... that are joined by the simple glued scarf splice shown. Determine the normal and shearing stresses in the glued splice. 1.30 Two wooden members of uniform cross section are joined by the simple ... mode of application of the loads at the ends of the rod. This will be discussed further in Chap. 2. In practice, it will be assumed that the distribution of normal stresses in an axially loaded ... tested to failure and an ultimate load of 29 kips was recorded. Using a factor of safety of 3.0, determine the required diameter (a) of rod AC, (b) of rod AD.140 mm140 mmPFig. P1.35 and...