using the itemprop and itemscope attributes

Tài liệu Using the LOCAL_PREF and MED Attributes pdf

Ngày tải lên : 18/01/2014, 05:20

... configuration, issue the clear ip bgp * command on ISP1A Wait several seconds, and then use the show ip bgp command to view ISP1A’s BGP table Both paths should again be present in the table, but the best ... Configure BGP for normal operation Enter the appropriate BGP commands so that SanJose3 advertises its Ethernet network and the other routers advertise the 10.0.0.0 network: ISP1A(config)#router ... always-compare-med Issue the clear ip bgp * command on SanJose3, wait several seconds, and then check SanJose3’s BGP table with the command show ip bgp SanJose3 should have two paths to the 10.0.0.0 network,...

3
365
0

Tài liệu Using the Scandisk and Defrag Utilities docx

Ngày tải lên : 24/01/2014, 19:20

... Note: Make sure that the screensaver and any other programs that automatically start are temporarily disabled or they can interrupt the defragmenting process Troubleshooting If Scandisk reports a ... resolve the problem There is an option to convert recovered data to a text file However, this will clutter the drive with many text files of garbled information Select the option to discard the information ... information Select the option to discard the information and continue Reflection List any other utilities that come with Windows that can help in the preventative maintenance of a system: ...

2
307
0

Báo cáo y học: "Assessing post-traumatic stress disorder in South African adolescents: using the child and adolescent trauma survey (CATS) as a screening tool" docx

Ngày tải lên : 08/08/2014, 21:20

... 'current' Furthermore, only the PTSD and depression sections of the K-SADS-PL were administered The screen interview and diagnostic supplement format is unique to the K-SADS-PL and greatly facilitates ... children and adolescents Procedures Permission to carry out the study was obtained from the Western Cape Department of Education and the Ethics Committees of the Universities of Stellenbosch and Cape ... appropriate for the sample First, using the K-SADS as the "gold" standard for a diagnosis of PTSD (a measure that identifies those individuals who have or not have a disorder), the sensitivity and specificity...

10
667
0

báo cáo khoa học: " Improving quality of care through routine, successful implementation of evidence-based practice at the bedside: an organizational case study protocol using the Pettigrew and Whipp model of strategic change" potx

Ngày tải lên : 11/08/2014, 05:22

... organization and its related change This reinforces the fluid nature of the dimensions, the signs, and their inter-relationship – the pattern of which may vary from organization to organization and within ... utilization among the management, and organizational support [37]." Ferlie and Shortell [38], after assessing initiatives on the quality of health care in the United Kingdom and the United States ... purposively sampled (e.g., the CNO, EBP project groups and their leads, and the procedure committee) Both nursing and interdisciplinary groups will be recruited In terms of the interviews, approximately...

13
424
0

AN0717 building a 10 bit bridge sensing circuit using the PIC16C6XX and MCP601 operational amplifier

Ngày tải lên : 11/01/2016, 11:33

... side of the Wheatstone bridge, the MCU switches the multiplexer (A2) to the leg of the other side of the sensor With the voltage of the other leg of the sensor connected to the input of the amplifier, ... a reduction in the dynamic range of the system The combination of the sensor error and the capacitor error increases the requirements on the input range to the modulator configuration Hardware ... care is not taken in limiting the charge and discharge range of the device If the R/C time constant of the circuit is greater than the inverse of the sample frequency, the non-linearity of this time...

8
278
0

AN0780 15 kilogram scale using the TC500A and the TC520

Ngày tải lên : 11/01/2016, 11:39

... DEVELOPING THE SCALE APPLICATION USING THE TC500A AND THE TC520 Input Stage The first consideration for a low signal level source is the amount of gain required for the input amplifier The TC500A ... expression for the pressure on the strain gauge (PSG), the strain gage constant (K) and the gain of the amplifier (G) The actual differential reference voltage is determined only by the ratio of ... referenced to ground Rather than using a precision reference for the TC500A and a precision supply for the strain gauge, combining eq3/a and eq3/b into eq4 produces an equation for the system: TDEINT...

