
... understanding of
structure/property relationships resulted, and the design of
materials evolves in partnership with design
with materials.
Structure and Structure Analysis. Materials science and ... J.J. Lewandowski, C.T. Liu, P.L. Martin, D.B.
Miracle, and M.V. Nathal, Ed., The Metallurgical Society, 1993, p 1-1 5
9. M.F. Ashby, Materials Selection and Design,...
...
mold-cooling program allows designers and molders to evaluate materials and process parameters in a rapid, convenient,
and cost-efficient manner. Plastic parts are usually thin, and thus a one-dimensional, ... 140 3-1 409
44.
J.H. Selverian and S. Kang, Ceramic-to-Metal Joints: Part II-Performance and Strength Prediction,
Am.
Ceram. Soc. Bull., Vol 71 (No. 10) , 1992,...
... the initial design of the casting is the
design of gates and risers. This consists of proper orientation of the part and the determination of the parting plane and the
size, number, and location ... the time it takes an assembler to
pick up and orient each part before the part is assembled. Jigs and trays, and so forth, that reduce this pick -and- place
orientation...