... life and wear mechanism of uncoated and coated milling inserts. Wear, 225(1), 273– 284. 25. Kopac, J. (1998). Influence of cutting material and coating on tool quality and tool life. J. Mater. ... manufacturing engineers handbook: A reference book for manufacturing engineers, managers, and technicians, vol. 1. Deaborn, Michigan, USA: Society of Manufacturing Engineers. 2. Donaldson, C., LeCain, ... studied; cutting speed (m/min), axial depth of cut (mm) and feed rate (mm/tooth). Results indicate failure of the cutting edge is dependent on the parameters mentioned above. In dry machining, wear...