10
251
0

AN0212 smart sensor CAN node using the MCP2515 and PIC16F876

Ngày tải lên : 11/01/2016, 11:45

... Figure The concept is to enable the MCP2515 CAN controller, the PIC16F876 microcontroller and the MCP3201 ADC to efficiently communicate among each other, utilizing the SPI The MCP2515 handles the ... When the value of the variable is a logic ‘0’, the PIC® device reads the pressure sensor, and when the value of the variable is a logic ‘1’, the PIC® device reads the reference A/D The microcontroller ... device on the node (such as a microcontroller) to the MCP2515 are through the SPI bus The PIC® device used on the Node Board fully supports the SPI in the Master mode Command strings are sent and received...

84
642
0

AN0215 a simple CAN node using the MCP2515 and PIC12C672

Ngày tải lên : 11/01/2016, 11:45

... loads the ADRES register value into the MCP2515 Transmit Buffer and Data Byte 0, and sends the RTS command If the match occurred on Filter 3, then the PIC MCU reads the TXRTSCTRL register for the ... the source of the interrupt, Timer0 or external INT pin and then branches to the appropriate code to process the interrupt Figure and Figure show the program flow for the Timer0 and CAN message ... complete, the ADRES value is loaded into the MCP2515 Transmit Buffer 0, Data Byte 0, and an RTS command is issued for Buffer The TMR0 register is then reloaded and the interrupt flag is cleared The...

24
450
0

AN0510 smart sensor CAN node using the MCP2515 and PIC16F876

Ngày tải lên : 11/01/2016, 11:47

... constants and the time the user gets using an MHz input clock Delay constants and the time that the user gets at 20 MHz and MHz input clock speeds are given in the source code listing of the full-duplex ... such that the user gets control for approximately half the time of the bit rate and the rest of the time is used up by the Operating System (and software delays) Please refer to Table for the delay ... Whereas, the transmission is totally under user control, the Reception is under the control of the Operating System As long as the user does not set the X_flag, no transmission occurs On the other hand...

19
274
0

AN1016 detecting small capacitive sensors using the MCP6291 and PIC16F690 devices

Ngày tải lên : 11/01/2016, 16:36

... worth the effort The dominant error sources are covered in this section They will be covered in the same sequence they propagate through the circuit and algorithm Their impact on RH accuracy, and ... contribute to the current imbalance The common mode voltage setting resistors (RCM1 and RCM2) and the op amp (U1) dominate the VCM errors If RCM1 is 1% low and RCM2 is 1% high, then the relative ... (INTRVL) to the correct row of the table The bottom bits of CSN (CSN – ACSN, interpreted as integers between and 15) are the input to the linear interpolation formula using the coefficients for the current...

14
223
0

Natural botanical products have a long history in the world and are featured in using a complex

Ngày tải lên : 03/11/2012, 09:54

... cytokine release including TNF-α in these animals and inhibit tumor growth However, further study is needed to determine how they are induced and the mechanisms they inhibit cancer cell growth in ... treatment groups They were fed intragastrically (i.g.) daily for 14 and 28 days Tumor areas were measured every days using a caliper, and the tumor area was calculated according to the formula: tumor ... investigate the effect on tumor growth To further examine the anti-tumor mechanism, the three important biological parameters in tumorigenesis including cell proliferation and apoptosis [7], and also...

9
712
0

Removal of arsenic from synthetic groundwater by adsorption using the combination of laterite and ironmodified activated carbon

Ngày tải lên : 05/09/2013, 09:38

... and atmospheric condition The samples were taken then acidified and analyzed for residual arsenic concentration A mixture of 70% As[III] and 30% As[V] was used in all of the experiments and the ... in the values of the regression coefficient r2 Therefore, adsorption process of arsenic onto LA and AC-Fe may be described by Langmuir isotherm and the adsorption capacities were 0.48mg/g and ... for LA and AC-Fe are 0.48mg/g and 1.18mg/g, respectively) However, it is also possible to realize that the longer the portion of AC-Fe, the higher the adsorbent cost Therefore, optimizing the AC-Fe...

