... working on a command guide in the same fashion as his previous books
for Cisco Press: the Cisco Networking Academy Program
CCNA Command Quick Reference and
the CCNA Portable Command Guide. The ...
multiplex (MUX)-type
VCs
NOTE: The global
default encapsulation
option is aal5snap.
CCNP ISCW
Portable Command Guide
Scott Empson
Hans Roth
800 East 96th Street
Indianapol...
... chapter provides information and commands concerning the following topics:
• The ip classless command
• RIP routing: mandatory commands
• RIP routing: optional commands
• Troubleshooting RIP issues
• ... provides information and commands concerning the following topics:
• Configuring OSPF: Mandatory commands
• Using wildcard masks with OSPF areas
• Configuring OSPF: Optional commands
— Loopba...
... in updating my CCNA Portable Command Guide for release
around the time of the announcement of the new exam. I was already working on the various
command guides for the new CCNP certification exams, ... and This Guide
The first book that I ever published for Cisco Press was a command guide that was specially
designed to follow the Cisco Networking Academy Program curriculum. Th...
... chapter provides information and commands concerning the following topics:
• The ip classless command
• RIP routing: mandatory commands
• RIP routing: optional commands
• Troubleshooting RIP issues
• ... provides information and commands concerning the following topics:
• Configuring OSPF: Mandatory commands
• Using wildcard masks with OSPF areas
• Configuring OSPF: Optional commands
— Loopba...
... entering the no
switchport interface configuration command
• SVI—A VLAN interface created by using the interface vlan vlan_id global
configuration command and, by default, a Layer 3 interface
• EtherChannel ... for SLA 10 to start
now and continue indefinitely.
NOTE: The ip sla schedule command is the
same as the SLA schedule command in Chapter
5, “Implementing a Highly Available Netw...
... exec command or press the Enter key to start the session.
The modem InOut command enables both incoming and outgoing calls. The alternative to this
command is the default no modem inout command, ... AT commands documented in
Table 4-4 are considered “standard” and should work on most modems.
A CCNP or CCDP should be familiar with these commands. For many modems on the market
today,...
... ports. The 5000 series
uses the slot/port command. The 1900 series uses the type slot/port
command.
5000 Series Set-Based Switch
You can use the show command to view port statistics on a 5000 ... Switch
These switches take the type slot/port command with either the
interface command or the show command. The interface command
enables you to set interface-specific configurations....
...
CCNP: Routing Study Guide
covers all the exam
objectives.
Exam 640-504: Switching
This exam tests your knowledge of the 1900
and 5000 series of Catalyst switches. This book,
CCNP:
... The 5000 series
uses the slot/port command. The 1900 series of switches uses the type
slot/port command.
5000 Series Set-Based Switch
You can use the show command to view port statistics...