... along with functionality as a part of parametric design (Ref 3).
Most parametric design methods can be applied to special-purpose parts and to standard parts and standard assemblies. A
number ... 9).
If a part is necessary and a standard part can be used, then it is usually more economical to specify the standard part
instead of designing and manufacturing a special-pu...
... in CAE-based design optimization. Computer-aided-engineering-
based design optimization does in fact turn CAE analysis tools into CAE design tools by replacing traditional trial -and-
error design ... Paper 93 271 2, SAE, 1993
77 . P. Moin and J. Kim, Tackling Turbulence with Supercomputers, Scientific American,
Vol 276 (No. 1), Jan
19 97, p 6 2-6 8
78 . B. Galperin and S.A...
... Selection, Granta Design, 1996
3. CMS Software and Handbooks, Granta Design, 1995
4. American Institute of Physics Handbook, 3rd ed., McGraw-Hill, 1 972
5. Metals Handbook, 9th ed., and ASM Handbook, ... which follows in this Section of the Handbook) for
materials selection in the minimum-weight design of ties, columns, beams, and plates, and for yield-limited design of...
... corresponding fatigue design
parameter.
1919, p 97 4-9 76
16.
Boston Molasses-Tank Trial: The Case for the Defense, Eng. News-Rec.,
Vol 85 (No. 15), 7 Oct 1 920, p
69 1-6 92
17.
Experts Deny ... a 90-Foot Molasses Tank, Eng. News-Rec.,
Vol 82 (No. 20) , 15 May
1919, p 97 4-9 76
16.
Boston Molasses-Tank Trial: The Case for the Defense, Eng. News-Rec., Vol 85 (No...
... 1948, p 75
15.
C. Herring, J. Appl. Phys., Vol 21, 1950, p 43 7- 4 45
16.
R.L. Coble, J. Appl. Phys., Vol 34, 1963, p 1 67 9-1 684
17.
M.F. Ashby, Acta Metall., Vol 20, 1 572 , p 88 7- 8 97
18.
... 13 5-1 47
31.
R. Viswanathan, The Effect of Stress and Temperature on the Creep and Rupture Behavior of a 1.25 pct.
Chromium-0.5 pct. Molybdenum Steel, Metall. Trans...