12
529
0

Tài liệu UML Applied - Object Oriented Analysis and Design using the UML doc

Ngày tải lên : 10/12/2013, 14:16

... wouldn’t be the end of the world if the receipt wasn’t dispensed Apply the rule to the other Use Cases, and you’ll find that really, none of them describe the goal of the user The goal of the user ... part of the consortium, including Hewlett-Packard, Microsoft and Oracle The UML was adopted by the OMG2 in 1997, and since then the OMG have owned and maintained the language Therefore, the UML ... Analysis and Design using the UML Chapter The Elaboration Phase In the Elaboration Phase, we are concerned with exploring the problem in detail, understanding the customer’s requirements and their...

123
742
2

systems with hysteresis. analysis_ identification and control using the bouc–wen model

Ngày tải lên : 12/12/2013, 22:41

... piston The product of the piston velocity and the post-yield plastic damping coefficient The product of the piston position and the factor that accounts for the accumulator stiffness and the MR ... mi is the mass of the ith floor, ¨ B is the ground acceleration and qi is the ith restoring force, including viscous damping The quantities ui are the relative displacement of the ith and the i ... easily that the stability proof of the feedback connection is exactly the same as in Theorem 13 In the following, the simplified version of Theorem 13 given in Theorem 14 is used Then the conditions...

223
525
1

Tất cả

Tài liệu Kalman Filtering and Neural Networks - Chapter 6: LEARNING NONLINEAR DYNAMICAL SYSTEMS USING THE EXPECTATION– MAXIMIZATION ALGORITHM doc

Ngày tải lên : 23/12/2013, 07:16

... the observations=inputs and the parameter values The M-step involves system identiﬁcation using the state estimates from the smoother Therefore, at the heart of the EM learning procedure is the ... outputs, and the conditional distributions over the hidden states For the model we have described, the parameters deﬁne the nonlinearities f and g, and the noise covariances Q and R (as well as the ... by picking randomly the values of the nodes that have no parents It then picks randomly the values of their children Stationarity means here that neither f nor the covariance of the noise process...

46
490
0

Tài liệu Using the Inter net and Other Networks pdf

Ngày tải lên : 17/01/2014, 16:20

... another of the thousands of IRC channels.) IRC ops, on the other January 2002 13:14 126 Chapter 6: Using the Internet and Other Networks hand, are technical people in charge of the servers themselves; ... Chapter 6: Using the Internet and Other Networks Here’s the syntax: talk user name@hostname If the other user is logged onto the same computer as you, omit the @hostname After you run that command, ... happening on the server and the channel; the bottom part (a single line) is where you type commands and text In between the two parts is a status line with the time of day, your nick, and other information...

33
613
0

Tài liệu Add, Edit, and Delete Data Using the DataGrid Control doc

Ngày tải lên : 21/01/2014, 12:20

... see the final HTML for the DataGrid control The lines of code that you will need to add are the ones for OnUpdateCommand, OnCancelCommand, OnEditCommand, and OnDeleteCommand By entering these ... about the record; it had only been added to the data table and not sent back to the server You can see the data being updated back to the server for the add and edit in the next step One other ... to handle the exception that occurs when you try to write the value to the column When you're writing the cells into the columns of the data row, the Trim function is used Because of using the...

14
510
0

Tài liệu Filter and Sort Records Using the DataView Object pptx

Ngày tải lên : 21/01/2014, 12:20

... to the current column name chosen in cboSortColumns If the two are the same, then the column name is assigned to the Sort property with the DESC keyword added on If not, then the name of the ... from the ComboBox The current setting of the Sort property is compared to the column name that is chosen If the Name matches, then the expression DESC is added to the value that is assigned to the ... Using the command buttons, a routine is called that creates a DataView object, sets the RowFilter property, and then assigns the data view to the DataSource property of...

7
350
0

LISTENING DIFFICULTIES PERCEIVED BY TEACHERS AND STUDENTS IN USING THE NEW ENGLISH TEXTBOOK FOR GRADE 10 AT QUE VO II UPPER SECONDARY SCHOOL IN BAC NINH

Ngày tải lên : 05/02/2014, 22:02

... forget others By and large, they can not fulfill the tasks if they focus on linguistic items rather than the message or the information The top-down view of listening is the use of inside the head ... person These facts result in ineffective and theoretical outcome which is backward and no longer meet the demand of the development, the integration and globalization of our country in the modern ... whatever they have produced in the previous stage, and other meaningful activities There are two common forms that post-listening tasks can take They are reactions to the content of the text, and...

53
1.2K
7