...
supporting frame and balance is bridged by a spacer. The balance assembly can rotate over
± 18 0° in increments of ± 0 .1 .
New Trends and Developments in Automotive Industry
8
and confidence ... and confidence thresholds.
Design parameter
11
dp
12
dp
21
dp
22
dp
31
dp
32
dp
41
dp
Numbers of rules generated 14 1 97 14 4 84 12 3 44 11 0
Num...
...
regulations
Training
structures
Training and
learning processes
Professional
training
Fig. 1. The professional training success factors.
The professional training can be either internal to ... Agdal, Rabat,
3
Department of Innovation Engineering and Center for Business Innovation,
University of Salento, Lecce,
1, 3
Italy
2
Morocco
1. Introduction
The automotive industry...
... 10
Chapter 11
Part 3
Chapter 12
Chapter 13
Part 4
Chapter 14
Chapter 15
Part 5
Chapter 16
Data Mining and Intelligent Agents for Supporting Mass Customization in the Automotive Industry
11 ... obtained from orders@intechweb.org
New Trends and Developments in Automotive Industry, Edited by Marcello Chiaberge
p. cm.
ISBN 978-953-307-999-8
New Tren...
...
Vol. 10 , pp. 18 1 -18 3.
New Trends and Developments in Automotive Industry
36
(a) Layout of multitooth tools used in the car
industry
(b) Different inserts in the multitooth tool
Fig. 1. ... Developments in Automotive Industry
40
10
10 0
10 00
10 000
10 0000
234567
Umbral
MTFA
R=2
R=6
10
10 0
10 00
10 000
10 0000
234567
Umbral
MTFA
1...
... has made the films to shrink. For the
(a)
(b)
(c)
(d)
New Trends and Developments in Automotive Industry
276
Carbonyl-ATR
0.5
0.7
0.9
1. 1
1. 3
1. 5
1. 7
1. 9
0 10 0 200 300 400 500 600
Ex
p
osure ... defined following Systems engineering standard (ISO 15 288),
• the job positions were both defined following Systems engineering and automotive
professional...
... engineering – Interior trim, Textiles in automotive
engineering, In: Textiles in automotive engineering, The Textile Institute, pp 19 4- 211 ,
Woodhead Publishing Limited, ISBN 1 85573 493 1, ... pressure and the temperature.
Fig. 14 . The laminating process
New Trends and Developments in Automotive Industry
326
Fig. 4. The flame lamination process...
...
25 min
Inspection
5 min
Part assembl
y
.5 min
Sandin
10 min
Mixin
g
Bondo
4 min
Bondo application
10 min
Sandin
g
with sandpaper #36
10 min
Sandin
g
with sandpaper ... cleaning
3 min
Sra
y
in
g
clearcoat
10 min
Uncover
5 min
Dr
y
in
g
5 min
Polish
30 min
Final inspection
3 min
New Trends and Developments in Automotive...